Tripp Lite MODBUSCARDSV Manual


Læs gratis den danske manual til Tripp Lite MODBUSCARDSV (48 sider) i kategorien Uafbrydelig strømforsyning (UPS). Denne vejledning er vurderet som hjælpsom af 36 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 18.5 anmeldelser. Har du et spørgsmål om Tripp Lite MODBUSCARDSV, eller vil du spørge andre brugere om produktet?

Side 1/48
Operation Manual
Programmable MODBUS Card
for SV, SVX, S3MX 100-200K
3-Phase UPS Systems
1111 W. 35th Street, Chicago, IL 60609 USA • tripplite.com/support
Copyright © 2019 Tripp Lite. All rights reserved.
Operation 2
1. Warning Item 2
2. Capability Setting 3
3. Control Item 3
4. Control Result 4
5. Setting Parameter to Default Value 4
6. UPS Working Status 5
7. UPS Battery Information 5
8. Temperature Inquiry 5
9. 3-Phase Load Inquiry 6
10. 3-Phase Bypass Info 6
11. Output Power Factor Inquiry 6
12. Load Level Inquiry 6
13. UPS Working Mode 6
14. UPS Fault Information 7
15. Loss Point 7
16. Setting Parameter Item 8
17. Setting Parameter Succeed or Fail 8
18. Remote Shutdown and Test 8
19. CPU Information 9
20. UPS Model and Rating Information 9
21. Parallel Inquiry 10
22. Date Inquiry 10
(Sys or Rack Info Inquiry Address)
23. Set Date 10
(Sys or Rack Info Inquiry Address)
Appendix 1 11
Appendix 2 11
Appendix 3 12
Español 13 • Fraais 25 • Русский 37
2
1. Warning Item
Holding Register (Range 0x0000 - 0x0001, Read Function 0x03)
The Read Holding Registers function code is used to read contents of a contiguous block of Holding Registers in a remote
device. Starting register address and number of registers is specified by the request Protocol Data Unit. Addresses start at 0
and registers numbered 1-16 address as 0-15.
The Write Single Register function code is used to write a Single Holding Register in a remote device. The address of the register
to be written is specified by the request Protocol Data Unit. Addresses start at 0 and registers numbered 1 address as 0.
Address
Description Value 0/Value 1Hex Decimal
0x0000 0
Bit15 = EPO is Active 0:FALSE/1:TRUE
Bit14 = Load is over load level and reach countdown delay 0:FALSE/1:TRUE
Bit12 = Load level is over Overload Alarm Level 0:FALSE/1:TRUE
Bit11 = Battery is not connected
(battery voltage is less than 9V) 0:FALSE/1:TRUE
Bit10 = Battery is over 15V 0:FALSE/1:TRUE
Bit8 = Including: EPO is active, Maintain Bypass is active, DC start, but DC start setting
is disabled
Line Status is not OK (Voltage or Frequency is out of range, Phase sequence is not
correct, Neutral Loss)
SYNCHRO signal is abnormal
TRIG0 signal is abnormal
0:FALSE/1:TRUE
Bit7 = Charger is abnormal 0:FALSE/1:TRUE
Bit6 = Checksum value of EEPROM Data saved in MCU
is not correct 0:FALSE/1:TRUE
Bit5 = Fan locked 0:FALSE/1:TRUE
Bit4 = Line Phase sequence is not correct 0:FALSE/1:TRUE
Bit3 = Bypass Phase sequence is not correct 0:FALSE/1:TRUE
Bit2 = Neutral is absent 0:FALSE/1:TRUE
Bit1 = Initial communication between DSP and MCU is abnormal 0:FALSE/1:TRUE
Bit0 = SYNCHRO signal is abnormal 0:FALSE/1:TRUE
0x0001 1
Bit15 = TRIG0 signal is abnormal 0:FALSE/1:TRUE
Bit14 = Power Module number is not consistent with setting 0:FALSE/1:TRUE
Bit13 = No STS in system 0:FALSE/1:TRUE
Bit12 = Maintain Bypass is active 0:FALSE/1:TRUE
Bit11-Bit0 = Reservation N/A
Operation


Produkt Specifikationer

Mærke: Tripp Lite
Kategori: Uafbrydelig strømforsyning (UPS)
Model: MODBUSCARDSV
Bredde: 67.1 mm
Dybde: 129 mm
Højde: 33 mm
Vægt: 80 g
Brugervejledning: Ja
Produktfarve: Sort
Produkttype: Netværksstyringskort
Pakkevægt: 200 g
Pakkedybde: 124.2 mm
Pakkebredde: 166.1 mm
Pakkehøjde: 48 mm
Antal: 1
Bæredygtighedscertifikater: RoHS
Hovedkassen højde (udvendigt): 240 mm
Hovedkassens længde (udvendigt): 297.9 mm
Hovedkassens bruttovægt (udvendigt): 4500 g
Hovedkassens bredde (udvendigt): 341.9 mm
Oprindelsesland: Kina
Grænsefladetype: RS-485
Produkter pr. hovedkasse (udvendigt): 20 stk
Kapabilitet: Tripp Lite SVTX / SVX / SV / S3M
Hovedkasse (udvendig) GTIN (EAN/UPC): 10037332241358

Har du brug for hjælp?

Hvis du har brug for hjælp til Tripp Lite MODBUSCARDSV stil et spørgsmål nedenfor, og andre brugere vil svare dig