
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
181017
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0445 T0446
Hardware Package (inculded):
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box
Installation Steps
IMPORTANT:
The sensor has an excellent photocell function
to enable the light to turn on at dusk and off at
dawn automatically.
Mounting Screw (B)
Green Grounding
Screw (E)
Wire Connector (F)
Lock Nut (D)
Ball Nut (G)
Rubber Pad (H)
Cross Bar(A)
Headless Screw (C)
Ball Nut (G)
Rubber Pad (H)
Wire Connector (F)
Outlet Box
Lock Nut (D)
Mounting Screw (B)
Bulb Type T10 MAX 60W
(not included)
1. Thread two headless screws (C) through the cross bar (A),
and then secure them with four lock nuts (D) (two on each
side of the cross bar). Adjust the length of the headless
screws if necessary.
Note: Make sure that the headless screws are lined up
horizontally to make the fixture level.
2. Attach the cross bar (A) to the outlet box by using two mounting screws (B).
3. Pull out the outlet wires and house grounding wire from the outlet box. Make wire
connections using the wire connectors (F):
---The black wire from the fixture to the black wire from the power source.
---The white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the cross bar with the green grounding
screw (E). Then connect it to the house grounding wire with a wire connector (F).
Carefully put the wires back into the outlet box.
Fixture Wire
Green Grounding Screw (E)
Cross Bar (A)
Fixture Grounding Wire
Headless Screw (C)
Back Plate