Zmodo ZS-2004-1TB Manual


Læs gratis den danske manual til Zmodo ZS-2004-1TB (8 sider) i kategorien Overvågningskamera. Denne vejledning er vurderet som hjælpsom af 5 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 3 anmeldelser. Har du et spørgsmål om Zmodo ZS-2004-1TB, eller vil du spørge andre brugere om produktet?

Side 1/8
Make sure that your NVR is powered off and unplugged from the power
source. Using a screwdriver, remove the four screws located on the
bottom panel as shown below.
2
Hard Drive Disk Installation
If your system does not include a pre-installed hard drive (HDD), you can
purchase your own and follow the steps below for installation. Make sure
that you purchase a 3.5" HDD optimized for always-on read/write
1
1
Getting to know your Business Security
System
The Zmodo Business Security System provides a full-featured monitoring
solution to cover your entire business space. The business system includes an
NVR for local storage, HD cameras with cloud storage options, and sPoE
Repeaters to connect the cameras. The sPoE repeater allows you to run one
cable from your router to power on multiple cameras in each zone of your
business. It will also allow for longer cable runs from your NVR.
Network Requirements:
720p cameras: Requires at least 1mbps upload when live viewing or 2mbps
upload when using the Cloud Service for each camera.
1080p cameras: Requires at least 2mbps upload when live viewing or 4mbps
upload when using the Cloud Service for each camera.
In order to optimize bandwidth and the number of ports on your WiFi router,
you may use a network switch, however your sPoE Repeater(s) and NVR must
be connected to the same network.
Smart Business Security System
Quick Start Guide
1
Replace the cover, and fasten the screws into the corresponding holes using
a screwdriver.
3
Your NVR may have encountered an error. Try restarting the NVR. If the
problem still persists, please contact Zmodo Support.
There is no hard drive, or there is a malfunction with your hard drive.
The NVR is recording video to the hard drive.
The NVR is powered on and no IP cameras have been detected.
NVR Status Indicator will let you know the
status of your NVR. Please refer to the chart
for specific details.
Blinking blue
Solid green
Solid red
Blinking red
NVR Status Indicator
2
Slide your HDD until the SATA ports on the NVR and the corresponding ports
on the HDD are properly connected, and the HDD is secure.
2
IP cameras and a hard drive have been detected by the NVR.
Solid blue
Peel the cover from the four rubber pads
(provided) to expose the adhesive backing.
Press firmly onto the bottom panel to cover
the four screws.
4


Produkt Specifikationer

Mærke: Zmodo
Kategori: Overvågningskamera
Model: ZS-2004-1TB

Har du brug for hjælp?

Hvis du har brug for hjælp til Zmodo ZS-2004-1TB stil et spørgsmål nedenfor, og andre brugere vil svare dig




Overvågningskamera Zmodo Manualer

Overvågningskamera Manualer

Nyeste Overvågningskamera Manualer