Teledex SIP LD4110S Manual

Teledex Telefon SIP LD4110S

Læs gratis den danske manual til Teledex SIP LD4110S (10 sider) i kategorien Telefon. Denne vejledning er vurderet som hjælpsom af 36 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 18.5 anmeldelser. Har du et spørgsmål om Teledex SIP LD4110S, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/10
SIP LD4100/4200 Series User Guide
WHEN USING YOUR TELEPHONE EQUIPMENT, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE
RISK OF FIRE, ELECTRIC SHOCK AND INJURY TO PERSONS, INCLUDING
THE FOLLOWING:
1. READ AND UNDERSTAND ALL INSTRUCTIONS.
2. FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON
THE PRODUCT.
3. UNPLUG THE PRODUCT FROM THE WALL OUTLET BEFORE
CLEANING. DO NOT USE LIQUID CLEANER OR
AEROSOLCLEANERS. USE A DAMP CLOTH FOR CLEANING.
4. DO NOT USE THIS PRODUCT NEAR WATER; FOR EXAMPLE NEAR
A BATHTUB, WASH BOWL, KITCHEN SINK OR LAUNDRY TUB, IN
A WET BASEMENT, OR NEAR A SWIMMING POOL.
5. DO NOT PLACE THIS PRODUCT ON AN UNSTABLE CART, STAND
OR TABLE. THE PRODUCT MAY FALL, CAUSING SERIOUS DAMAGE
TO THE PRODUCT.
6. SLOTS AND OPENINGS IN THE CABINET AND THE BOTTOM ARE
PROVIDED FOR VENTILATION, TO PROTECT IT FROM
OVERHEATING. THESE OPENINGS MUST NOT BE BLOCKED OR
COVERED. THE OPENINGS SHOULD NEVER BE BLOCKED BY
PLACING THE PRODUCT ON A BED, SOFA, RUG OR ANY OTHER
SIMILAR SURFACE. THIS PRODUCT SHOULD NEVER BE PLACED
NEAR OR OVER A RADIATOR OR HEAT REGISTER. THIS
PRODUCT SHOULD NOT BE PLACED IN A BUILT-IN INSTALLATION
UNLESS PROPER VENTILATION IS PROVIDED.
7. NEVER PUSH OBJECTS OF ANY KIND INTO THIS PRODUCT
THROUGH CABINET SLOTS AS THEY MAY TOUCH DANGEROUS
VOLTAGE POINTS OR SHORT OUT PARTS THAT COULD RESULT IN
A RISK OF FIRE OR ELECTRIC SHOCK. NEVER SPILL LIQUID OF ANY
KIND ON THE PRODUCT.
8. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT DISASSEMBLE
THIS PRODUCT, BUT TAKE IT TO QUALIFIED SERVICE PERSONNEL
WHEN SOME SERVICE OR REPAIR WORK IS REQUIRED. OPENING
OR REMOVING COVERS MAY EXPOSE YOU TO DANGEROUS
VOLTAGES OR OTHER RISKS. INCORRECT REASSEMBLY CAN CAUSE
ELECTRIC SHOCK WHEN THE APPLIANCE IS SUBSEQUENTLY USED.
9. UNPLUG THIS PRODUCT FROM THE WALL OUTLET AND REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL UNDER THE
FOLLOWING CONDITIONS:
– WHEN THE POWER SUPPLY CORD OR PLUG IS DAMAGED
OR FRAYED.
– IF LIQUID HAS BEEN SPILLED INTO THE PRODUCT.
– IF THE PRODUCT HAS BEEN EXPOSED TO RAIN OR WATER.
– IF THE PRODUCT DOES NOT OPERATE NORMALLY BY
FOLLOWING THE OPERATING INSTRUCTIONS. ADJUST ONLY
THOSE CONTROLS THAT ARE COVERED BY THE OPERATING
INSTRUCTIONS, AS IMPROPER ADJUSTMENT OF OTHER
CONTROLS MAY RESULT IN DAMAGE AND WILL OFTEN
REQUIRE EXTENSIVE WORK BY A QUALIFIED TECHNICIAN
TO RESTORE THE PRODUCT TO NORMAL OPERATION.
– IF THE PRODUCT HAS BEEN DROPPED OR THE CABINET HAS
BEEN DAMAGED.
– IF THE PRODUCT EXHIBITS A DISTINCT CHANGE IN
PERFORMANCE.
10. AVOID USING A TELEPHONE (OTHER THAN A CORDLESS TYPE)
DURING AN ELECTRICAL STORM. THERE MAY BE A RISK OF
ELECTRIC SHOCK FROM LIGHTNING.
NOTICES
REQUIREMENTS OF PART 15 - FCC RULES
NOTE: This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures: a) move
the telephone away from the receiver; b) consult the dealer or an
experienced radio/TV technician for help. Any changes made by the
user not approved by the manufacturer can void the user’s authority
to operate the telephone.
IMPORTANT SAFETY INSTRUCTIONS
For Models
SIP LD4105S, SIP LD4110S
SIP LD4205S, SIP LD4210S
1. Introduction to the Teledex iPhone SIP LD Series
IP Phone 3
1.1 Definitions, acronyms and abbreviations 3
1.2 The SIP LD Series works like a telephone 3
1.3 Two lines 3
1.4 The network 3
1.5 The IP-PBX 3
1.6 The network system administrator 3
2. Installing the SIP LD Series IP phone 3
2.1 A Matter of Safety 3
2.2 Versions of the SIP LD Series 3
2.3 Unpacking the SIP LD Series 3
2.4 Connecting the handset 4
2.5 Connecting the SIP LD Series to the network 4
2.5.1 Version 1 (local power): Connect
network with the inline power adapter 4
2.5.2 Version 2 (PoE) 4
2.5.3 Version 3 (Dual power) 4
2.6 Connecting a PC to the SIP LD Series 4
2.7 Arranging the SIP LD Series on the desk 4
2.8 Mounting the SIP LD Series on a wall 4
3. Configuring the SIP LD Series 4
3.1 Starting up 4
3.2 Online configuration 4
3.2.1 Visit the configuration portal 4(Fig.2)
3.2.2 Change network configurations 5(Fig.3)
3.2.3 Set Line 1 & Line 2 information 5(Fig. 4)
3.2.4 Configure the auto dial keys 5(Fig. 5)
3.2.5 Configure the call features 6(Fig. 6)
3.2.6 Enable or disable multiple line appearances 6(Fig.7)
3.2.7 Upgrade the phones firmware 6(Fig.8)
3.2.8 Reset the iPhone 6(Fig.9)
3.2.9 Restore to factory configuration 7
4. Using the SIP LD Series IP Phone 7
4.1 Using the handset and speakerphone 7
4.1.1 Using the Handset 7
4.1.2 Using the speakerphone 7
4.1.3 Switching between handset and speakerphone 7
4.1.4 Adjust the ringer volume 7
4.1.5 Adjust the speaker volume 7
4.1.6 Adjust the handset volume 7
4.2 Placing a phone call 7
4.3 Receiving a phone call 7
4.4 Using Mute 7
4.5 Using Hold 7
4.6 Using the second line 7
4.7 Transferring a call 8
4.8 Redialing the last number 8
4.9 Pre-dialing a phone number 8
4.10 DTMF Signaling 8
5. Advanced Features of the SIP LD Series 8
5.1 Using call forwarding 8
5.2 Using call waiting 8
5.3 Speed dialing 8
5.3.1 Programming the Memory Dialing Keys
through “concealed” STORE key 8
5.3.2 Configure the timed pause for the speed dial 8
5.3.3 Using the Speed Dialing Keys 8
5.4 Three-Way Conference Calls 9
5.4.1 Three-way conference with one line 9
5.4.2 Three-way conference with 2 lines 9
5.5 Using voice mail 9
5.5.1 Message waiting 9
5.5.2 Retrieving messages 9
6. Care and Troubleshooting 9
6.1 Cleaning the SIP LD Series 9
6.2 In case of trouble 9
6.2.1 Disconnect from the network 9
6.2.2 Disconnect the PC 9
6.2.3 Check the cords and cables 9
7. Appendix A – European Requirements 9
8. Appendix B – SIP LD Series Product Specifications 9
9. Appendix C – Product Support 10
TAbLE OF CONTENTS

