Whirlpool AWM 5130/3 Manual


Læs gratis den danske manual til Whirlpool AWM 5130/3 (14 sider) i kategorien Vaskemaskiner. Denne vejledning er vurderet som hjælpsom af 24 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 12.5 anmeldelser. Har du et spørgsmål om Whirlpool AWM 5130/3, eller vil du spørge andre brugere om produktet?

Side 1/14
CONTENTS
BEFORE USING THE WASHING MACHINE
PRECAUTIONS AND GENERAL RECOMMENDATIONS
DESCRIPTION OF THE WASHING MACHINE
DOOR
CHILD SAFETY (IF AVAILABLE)
BEFORE THE FIRST WASH CYCLE
PREPARING THE WASH
DETERGENTS AND ADDITIVES
REMOVING THE FILTER
DRAINING RESIDUAL WATER
CARE AND MAINTENANCE
AFTER-SALES SERVICE
TRANSPORT/HANDLING
ELECTRICAL CONNECTION
3gb05369.fm Page 57 Wednesday, June 5, 2002 6:59 PM
Black process 45.0° 100.0 LPI
58
BEFORE USING THE WASHING MACHINE
1.Remove the packaging and check
After unpacking, make sure that the washing
machine is undamaged. If in doubt, do not use
the washing machine. Contact After-Sales
Service or your local retailer
Check that the accessories and supplied parts are
all present
Keep the packing material (plastic bags,
polystyrene parts, etc.) out of reach of children,
as they are potentially dangerous
2.Remove the transport bolts
The washing machine is fitted with a transport
bolts to avoid any possible damage to the
interior during transport. Before using the
washing machine, it is imperative that the
transport bolts are removed
3.Install the washing machine
Remove the protective foil from the control
panel
Move the appliance without lifting it by the
worktop
Install the appliance on a solid and level floor
surface, preferably in a corner of the room
Make sure that all four feet are resting firmly on
the floor and check that the appliance is
perfectly level (use a spirit level)
4.Water inlet
Connect the water supply inlet hose in
accordance with regulations of your local water
company
Water inlet: Cold water only
Tap: 3/4” threaded hose connection
Water Pressure
(flow pressure): 100-1000 kPa (1-10 bar).
5.Drain hose
Connect the drain hose to the siphon or hook it
over the edge of a sink by means of theU” bend
supplied
If the washing machine is connected to a built-in
pumping out system, ensure that the latter is
equipped with a vent to avoid simultaneous
loading and draining of water (siphoning effect)
6.Electrical connections
Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer’s instructions and local safety
regulations
Data concerning voltage, consumption and fuses
are located on the inside of the appliance door
The appliance must be connected to the mains
exclusively by means of a socket with an earth
connection in accordance with established
regulations. The washing machine must be
earthed by law. The manufacturer declines all
liability for damage to property or injury to
persons or animals due to non-compliance with
the directions given above
Do not use extension leads or multi sockets
Before any maintenance on the washing
machine disconnect it from the mains supply
Access to the mains plug or to disconnection
from mains supply via a double-pole switch must
be ensured at all times following the installation
Do not operate the washing machine if it has
been damaged during transport. Inform the
After-Sales Service
Mains cable replacement is only to be carried out
by After-Sales Service
The washing machine must only be used in the
household for the prescribed uses
Minimum housing dimensions:
Width: 600 mm
Height: 825 mm
Depth: 600 mm
3gb05369.fm Page 58 Wednesday, June 5, 2002 6:59 PM
Black process 45.0° 100.0 LPI


Produkt Specifikationer

Mærke: Whirlpool
Kategori: Vaskemaskiner
Model: AWM 5130/3

Har du brug for hjælp?

Hvis du har brug for hjælp til Whirlpool AWM 5130/3 stil et spørgsmål nedenfor, og andre brugere vil svare dig