Toolland PH360 Manual

Toolland Skæremaskine PH360

Læs gratis den danske manual til Toolland PH360 (17 sider) i kategorien Skæremaskine. Denne vejledning er vurderet som hjælpsom af 54 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 27.5 anmeldelser. Har du et spørgsmål om Toolland PH360, eller vil du spørge andre brugere om produktet?

Side 1/17

PH340/PH360

USER MANUAL 2

HANDLEIDING 4

MODE D'EMPLOI 6

MANUAL DEL USUARIO 8

BEDIENUNGSANLEITUNG 10

INSTRUKCJA OBSŁUGI 12

MANUAL DO UTILIZADOR 14

PH340/PH360

V. 01 05/12/2018 2 ©Velleman nv –

USER MANUAL

1. Introduction

Thank you for choosing Toolland. Please read the manual thoroughly before bringing this

device into service. If the device was damaged in transit, do not install or use it and contact

your dealer.

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.

2. Safety Instructions

Safety gloves are required while operating this machine.

 CAUTION The edges of cut tiles are sharp. –

 Always keep the appliance away from any crash and corrosive liquid.

 This tile-cutting machine is fitted with a replaceable circular blade. Keep the tile cutter and

blade away from children.

 After use, the appliance must be stored in a safe and dry place.

 This appliance is designed for cutting and breaking glazed tile, and shall not be used for

any other purpose.

 When using the appliance, always keep extension leads away from the machine.

 Always place the appliance on a level and firm surface.

3. Operation

1. Place the tile on the cutter bed. Set the guide to the width of the tile.

2. Position the tile-cutter wheel on the base of the tile to be cut.

Score the tile by moving the handle forward away from you while pressing down – –

lightly. K steady pressure for the full length of the tile. eep a

At the end of the score, the wheel will bump against the buffer. Make sure the anvil sits

over the score line.

3. Press down slightly applying increasing pressure until the tile snaps. Tip: Press the handle

with one hand and hold the base of the tile with the other.

Produkt Specifikationer

Mærke:	Toolland
Kategori:	Skæremaskine
Model:	PH360

Har du brug for hjælp?

Hvis du har brug for hjælp til Toolland PH360 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Skæremaskine Toolland Manualer

Toolland PH360 Manual

8 December 2024

Skæremaskine Manualer

Nyeste Skæremaskine Manualer

GARDE 181DC1 Manual

17 Juni 2025

Vollrath 55457 Manual

16 Juni 2025

Nemco 55450-4 Manual

16 Juni 2025

GARDE 181CHEESE34 Manual

15 Juni 2025

Vollrath 15203 Manual

15 Juni 2025

GARDE 181CHKSLC14 Manual

15 Juni 2025

GARDE 181CHKSLC12 Manual

15 Juni 2025

Choice 407LETCUT12 Manual

15 Juni 2025

Vollrath 55459 Manual

15 Juni 2025

Choice 407CHEESECMB Manual

15 Juni 2025