
ZGK6300
ZGK6310
INSTRUKCJA UŻYTKOWANIA 
Wielofunkcyjny trymer
ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ 
Многофункциональный триммер
NÁVOD K POUŽITÍ 
Multifunkční zastřihovač
ИНСТРУКЦИИ ЗА УПОТРЕБА 
Многофункционален тример
NÁVOD NA UOBSLUHU
Multifunkčný zastrihávač
ІНСТРУКЦІЯ ПО ЗАСТОСУВАННЮ 
Багатофункціональний тример
USER MANUAL 
Multi groomer
BENUTZERHANDBUCH 
Multifunktionaler Trimmer
HASZNÁLATI UTASÍTÁS 
Többfunkciós trimmer
INSTRUCȚIUNI DE UTILIZARE 
Aparat de tuns multifuncțional
PL
EN
DE
CZ
SK
HU
RO
RU
UA
BG
ZGK6300/ZGK6310
WE WOULD LIKE TO THANK YOU FOR CHOOSING ZELMER. WE WISH 
THE PRODUCT PERFORMS TO YOUR SATISFACTION AND PLEASURE.
WARNING
PLEASE READ THE INSTRUCTIONS FOR USE CAREFULLY PRIOR TO 
USING THE PRODUCT. STORE THESE IN A SAFE PLACE FOR FUTURE 
REFERENCE
DESCRIPTION
1. T-blade
2. ON/OFF switch button
3. 3-10mm trimmer guide
4. Storage pouch
5. Cleaning brush
6. Design trimmer
7. Mini foil shaver
8. Nose and ear trimmer
9. LED Indicator light
10. Cutting guide (12/15/18/21mm)
11. Oil bottle
12. USB charging cable
SAFETY INSTRUCTIONS
This device can be used by children aged 3 
or over under supervision. This appliance 
can be used by children aged from 8 years 
and above and persons with reduced 
physical, sensory or mental capabilities or 
lack of experience and knowledge if they 
have been given supervision or instruction 
concerning use of the appliance in a safe 
way and understand the hazards involved. 
Children shall not play with the appliance. 
Cleaning and user maintenance shall not be 
made by children without supervision.
This device can only be connected with the 
USB interface (5VDC, Output Max 1A).
Follow the DEVICE CHARGE instructions 
in order to charge it.
Follow the device BATTERY REMOVAL 
instructions for removal of the batteries from 
the device.
This device is designed for use at a 
maximum altitude up to 2000m above sea 
level.
IMPORTANT WARNINGS
This appliance is designed for home use and should never be used for commer-
cial or industrial use under any circumstances.
Do not use the device on wet hair.
Do not use connect or disconnect the device to the mains with your hands or feet 
wet. Do not use any accessories other than those supplied.
Do not use this device near to bathtubs, showers, sinks or other tanks that 
contain water. The mains connection cable must not be tangled or wrapped 
around the product during use. Do not pull on the cable to unplug it or use it to 
carry the product.
Do not wrap the cable around the device.
Proceed according to the cleaning section of this manual for cleaning. Do not use 
the product on animals.
Unplug the product immediately from the mains in the event of any breakdown 
and contact an authorised Technical support service.
 In order to prevent any risk of danger, do not open the device. Only qualified 
technical personnel from the brand´s Official Technical support service may carry 
out repairs or procedures on the device.
Any incorrect use or improper handling of the product shall render the warranty 
null and void. Only an authorised technical support service centre may carry out 
repairs on this product.
B&B TRENDS SL. disclaims all liability for damages that may occur to people, 
animals or objects, for the non-observance of these warnings.
INSTRUCTIONS FOR USE
Always ensure the appliance is switched off before changing any attachments.
Place the desired trimming head on top of the groomer and attach the desired 
cutting comb guide.
Switch the groomer on by moving up the on/off switch button (Fig.2) and move 
down again to turn it off.
The LED indicator (Fig.9) will turn in green light when the groomer is switched on.
You  can  choose  between  different  cutting  fixed  comb  guides  12/15/18/21mm 
(Fig.10) or 3-10mm adjustable trimmer guide (Fig.3).
