Sun Joe 24V-HT16-LTE Manual

Sun Joe Hækkeklipper 24V-HT16-LTE

Læs gratis den danske manual til Sun Joe 24V-HT16-LTE (16 sider) i kategorien Hækkeklipper. Denne vejledning er vurderet som hjælpsom af 52 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 26.5 anmeldelser. Har du et spørgsmål om Sun Joe 24V-HT16-LTE, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/16
A Division of Snow Joe, LLC
OPERATOR’S MANUAL
Model 24V-HT16-LTE Form No. SJ-24V-HT16-LTE-880E-M
CORDLESS HEDGE TRIMMER
24V MAX* | 2.0 Ah |16-INCH
R
*DISCLAIMER: Initial no-load voltage, when fully charged,
peaks at 24V; nominal voltage under typical load is 21.6V.
SAVE THESE INSTRUCTIONS
Original instructions.
© 2023 Snow Joe, LLC. All rights reserved.
IMPORTANT!
Safety Instructions
All Operators Must Read These
Instructions Before Use
Always follow these safety guidelines. Failure to do so may result
in serious bodily injury or death.
General Power Tool Safety Warnings
m WARNING Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
mDANGER! This indicates a hazardous situation, which,
if not followed, will result in serious injury or death.
mWARNING! This indicates a hazardous situation, which, if
not followed, could result in serious injury or death.
mCAUTION! This indicates a hazardous situation, which, if
not followed, could result in minor or moderate injury.
Work Area Safety
1. Keep work area clean and well lit – Cluttered or dark areas
invite accidents.
2. Do not operate power tools in explosive atmospheres,
such as in the presence of flammable liquids, gases or
dust – Power tools create sparks which may ignite the dust
or fumes.
3. Keep children and bystanders away while operating a
power tool – Distractions can cause you to lose control.
Electrical Safety
1. Power tool plugs must match the outlet. Never modify
the plug in any way. Do not use any adapter plugs with
earthed (grounded) power tools. Unmodified plugs and
matching outlets will reduce risk of electric shock.
2. Avoid body contact with earthed or grounded surfaces,
such as pipes, radiators, ranges and refrigerators – There
is an increased risk of electric shock if your body is earthed
or grounded.
3. Do not expose power tools to rain or wet conditions –
Water entering a power tool will increase the risk of electric
shock.
4. Do not abuse the cord. Never use the cord for carrying,
pulling or unplugging the power tool. Keep cord away
from heat, oil, sharp edges or moving parts. Damaged or
entangled cords increase the risk of electric shock.
5. When operating a power tool outdoors, use an extension
cord suitable for outdoor use. Use of a cord suitable for
outdoor use reduces the risk of electric shock.
6. If operating a power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk of
electric shock.
Personal Safety
1. Stay alert, watch what you are doing and use common
sense when operating a power tool. Do not use a power
tool while you are tired or under the influence
of drugs, alcohol or medication – A moment of inattention
while operating power tools may result in serious personal
injury.
2. Use personal protective equipment. Always wear eye
protection – Protective equipment such as dust mask, non-
skid safety shoes, hard hat, or hearing protection used for
appropriate conditions will reduce personal injuries.
3. Prevent unintentional starting. Ensure the switch is in the
off-position before connecting to power source and/or
battery pack, picking up or carrying the tool. – Carrying
power tools with your finger on the switch or energizing
power tools that have the switch on invites accidents.
4. Remove any adjusting key or wrench before turning the
power tool on. A wrench or a key left attached to a rotating
part of the power tool may result in personal injury.
5. Do not overreach. Keep proper footing and balance at
all times – This enables better control of the power tool in
unexpected situations.
6. Dress properly. Do not wear loose clothing or jewelry.
Keep your hair, clothing and gloves away from moving
parts – Loose clothes, jewelry or long hair can be caught in
moving parts.

Produkt Specifikationer

Mærke: Sun Joe
Kategori: Hækkeklipper
Model: 24V-HT16-LTE

Har du brug for hjælp?

Hvis du har brug for hjælp til Sun Joe 24V-HT16-LTE stil et spørgsmål nedenfor, og andre brugere vil svare dig


Hækkeklipper Sun Joe Manualer

Sun Joe

Sun Joe 24V-HT16-LTE Manual

31 December 2025
Sun Joe

Sun Joe HJ15HTE Manual

31 December 2025
Sun Joe

Sun Joe HJ22HTE-MAX Manual

8 September 2024
Sun Joe

Sun Joe SJH901E Manual

25 August 2024
Sun Joe

Sun Joe SJH904E-RM Manual

14 August 2024
Sun Joe

Sun Joe 20VIONLT-PHT17-RM Manual

12 August 2024
Sun Joe

Sun Joe 24V-HT22-LTE Manual

9 August 2024
Sun Joe

Sun Joe 24V-PHT17-CT-RM Manual

5 August 2024
Sun Joe

Sun Joe HJ604C-GRY-RM Manual

2 August 2024
Sun Joe

Sun Joe SJH902E-RM Manual

31 Juli 2024

Hækkeklipper Manualer

Nyeste Hækkeklipper Manualer

Valex

Valex RSA108 Manual

8 December 2025
Graphite

Graphite Energy+ 58G955 Manual

7 December 2025
Scheppach

Scheppach BHS650 Manual

5 December 2025
Scheppach

Scheppach HTE550 Manual

4 December 2025
DeWalt

DeWalt DCMHT563 Manual

18 November 2025
Shindaiwa

Shindaiwa AH262S-HD Manual

7 Oktober 2025
Flo

Flo 79442 Manual

7 Oktober 2025
Flo

Flo 79448 Manual

7 Oktober 2025
Shindaiwa

Shindaiwa DH220 Manual

6 Oktober 2025
Shindaiwa

Shindaiwa DH185ST Manual

6 Oktober 2025