Vemer Energy-3x130 PWRi Manual

Vemer Måleudstyr Energy-3x130 PWRi

Læs gratis den danske manual til Vemer Energy-3x130 PWRi (2 sider) i kategorien Måleudstyr. Denne vejledning er vurderet som hjælpsom af 36 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 18.5 anmeldelser. Har du et spørgsmål om Vemer Energy-3x130 PWRi, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

User Manual

ACTIVE ENERGY METER

Read all the instructions carefully

TheENERGY-400 ENERGY-3x130 and are electronic static devices to read active energy in

three-phasesystemsdesignedtooperateinenvironmentswithmeasurementcategoryIIIand

pollution level 2 according to EN 61010-1 standard.

SAFETY WARNINGS

To guarantee correct installation, proceed as follows:

1) The appliance should be installed by a qualified operator

2) The appliance should be installed in a panel in such a way as to guarantee that the

terminals are inaccessible after fitting

3) A protection device against over-currents should be installed in the electrical system,

upstream of the energy meter

4) Connect the instrument as shown in the alongside diagrams

5) Before touching the connector terminals make sure that the wires to be connected or

already connected to the instrument are not live

6) Touch the dip-switches only when the instrument is not powered

7) Do not power or connect the instrument if any part of it is damaged

8) The instrument must be installed and activated in compliance with current electric

system standards.

Code Model Description

VN964300 ENERGY-400PWR Three-phaseenergymeter400VAC

VN966800 ENERGY-3x130PWR Three-phaseenergymeter3x130VAC

VN967600 ENERGY-3x130PWRi Three-phaseenergymeter3x130VAC

TECHNICAL SPECIFICATIONS

• Powersupply:

- 3x230 V AC phase-neutral (400VAC phase-phase) (-15% ÷ +10%)

for Energy-400 model

- 3x130 V AC phase-neutral (230VAC phase-phase) (-15% ÷ +10%)

for Energy-3x130 models

• Frequency:50/60Hz

• Ratedcurrent:5A

• Maximumcurrent:6A

• Minimumstart-upcurrent:15mA

• Maximumpowerconsumption:

- voltage circuits < 2,5 VA

- current circuits < 2,5 VA

• Meterconstant:1imp=¼kWh

• Voltageinputs:inputimpedance=2MΩ

• Currentinputs:

 -shuntof0.022 (+/-10%)forΩPWR models

 -coilswithgalvanicinsulationbetweenprimaryandsecondaryforEnergy-3x130PWRi

model

• Twoopticinsulatedimpulseoutput:

- impulse duration < 100 ms

- voltage 9÷24 V DC

- current < 20 mA

• Insulation:

 -reinforcedbetweenimpulseoutputandotherterminals

- reinforced between terminals and parts accessible after installation

• CTavailable:5-10-25-50-75-100-125-150-200-250-300-400-500-600-8001000/5A

• Operatingtemperature:-10°C÷+45°C

• Storagetemperature:-25°C÷+70°C

• Relativehumidity:10÷90%noncondensing

• Classindex:classA(EN50470)

• Container:4moduleDIN

• Protectionlevel:IP20/IP40onthefront

INSTRUMENT DESCRIPTION

 Dip-switchforCTsetting

Green warning light:lightsuptoindicatepoweron

Red warning light:flashestoindicatethattheinstrumentismeteringenergy

(1flash=¼kWh)

Yellow warning light:whenlittheinstrumentdetects¼kWhnegative(probable

incorrectentry)andremainslituntil¼kWhpositiveisdetected

ChecktheinsertionofCT:connectL1,L2,L3frompowerpaneltoP1ofCTand

connectP2ofCTtotheload.

 Impulseoutput:Opticallyinsulated

 Electro-mechanicalimpulsecounter:resolution1kWh

GUIDE TO INSTALLATION

1)Beforeinstallingtheinstrument,selecttherequiredtransformationratio,asshownin

panel C)

2) PWR ForEnergy-3x130 imodelonly,theCTsecondariesmaybeconnectedtoearth

3)Theinstrumentshouldbeconnectedasshowninthepanel ,inaccordancewiththeB)

CTcurrentdirections

4)Iftheerroristofallwithintheclasslimitsoftheinstrument,itisnecessarytousethe

current transformer in its linear operating field.

5)IftheinstrumentisactivethepowershouldbeswitchedofftochangetheCTratio.

6)Incaseofchangestothedip-switchwiththeinstrumentactived,theselocksinfault

conditionwithredandgreenlightsalwayson.Inthisconditiontheinstrumentdoesn’t

coun.

 Torestorethecorrectoperation,repositiontheDIPswitchesintheinitialconditionor

resettheinstrumentbyremovingandrestoringpower.

REFERENCE STANDARDS

ConformitytoEUdirective:

2004/22/EC (MID)

2006/95/EC (Low Voltage - LVD)

isdeclaredwithreferencetothefollowingharmonisedstandards:

EN 61010-1

EN50470-1andEN50470-3

V3IS00244-100_02-2013

Mod. ENERGY-400 PWR

Mod. ENERGY-3x130 PWR

ENERGY-3x130 PWRi

Dimensions (A)

Connection diagrams (B)

Instrument description (C)

2 CT connection ( ) WITHOUT neutral (3 wires)PWR onlyi

1 kWh/pulse

Pulse output

I 20 mA≤

9÷24 VCC

PWRi

P1 P2

S1 S2

PWR

P1 P2

S1 S2

200

250

300

400

x/5 A1 234 x/5 A1 2 34

100

125

150

500

600

800

1000

ON OFF

3 CT connection WITH or WITHOUT neutral (3 or 4 wires)

1 kWh/pulse

Pulse output

I 20 mA≤

9÷24 VCC

72 60

1 460 0 0

60 0 0

Produkt Specifikationer

Mærke:	Vemer
Kategori:	Måleudstyr
Model:	Energy-3x130 PWRi

Har du brug for hjælp?

Hvis du har brug for hjælp til Vemer Energy-3x130 PWRi stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Måleudstyr Vemer Manualer

Vemer Energy-230 M Manual

2 Oktober 2024

Vemer Energy-230 Wi-Fi Manual

2 September 2024

Vemer Energy-230 Micro LCD Manual

7 August 2024

Vemer Energy-3x130 PWRi Manual

30 Juli 2024

Vemer Energy-400 PWR Manual

28 Juli 2024

Vemer Energy-400 D PWR Manual

23 Juli 2024

Vemer Energy-230 Micro Manual

22 Juli 2024

Måleudstyr Manualer

Nyeste Måleudstyr Manualer

3 April 2025

3 April 2025

3 April 2025

3 April 2025

3 April 2025

3 April 2025

3 April 2025

3 April 2025

3 April 2025

3 April 2025