A - 1 Operating manual – WA 4i water separator
EN
TABLE OF CONTENTS
01. General description . . . . . . . . . . . . . . . . A - 01
02. Read before start-up A - 01 . . . . . . . . . . . . . . .
03. Principle of operation A - 03 . . . . . . . . . . . . . .
04. Start-up ......................... A - 04
05. Shutdown ....................... A - 04
06. Care and maintenance A - 05 .............
07. Technical data WA 4 i A - 06 ..............
08. Faults and troubleshooting A - 06 ..........
09. Warranty ........................ A - 07
10. EC Declaration of Conformity A - 08 ........
This release replaces all previous releases. No part of this publication may be
reproduced without written permission. The same applies for electronically
processing, duplicating or spreading the publication. Subject to technical chang-
es. All rights reserved. Trademarks are used without guarantee that they may be
used freely and primarily following the spelling of the manufacturer. The product
names used are registered and should be treated appropriately. The right to make
construction changes in the interests of constant product improvement as well
as changes to the shape and colour is reserved. The scope of delivery may vary
from product images. This document was produced with all due care. We accept
no liability whatsoever for mistakes or omissions. © TROTEC
®
01. GENERAL DESCRIPTION
The water separator WA4i is a device for commercial
use that was designed for combined usage with the
Trotec insulation dryers VX5, the HEPA filter and the
NR silencers.
The insulation dryer and the water separator constitute
an operating unit. The water separator WA 4i enables
suction of both contaminated air containing water and
free water itself.
02. READ BEFORE START-UP
• The WA 4i is to be used as a water
separator for insulation drying of
screeds or flat roofs. It must be
set up vertically with all castors
standing on flat ground. The device
must not be used as storage place
or footstep.
• For storage, up to 3 WA 4i devices
may be stacked on top of one another. The WA 4i is
positioned inside the provided borders.
• The WA 4i water separator's task is to keep water
and dirt particles away from the intake flow of
downstream side channel blower.
1
2)
3
4
5
6
1. Vacuum connectors
2. Inlet connectors
3. Socket for the
insulation drying unit
4. Power button
5. Status indicator/
residual water button
6. Waste water
connection
7. TTKwic
quick coupling
2
7
