251100902 - B
1. The Brake Kit is pre-assembled for use on single Thule
Chariot child carriers, however, if you will be using the
Brake Kit on a double Thule Chariot child carrier, you
will need to adjust the Jogging Brake Kit into its large/
wider size. To do this, remove the four bolts (using a
10mm wrench and a Phillips screwdriver) that secure
the four rails to the square tube.
2. For the Thule Chariot Corsaire, move the rails
outwards and re-install the bolts through the middle
two holes on each of the four rails. For the Thule
Chariot Cheetah 2, and the Thule Chariot Cougar
2 move the rails outwards, and re-install the bolts
through the outside two holes on each of the four
rails. Ensure that each bolt has two washers, which
are placed on the top and the bottom of the square
tube and sandwiched between the square tube and
the rails.
3. Remove the front wheel of the carrier (or install the
two wheel arms, but not the wheel).
4. While facing the front of your carrier, pivot both
quick release levers into the open position and
orient the main body of the Brake Kit so that the
levers and the brake calipers are on the bottom
pointing towards you.
5. Install the main body of the Brake Kit onto the wheel
arms by rst sliding one end of the Brake onto one
of the wheel arms followed by the other. Notice: do
not tighten the quick release levers yet.
6. Assemble the brake cable onto / through the carrier.
Refer to Figure #1a or #1b. Run the cables up the
right hand side of the carrier.
These instructions contain many WARNINGS. Read and
understand all of the Warnings. Failure to assemble
and use this accessory correctly may lead to serious
personal injury to your passenger.
GENERAL WARNING
• Use wrist safety strap at all times.
• Always use seat belts.
• Always use parking brake when jogging stroller is
stationary.
• Never in-line skate with the Jogging Kit. A serious
accident could occur resulting in serious injury or death.
Initial Assembly Time: About 5 minutes.
Tools Required: a 10mm wrench, Phillips screwdriver
and a 5mm Allen Key.
Read instructions carefully before assembly.
The brake cable does not need to be disassembled
for assembly.
Any reference to orientation (left or right) is from the
trailer passenger's point of view, while in the carrier.
Figure 1a
Figure 1b
Thule Chariot Corsaire or
Thule Chariot Captain
Thule Chariot Cougar or
Thule Chariot Cheetah
Pass cable through
sleeve to back of trailer
insert cable
through sleeve
Insert cable into sleeve
cable passes under
hollow axle
insert cable
through webbing
