Xvive PX Manual

Xvive Ikke kategoriseret PX

Læs gratis den danske manual til Xvive PX (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 20 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 10.5 anmeldelser. Har du et spørgsmål om Xvive PX, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

● 3-channel mixer and headphone amplier for personal in-ear-monitoring applications

● Ultra-compact and lightweight design

● Cat 5 cable transmits three channels of audio and 9 volts of Power over

Ethernet (PoE)

● Three balanced female XLR plugs connect to your mixing console or other

audio devices

● Level control knob powers o the unit all the way counterclockwise

● Three balanced XLR to unbalanced 1/4” adapters included

● DIP switches inside PX allow you to control how each channel is panned: left,

right, or both

● PoE/battery power switch selects either Cat 5 9V PoE power or 2x AAA battery

power

● Runs for up to 5 hours on 2 AAA batteries (not included)

● LED indicates when battery power is being used

● Sturdy beltpack clip

● Ultra-rugged impact-resistant metal chassis

● Ethernet cable can simultaneously transmit audio and power over a distance of

up to 200 ft

As a musician and/or singer, whether you’re performing live, rehearsing with a

band or recording in a studio, you need to hear both yourself and the other

musicians. But just as importantly, you need to have control over what you hear.

Everyone hears dierently from their own perspective, so everyone needs to

have control over their own mix.

Ideally, you’d have a monitor engineer—but in most situations it’s likely that you

or another band member are controlling the monitor mix from the stage. Or a

sound technician at the other end of the room has the control; but it’s hard to

communicate with them during a show. Instead of having a xed monitor mix

from the board, PX allows you to set up a simple three-channel monitor mix that

allows you to adjust the levels that matter to you the most—on the y. For

example, one knob could control your vocal level, one could control your

instrument level, and another could be a submix of other vocals and instruments.

With the PX system, control of that balance is always within reach, and always

adjusted perfectly to your liking!

FEATURES

NO SOUND

• Check that the audio source is connected to PX-B and sending signal

• Check that the EC25 cable is connected to PX-A and PX-B

• Check that input 1, 2, and 3 volume controls on PX-A are not turned all the way down

• Check that the main volume knob / power switch is turned on

• Check that earphones/headphones are properly connected

• Check that left and right channel switches in the battery case are not all set to

the o position

NO POWER

• Check that the PX-A power switch (/volume knob) is turned on

• Check that the power mode switch is correctly set to PoE or AAA battery

• Check that the batteries have been installed correctly

• Check to make sure that the PoE power adapter used is 9V/2A DC center-negative

• Check that the EC25 cable is in working order and connected properly

TROUBLESHOOTING

PRODUCT OVERVIEW

PORTABLE 3-CHANNEL

PERSONAL MIXER

For personal IEM/headphone mixes

for live and recording

COMPLETE PX SYSTEM

SPECIFICATIONS

Input type:

Input impedance:

Output type:

Output impedance:

Max. output:

Power input:

Battery life:

Current:

Ethernet cable length:

PoE power requirement:

Balanced XLR

13.3 kΩ

1/8” TRS (stereo)

8-80 Ω

2x 150 mW @ 16 Ω

PoE (Power over Ethernet) or 2x AAA batteries

~5 hours

~210 mA

25 feet / 7.6 m

9V/2A center-negative (powers up to 5 PX-A units)

9V / 500mA center-negative for one PX-A unit

LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT

HEARING DAMAGE. USE AS LOW A VOLUME AS POSSIBLE.

Overexposure to excessive sound levels can damage your ears, resulting in

permanent noise-induced hearing loss. Do not use earphones for a long time and

set the volume below 50%.

Xvive accepts no liability for any loss which may be suered by any person who

relies either wholly or in part upon any description, photograph, or statement

contained herein. Technical specications, appearances and other information

are subject to change without notice.

LIMITED WARRANTY

LEGAL DISCLAIMER

For the applicable warranty terms and conditions and additional information

regarding the Xvive Limited Warranty, please email support@xvive.com.

WARNING

Input 1 Volume

Ethernet input

Input 2 Volume

Input 3 Volume

Power LED

PoE mode: solid on

Battery mode:

100% - 20% charged: Blue LED

20% - 10% charged: Pink LED

10% - 0% charged: Red LED

(When the LED is red, the batteries should be replaced)

Stereo setup DIP switches

L switch ON = audio is sent to the left earphone

R switch ON = audio is sent to the right earphone

L and R both ON = audio is sent to left and right sides

Earphone/headphone output

Earphone/headphone volume

PoE / battery

power switch

Battery compartment

and stereo setup

DIP switches

Ethernet output

Balanced XLR 1

Balanced XLR 2

9V DC center-negative

power input

Balanced XLR 3

Includes 3 balanced-XLR-to-¼”-unbalanced-TS adapters

PX-B

CH1

ON ON ON

L R L R L R

CH2 CH3

PX-A

DISTORTED AUDIO

• Check if the master volume is too high

• Check the levels going in and out of the PX-A mixer

• Verify that each signal is not distorted at the audio source

• Low batteries can cause distortion. Check batteries and replace if necessary.

LOW AUDIO LEVEL FROM THE PXA EARPHONE OUTPUT

• Check the PX-A master volume (earphone/headphone output) level

• Check CH1, CH2, CH3 volume levels

• Check output levels from audio sources (e.g. mixing console aux outs)

MULTIPLE CONNECTIONS WITH PXH

• The PX-B signal can be sent to up to ve PX-A units via the PX-H Hub, to be

heard simultaneously by up to ve people. You can also stack multiple PX-H

units to build a larger system for more than 5 people.

XLR to ¼” TS

Adapter x 3

EC25PX-BPX-A

CH3 CH1 CH4

CH2

T568B

Orange+

White

Orange

Green

Brown+White

Brown

Green+White

Blue

Blue+White

ETHERNET INPUT

CH 1 is input 1 XLR hot and XLR cold Blue Blue+White

, ,

CH 2 is input 3 XLR hot and XLR cold Green Green+White, ,

CH 3 is input 2 XLR hot and XLR cold Orange Orange+White, ,

CH 4 is PoE power input, Brown (+), Brown+White (-)

Produkt Specifikationer

Mærke:	Xvive
Kategori:	Ikke kategoriseret
Model:	PX

Har du brug for hjælp?

Hvis du har brug for hjælp til Xvive PX stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Xvive Manualer

3 Juli 2025

3 Juli 2025

27 Juni 2025

26 Juni 2025

25 Juni 2025

30 Januar 2025

Xvive More You Manual

30 Januar 2025

Xvive A58 Manual

6 September 2024

Xvive G1 Manual

3 September 2024

Xvive V19 Micro Power Manual

21 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Dahua Technology DHL32-F600 Manual

28 Oktober 2025

Dahua Technology VTS5240B Manual

28 Oktober 2025

Dahua Technology HAC-HFW1230S-POC Manual

28 Oktober 2025

Dahua Technology HAC-HDW1400TLMQ-A Manual

28 Oktober 2025

Dahua Technology EVS7124D Manual

27 Oktober 2025

Dahua Technology XVR7816S-4KL-X-LP Manual

27 Oktober 2025

Dahua Technology HAC-HDW1220EM Manual

27 Oktober 2025

Dahua Technology ISC-M6550 Manual

27 Oktober 2025

Dahua Technology EVS7148D Manual

27 Oktober 2025

Dahua Technology HAC-HFW2249E-A Manual

27 Oktober 2025