HOW TO PLACE AND REMOVE 
ATTACHMENTS
A detachable blade system enables you to quickly change from blade for full 
grooming to detail trimming blade around a moustache, goatee, or anywhere to 
define the hair line. To remove the attachments, simply pull top edge of blade 
away from the body unit. To attach, align the back tab of the attachment head to 
the cavity on the inner edge of trimmer unit and push down on top of blade.
T-BLADE (Fig.1)
For uniform cutting, allow the trimmer to cut its way through the hair. Do not force 
it through at a faster rate.
Select the desired length on the adjustable comb 3-10mm or select the desired 
guide combs 12/15/18/18mm. Start by combing the hair so it falls into its natural 
direction.
Place the largest guide comb onto your trimmer and start by trimming the sides 
from the bottom upwards. Hold the trimmer lightly against the hair, with teeth of 
the guide comb pointing up but flat against the head. Slowly lift the trimmer up 
and outward through the hair, cutting only a small amount at a time. Repeat 
around sides and back of head.
To trim your beard/moustache hold the groomer with the cutting blade facing you.
Start with edge of beard/moustache line, and with the cutting blades resting 
lightly against your skin, use slow movements to create a beard/moustache line.
 
DESIGN TRIMMER (Fig.6)
Use the design trimmer to create fine lines and contours around your facial style, 
close to the skin.
Hold the design trimming head perpendicular to the skin and move the trimming 
head upwards or downwards with gentle pressure.
MINI FOIL SHAVER (Fig.7)
Hold the groomer and allow mini foil shaver gently touches your face.
Use short, well-controlled movements to shave around your beard/moustache. 
Use your free hand to stretch your skin. This encourages the hair to stand 
upright, making it easier to shave.
NOSE AND EAR TRIMMER (Fig.8)
Insert the nose and ear attachment gently into the nostril or ear.
Gently move the groomer in and out of the nostril or ear and at the same time 
rotate the groomer.
IMPORTANT: Avoid inserting the cutting unit more than 6mm into your nostril.
CHARGING THE DEVICE
Before using your groomer for the first time, charge for 2-3 hours, and charge 2 
hours regularly. Ensure the product is switched off. The hair trimmer is complete-
ly handy to carry and can be charged anywhere with the USB cable (Fig.12). First 
insert the plug on the end of the USB charging cable lead into the unit and then 
connect the USB charging cable to the USB interface. This appliance is suitable 
for 5V DC Max 1A charger, computer and other power interface, the charging 
indicator is red when the battery is charging connecting the USB interface, the 
charging indicator is green when the battery is full. IMPORTANT: This product is 
for cord and cordless use. Your groomer cannot be overcharged. However, if the 
product is not going to be used for an extended period time (2-3 months), unplug 
it from the mains and store. Fully recharge your hair clipper when you like to use 
it again. To preserve the life of your batteries, let them run out every 2 months 
then recharge for 2-3 hours again.
MAINTENANCE AND CLEANING
Unplug the product when you do not intend to use it for an extended period of 
time to prolong its shelf-life. Allow the device to cool down prior to storage. 
Separate the tool head from the body and use the cleaning brush (Fig.5) to 
remove dust from the internal parts. Apply a drop of oil (Fig.11) on one of the 
edges of the blades for their maintenance, and turn on the device for a few 
seconds to distribute it. This should be done when you notice a certain amount of 
difficulty during the trimming operation.
Ensure that the device is unplugged prior to cleaning it.
This device may only be cleaned with a damp cloth, and chemical products must 
never be used for the same.
PRODUCT DISPOSAL
REMOVING BATTERY
The appliance must be disconnected from 
the supply mains when removing the 
battery.
Ensure that the clipper is discharged of all power First remove the comb. Then 
remove the blade.
Unscrew the 2 screws in the blade base of the unit. Unscrew the other screw on 
the lower back housing of the clipper. Lift or pry the clipper halves apart, 
exposing the battery.
Cut the metal pieces on both ends of the battery and remove it from the PCB. Pull 
downward the battery set from the unit.
The battery must be removed from the 
appliance before it is scrapped. The battery 
is to be disposed of safety