Produkt Specifikationer

Mærke: Teledex
Kategori: Telefon
Model: SIP LD4110S

Har du brug for hjælp?

Hvis du har brug for hjælp til Teledex SIP LD4110S stil et spørgsmål nedenfor, og andre brugere vil svare dig


Telefon Teledex Manualer

Teledex

Teledex SIP ND210L Manual

12 Januar 2025
Teledex

Teledex A110 Manual

6 September 2024
Teledex

Teledex SIP ND2105 Manual

18 August 2024
Teledex

Teledex Pearl S Manual

18 August 2024
Teledex

Teledex SIP LD4210S Manual

18 August 2024
Teledex

Teledex SIP ND2105S Manual

18 August 2024
Teledex

Teledex SIP ND2110 Manual

18 August 2024
Teledex

Teledex SIP ND2110S Manual

18 August 2024
Teledex

Teledex SIP LD4105S Manual

18 August 2024
Teledex

Teledex Opal 1003 Manual

18 August 2024

Telefon Manualer

Nyeste Telefon Manualer

Alcatel

Alcatel Temporis SP2604G Manual

10 Juni 2025
Panasonic

Panasonic KX-TGC212 Manual

9 Juni 2025
Panasonic

Panasonic KX-TG8051 Manual

6 Juni 2025
Siemens

Siemens Gigaset E500 Manual

2 Juni 2025
Gigaset

Gigaset E290M Manual

9 April 2025
Bogen

Bogen MCDS4 Manual

1 Marts 2025
Bogen

Bogen CA15C Manual

1 Marts 2025
Ubiquiti Networks

Ubiquiti Networks G3 Touch Enterprise Manual

25 Februar 2025
POCO

POCO X3 GT Manual

22 Februar 2025
POCO

POCO M4 Pro 5G Manual

22 Februar 2025