Tripp Lite POS500 Manual

Tripp Lite Uafbrydelig strømforsyning (UPS) POS500

Læs gratis den danske manual til Tripp Lite POS500 (16 sider) i kategorien Uafbrydelig strømforsyning (UPS). Denne vejledning er vurderet som hjælpsom af 49 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 25 anmeldelser. Har du et spørgsmål om Tripp Lite POS500, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/16

Owner’s Manual

WARRANTY

REGISTRATION:

to win a FREE Tripp Lite product—

www.tripplite.com/warranty

POS (Point-of-Sale) Series

UPS Systems

120V AC Input

Not suitable for mobile applications

Important Safety Instructions

Quick Installation

Storage and Service

Warranty Registration

Basic Operation

Español

1111 W. 35th Street • Chicago, IL 60609 USA

(773) 869-1234 • www.tripplite.com

Français

Optional Installation 3

200711180 93-2716 POS OM.qxd 12/13/2007 1:50 PM Page 1

Important Safety Instructions

UPS Location Warnings

• Install your UPS indoors, away from excess moisture or heat, conductive contaminants, dust or direct sunlight.

• For best performance, keep the indoor temperature between 32º F and 104º F (0º C and 40º C).

• Leave adequate space around all sides of the UPS for proper ventilation.

•Do not mount unit with its front or rear panel facing down (at any angle). Mounting in this manner will

seriously inhibit the unit's internal cooling, eventually causing product damage not covered under warranty.

UPS Connection Warnings

• Connect your UPS directly to a properly grounded AC power outlet. Do not plug the UPS into itself;

this will damage the UPS.

• Do not modify the UPS’s plug, and do not use an adapter that would eliminate the UPS’s ground connection.

• Do not use extension cords to connect the UPS to an AC outlet. Your warranty will be voided if anything

other than Tripp Lite surge suppressors are used to connect your UPS to an outlet.

• If the UPS receives power from a motor-powered AC generator, the generator must provide clean,

filtered, computer-grade output.

Equipment Connection Warnings

• Use of this equipment in life support applications where failure of this equipment can reasonably be

expected to cause the failure of the life support equipment or to significantly affect its safety or

effectiveness is not recommended. Do not use this equipment in the presence of a flammable anesthetic

mixture with air, oxygen or nitrous oxide.

• Do not connect surge suppressors or extension cords to the output of your UPS. This might damage the

UPS and will void the surge suppressor and UPS warranties.

Battery Warnings

• Your UPS does not require routine maintenance. Do not open your UPS for any reason. There are no user-

serviceable parts inside.

• Batteries can present a risk of electrical shock and burn from high short-circuit current. Observe proper

precautions. Do not dispose of the batteries in a fire. Do not open the UPS or batteries. Do not short or

bridge the battery terminals with any object. Unplug and turn off the UPS before performing battery

replacement. Use tools with insulated handles. There are no user-serviceable parts inside the UPS. Battery

replacement should be performed only by authorized service personnel using the same number and type of

batteries (sealed Lead-Acid). The batteries are recyclable. Refer to your local codes for disposal

requirements or in the USA only call 1-800-SAV-LEAD or 1-800-8-BATTERY (1-800-822-8837) or visit

www.rbrc.com for recycling information. Tripp Lite offers a complete line of UPS System Replacement

Battery Cartridges (R.B.C.).Visit Tripp Lite on the web at www.tripplite.com/support/battery/index.cfm to

locate the specific replacement battery for your UPS.

• Do not attempt to add external batteries to the UPS.

SAVE THESE INSTRUCTIONS

This manual contains instructions and warnings that should be followed during the installation, operation

and storage of this product. Failure to heed these warnings will void your warranty.

Quick Installation

1. Plug the UPS into an outlet that doesn’t share a circuit with a heavy electrical load.*

* An air conditioner, refrigerator, etc.

2. Turn the UPS on: Press and hold the ON/OFF/TEST button for one second to turn the UPS on. The UPS

alarm will beep once briefly after one second has passed. NOTE: The UPS will not turn on, even if

connected to live utility power, until it is turned on using the ON/OFF/TEST button.

3. Plug your equipment into the UPS: Select outlets (see Basic Operation section) will provide battery backup

and surge protection; connect your computer, monitor and other critical devices here.* Select outlets (see Basic

Operation section) will provide surge protection only; connect your printer and other non-essential devices here.

* Your UPS is designed to support electronic equipment only. You will overload the UPS if the total VA ratings for all the equipment

you connect to the Battery Backup Protected/Surge Protected outlets exceeds the UPS’s Output Capacity. To find your equipment’s VA

ratings, look on their nameplates. If the equipment is listed in amps, multiply the number of amps by 120 to determine VA. (Example:

1 amp × 120 = 120 VA). If you are unsure if you have overloaded the Battery Backup Protected/Surge Protected outlets, run a self-

test (see “ON/OFF/TEST” Button description).

200711180 93-2716 POS OM.qxd 12/13/2007 1:50 PM Page 2

Produkt Specifikationer

Mærke:	Tripp Lite
Kategori:	Uafbrydelig strømforsyning (UPS)
Model:	POS500
Vægt:	3700 g
Produktfarve:	Sort
Pakkevægt:	4800 g
Formfaktor:	Tower
Responstid:	4 ms
Opbevaringstemperatur (T-T):	-15 - 50 °C
Relativ luftfugtighed ved drift (H-H):	0 - 95 %
Antal USB 2.0-porte:	1
Driftstemperatur (T-T):	0 - 40 °C
Dimensioner (BxDxH):	90.9 x 284.5 x 166.5 mm
Udgangseffekt:	300 W
Certificering:	UL1778, CSA, NOM, FCC Part 15 Category B, FCC Part 68, ROHS
LED-indikatorer:	Ja
Kabellængde:	1.8 m
Pakkens dimensioner (BxDxH):	180.1 x 159.9 x 240 mm
Mac kompabilitet:	Ja
Opladningstid for batteri:	10 t
Lydalarmer:	Ja
Input forbindertype:	5-15P
Nominel udgangsspænding:	120 V
Nominel indgangsspænding:	120 V
Output-forbindere:	6 x 5-15R
Overspænding energivurdering:	480 J
Output strømkapacitet (VA):	0.5 kVA
Typisk backup tid ved halv styrke:	16 min.
Typisk backup tid ved fuld styrke:	5 min.
Hot-swap batteri:	Ja