Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • Germany • www.thomann.de
DocID: 495774_30.07.2020
EN
Extremely low-noise Class A JFet amplier
For dynamic and ribbon microphones
2 matched JFet transistor pairs
The phantom power required for operation is NOT
fed to the microphone
Developed and produced in Germany
Input: 3-pin XLR socket,
balanced
Output: 3-pin XLR plug,
balanced
Input impedance: 20kOhm
Gain: 28dB (@ 3kOhm
source impedance)
Frequency response: 10Hz-50kHz (+/- 1dB)
Phantom power: 24-48V
Dimensions: 77×22mm (L×Ø)
Weight: 35g
FetAmp - Microphone preamp
This device is intended to preamplify microphone signals. Any other use or
use under other operating conditions is considered to be improper and may
result in personal injury or property damage. No liability will be assumed for
damages resulting from improper use.
Ensure that plastic bags, packaging, etc. are properly disposed of and
are not in the reach of babies and young children. Choking hazard!
Ensure that children do not detach any small parts (e.g. knobs or the
like) from the product. They could swallow the pieces and choke!
Never let children use electrical devices unattended.
For the transport and protective packaging, environmentally friendly
materials have been chosen that can be supplied to normal recycling.
Ensure that plastic bags, packaging, etc. are properly disposed of. Do
not just dispose of these materials with your normal household waste,
but make sure that they are collected for recycling. Please follow the
notes and markings on the packaging.
This product is subject to the European Waste Electrical and Electronic
Equipment Directive (WEEE) in its currently valid version. Do not dis-
pose of your old device with your normal household waste. Dispose of
this product through an approved waste disposal rm or through your
local waste facility. Comply with the rules and regulations that apply in
your country. If in doubt, consult your local waste disposal facility.
