Important Safety Instructions
FCC Statement
The content in this manual is for information purposes only and is
subject to change without notice. While every effort is made to ensure
that this manual is accurate and complete at the time of printing,
no liability is assumed for any errors and omissions that may have
occurred. As we’re constantly making improvements to our products,
firmware, software and user manuals, we reserve the right to change
the information without prior notice. For the latest version of this user
manual, please visit: www.swann.com
When fitting the screws into the wall, make sure you are not inserting
them anywhere near electrical wires, including wires that may be
behind the wall. If you are unsure at all, please get a professional to
check first and install the screws for you.
This equipment has been tested and found to comply with the limits
for Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to
operate this equipment.
