Teledex Pearl S Manual

Teledex Telefon Pearl S

Læs gratis den danske manual til Teledex Pearl S (2 sider) i kategorien Telefon. Denne vejledning er vurderet som hjælpsom af 21 personer og har en gennemsnitlig bedømmelse på 4.1 stjerner ud af 11 anmeldelser. Har du et spørgsmål om Teledex Pearl S, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

PACKAGE CONTENTS

Check to be sure that you have all of the following components in

your package (see figure below) :

• Telephone base unit • Handset coil cord • User guide

• Handset • Line cord

INSTALLATION

1) Plug one end of the handset coiled cord into the handset. Plug

the other end of the cord into the handset jack located on the

left side of the phone base. (Refer to diagram on reverse.)

2) Place the handset in the handset cradle. Plug one end of the line

cord into the jack on the back of your phone.LINE

3) Plug the other end of the modular cord into the wall jack.

WALL MOUNTING

The Pearl S telephone can easily be attached to a wall mount plate.

1) Remove the wall mount clip (located on the front of the

telephone, above the speaker grill) by firmly pushing upward

(toward the hook switch.)

2) Rotate the clip 180 degrees, so that the side with the protruding

edge is towards the top of the telephone. This edge will help

hold the handset on the cradle.

3) Place the handset in the handset cradle.

4) Connect the line cord into the jack on the back of your LINE

phone. Route the line cord through channel on the bottom of

the telephone. Connect the other end of the line cord to the

jack on the wall mount plate.

5) Slip the phone onto the wall plate; slide the telephone down

so it is firmly in place.

USING THE DATA PORT

The data port is located on the right hand side of the telephone. Use

this jack to connect a computer or fax machine in parallel to the

same phone line to which the telephone is connected.

ADJUSTING THE RINGER VOLUME

Your Pearl S telephone has two ringer volume levels: “Low” and

“High.” To adjust the ringer volume, slide the ringer volume switch

(located on the backside of the telephone) to the desired level.

HANDSET VOLUME CONTROL

There are three (3) volume levels for the handset volume. To increase

or decrease the handset volume, slide the handset volume switch

(located on the right hand side of the telephone) to the desired setting.

SPEAKER VOLUME CONTROL

To increase or decrease the speakerphone volume, move the speaker

volume slider control (located on the right hand side of the telephone)

until speaker volume is at a satisfactory level.

PLACING AND ANSWERING CALLS

To make a call, pick up the handset or press the key. WhenSPEAKER

you hear the dial tone, dial the desired phone number. To answer an

incoming call, pick up the handset or press the key. To end aSPEAKER

call, place the handset back on the base, or press the SPEAKER key

again.

SWITCHING BETWEEN HANDSET AND SPEAKERPHONE

To switch from the handset to the speakerphone during a call, press

the SPEAKER key, and place the handset on the base. To switch from

the speakerphone to the handset, lift the handset; the speakerphone

will automatically turn off.

USING REDIAL

The redial function allows you to redial the last dialed number. Pick

up the handset, or press the key, and press the SPEAKER REDIAL key. The

number will be dialed automatically.

USING FLASH

Flash supports custom calling services, such as call waiting. For

example, if you have subscribed to call waiting, press FLASH to answer

an incoming call, without disconnecting the current call. Press FLASH

again to return to the first call.

USING HOLD

To place a call on hold, press the HOLD key. The HOLD LED flashes.

You may now hang up the handset without disconnecting the call.

To resume the call, press the HOLD key again, or press the SPEAKER key.

The call will once again be active.

USING MUTE

Pressing the key will silence the handset or speakerphone micro-MUTE

phone. You will be able to hear the other party, but they will not be

able to hear you. The MUTE LED will light. Press the MUTE key again to

resume your conversation.

PROGRAMMING GUEST SERVICE KEYS

Follow these steps to program a number into one of the three memory

locations, for one-touch access to guest services, or for accessing

special PBX/Centrex services or features. Each memory location can

store up to sixteen (16) digits.

1) Lift the handset, then press the STORE key (For key location,

refer to diagram on reverse.)

2) On the dial pad, enter the number you wish to store. Once

you have entered the number completely, press the memory

button corresponding to the desired location.

DIALING A STORED NUMBER

Pick up the handset or press the key, wait for a dial tone,SPEAKER

then press the desired memory (guest service) key. The telephone will

automatically dial the stored number.

MESSAGE WAITING

The message waiting indicator flashes to indicate that there is a

message waiting. Consult your system administrator or service

provider for instructions on how to access these messages.

CARE AND MAINTENANCE

Your Pearl S telephone has been designed to provide years of trouble

free service. To ensure its longevity, please follow these maintenance

instructions:

1) Keep the Pearl S away from heat, as high temperatures can shorten

the life of the electrical components, and distort or melt plastic

parts.

2) The telephone should be kept free of dust and moisture. If it

gets wet, wipe it dry immediately. Liquids may contain minerals

that can corrode electronic circuits.

3) Handle your telephone gently and carefully. Dropping it can

cause serious damage to internal circuitry or the plastic case,

which may result in malfunction.

4) Do not use any type of chemical or abrasive powder to clean the

outer casing. Use only mild detergents on a soft, damp cloth to

clean the telephone.

5) In case of trouble with the telephone, do not attempt to repair

the telephone yourself. Contact your distributor for assistance.

If the trouble is affecting the telephone lines, the phone company

or service provider may ask you to disconnect the telephone

until the problem is resolved.

PEARL S

Guestroom Speakerphone

Users Guide

PACKAGE CONTENTS

BASE UNIT HANDSET

COIL CORD

LINE CORD USER GUIDE

Produkt Specifikationer

Mærke:	Teledex
Kategori:	Telefon
Model:	Pearl S

Har du brug for hjælp?

Hvis du har brug for hjælp til Teledex Pearl S stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Telefon Teledex Manualer

Teledex A105 Manual

6 November 2025

Teledex SIP ND210L Manual

12 Januar 2025

Teledex A110 Manual

6 September 2024

Teledex SIP ND2105 Manual

18 August 2024

Teledex Pearl S Manual

18 August 2024

Teledex SIP LD4210S Manual

18 August 2024

Teledex SIP ND2105S Manual

18 August 2024

Teledex SIP ND2110 Manual

18 August 2024

Teledex SIP ND2110S Manual

18 August 2024

Teledex SIP LD4105S Manual

18 August 2024

Telefon Manualer

Nyeste Telefon Manualer

Kensington H3005 Manual

6 December 2025

HMD Barça 3210 Manual

4 December 2025

Panasonic KX-TS2350 Manual

29 November 2025

Huawei nova 14i Manual

23 November 2025

Soundcore Life P2 Manual

22 November 2025

Panasonic KX-TGE260 Manual

16 November 2025

Gigaset N530 IP PRO Manual

16 November 2025

Gigaset SL850H PRO Manual

12 November 2025

LG KG200 Manual

10 November 2025

Telycam SONO Manual

9 November 2025