Yamaha NS-C300 Manual

Yamaha Højttaler NS-C300

Læs gratis den danske manual til Yamaha NS-C300 (2 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 8 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 4.5 anmeldelser. Har du et spørgsmål om Yamaha NS-C300, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Read these precautions carefully before using your speaker.

●Any time you note distortion, reduce the volume control on your

amplifier to a lower setting. Never allow your amplifier to be

driven into “clipping”. Otherwise the speaker may be damaged.

●When using an amplifier with a rated output power higher than

the nominal input power of the speaker, care should be taken

never to exceed the speaker’s maximum input.

●Do not attempt to clean the speaker with chemical solvents as

this might damage the finish. To clean, wipe with a dry, soft cloth.

●To prevent the enclosure from warping or discoloring, do not

place the speaker where it will be exposed to direct sunlight or

excessive humidity.

●Do not place the speaker where it is liable to be knocked over or

struck by falling objects. Stable placement will also ensure better

sound performance.

●Placing the speaker on the same shelf or rack as the turntable

can result in feedback.

●When positioning the speaker, be sure to leave some space

between the speaker and the wall or other hard surface.

●Secure placement or installation is the owner’s responsibility.

YAMAHA shall not be liable for any accident caused by improper

placement or installation of the speaker.

NS-C300

Speaker System

Thank you for selecting this YAMAHA NS-C300 speaker system.

PRECAUTIONS

PLACING THE SPEAKER

Place the center speaker on the floor under the TV or inside the TV

rack so that it is stabilized. The center speaker should be set in

alignment with the center of the TV screen.

The positioning of the center speaker is important, because it

controls the whole sound quality of a multi channel system. Set up

the center speaker on the basis of your listening position by

following the owner’s manual supplied with your amplifier.

Notes

●Do not place the center speaker on top of the TV. If placed,

the speaker may fall and possibly cause damage or personal

injury.

●Though this speaker is magnetically shielded, there may be

some influence on the TV picture depending on the type of

TV or the placement of the speaker. In such a case, place the

speaker away from the TV so that there is no influence on

the TV picture.

OWNER’S MANUAL

Type .......................... 2-way 3-speaker bass reflex speaker system

(Magnetically-shielded type)

Speaker Unit ...................................... 16 cm (6.5”) cone woofer x 2

3 cm (1”) dome tweeter

Nominal Impedance ............................................................. 6 ohms

Frequency Response ............................................... 45 Hz – 35 kHz

Nominal Input Power.............................................................. 140 W

Maximum Input Power ........................................................... 400 W

Sensitivity ................................................................ 91 dB/2.83 V/m

Crossover Frequency .............................................................. 3 kHz

Dimensions (WxHxD)....................................... 540 x 212 x 290 mm

(21.3” x 8.3” x 11.4 ”)

Weight ................................................................. 12.4 kg (27.4 lbs.)

●Specifications subject to change without notice due to product

improvements.

●Care should be taken not to exceed the input power values

noted above.

SPECIFICATIONS

REMOVING THE FRONT COVER

The front cover is fastened to the enclosure at four points, and can

be removed if desired. To remove the cover, hold on to both sides

and slowly pull straight away from the speaker. To reattach, line up

the four pegs on the inside surface of the cover with the four

corresponding holes on the speaker and push gently.

Note

When the cover is removed, take care not to touch the speaker

units with your hands or to exert excessive force with tools.

Surround L

Surround R

Subwoofer

NS-C300

Main R

Main L

English

–

CENTER

–

CENTER

CONNECTIONS TO YOUR AMPLIFIER

Leave the short

bars in place

when connecting.

Short bar

–

<Bi-Wiring Connections><Standard Connections>

Center speaker

Amplifier or

Receiver

–

This speaker system is capable of standard connections and bi-wiring connections. Before making connections, make sure that

the amplifier is switched off.

Center speaker

Remove the short

bars before

connecting.

■ Connections

●Connect the screw-type input terminals at the rear of the speaker

to the speaker output terminals of your amplifier with the speaker

cables.

●Connect the (+) terminals on both the amplifier and the speaker

using one side of the cable. Connect the (–) terminals on both

components using the other side of the cable.

●Connect the speaker to the center terminals of your amplifier,

making sure not to reverse the polarity (+, –). If this speaker is

connected with reversed polarity, the sound will be unnatural and

lack bass.

Procedure:

➀Loosen the terminal knob.

➁Remove approx. 10 mm (3/8”) insulation from the speaker

cable and insert the bare wire end properly into the terminal

hole.

➂Tighten the knob.

➃Test the security of the connections by tugging lightly on the

cable at the terminal.

Note

Do not let the bare speaker wires touch each other as this

could damage the speaker and/or the amplifier.

Bi-Wiring Connections

This speaker system is capable of bi-wiring connections. To

connect the speaker to the output terminals of the amplifier, two

pairs of cables for each of woofer and tweeter are used instead of

standard connections. This type of connection decreases the

modulation distortion caused by electric resistance of the cables

and driving current of the speakers. Consequently, purer sound

quality can be expected.

To utilize bi-wiring connections, remove the short bars from the

terminals first, and then connect the woofer and tweeter to the

amplifier separately using two pairs of cables.

Note

For bi-wiring connections, use the same type of cable for both

the woofer and tweeter, making sure to match the polarity.

Loosen

Tighten

Amplifier or

Receiver

Woofer terminals

Tweeter terminals

V404310

Printed in Malaysia

Produkt Specifikationer

Mærke:	Yamaha
Kategori:	Højttaler
Model:	NS-C300

Har du brug for hjælp?

Hvis du har brug for hjælp til Yamaha NS-C300 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Højttaler Yamaha Manualer

Yamaha VXL1W-16P Manual

5 September 2025

Yamaha Stagepas 150M Manual

27 August 2025

Yamaha Stagepas 250M Manual

25 August 2025

Yamaha RMA1MB Manual

18 August 2025

Yamaha NS-600A Manual

10 August 2025

Yamaha MusicCast 200 Manual

10 August 2025

Yamaha NS-800A Manual

10 August 2025

Yamaha NS-BP150 Manual

9 August 2025

Yamaha DZR12-D Manual

9 August 2025

Yamaha True X Speaker WS-X1A Manual

9 Juni 2025

Højttaler Manualer

Nyeste Højttaler Manualer

Energy Sistem TempoRave Manual

11 December 2025

RCF C 5215-W MKIII Manual

10 December 2025

RCF X 28 L Manual

10 December 2025

Fostex PM0.4d Manual

8 December 2025

Amphion Argon 3LX Manual

8 December 2025

Amphion Argon 7LX Manual

8 December 2025

8 December 2025

8 December 2025

7 December 2025

7 December 2025