Vitek VT-1230A-D18 Manual

Vitek Ikke kategoriseret VT-1230A-D18

Læs nedenfor 📖 manual på dansk for Vitek VT-1230A-D18 (1 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 12 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
!
DC 12 30AV 18CH Power Supply Models - -VT 1230A D18!
Installation instruction:
1. Install box at desired location in a cool place. The power
supply can be wall . Make the hole position on mounted
the wall using the back of the box as a template and drill
four holes. Screw in the top two holes with the mounting
M4 screws hang the power supply box - tand hen affix
the bottom screws. Use drywall anchors if solid beams
are unavailable.
2. Knock out (remove) the appropriate perforated knockouts
for running cables through.
3. Turn power switch to “OFF” posi . tion
4. U” Connect each camera device to one "+U” & one “-
power output terminal. Be careful that the “+” & “-“ match
at the camera as well.
5. 11 Plug the AC plug into local 0VAC power outlet. Turn
power switch to “ON” position. The green LED light
should be on showing power is being supplied to the
camera.
6. Close the cover and secure it with provided screw.
Technical Specifications
Each channel is protected with a 1 Amp,PTC resettable .85
fuse.
Operation emperature: - +86 degrees F the t 14 to
Storage temperature: - degrees F 14 to +140
Notes:
1. When used in an extreme weather climate the power ,
panel may take up 30 seconds to boot up after initial
connection to power.
2. 2 To avoid the risk of fire use only type STP- wire or
heavier No.18AWG cop . Use wire gauge per at minimum
suitable for at least 194 degrees F.
!


Produkt Specifikationer

Mærke: Vitek
Kategori: Ikke kategoriseret
Model: VT-1230A-D18

Har du brug for hjælp?

Hvis du har brug for hjælp til Vitek VT-1230A-D18 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Vitek Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer