2N 9159014 Manual


Læs gratis den danske manual til 2N 9159014 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 16 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 8.5 anmeldelser. Har du et spørgsmål om 2N 9159014, eller vil du spørge andre brugere om produktet?

Side 1/2
9159014
2N® 2Wire
Product features
- Using legacy analog 2 wire cabling for IP intercom connection including PoE power
supply
- Saves cost for UTP cabling and makes possible to install IP intercoms on legacy
infrastructure
- Alternatively one master unit can support up to four slaves
- Long range Ethernet extension over 2 wires or coax
- IEEE 802.3 af/at Compliant 40 Watt PoE+ for IP intercom power supply
- Easy configuration, no IP address and network setup required, plug&play
- Calculated MTBF = 340,000 hours
Includes
- 2pcs converter unit with Coax / 2 wire adaptor
- 1pc power supply adaptor
Product use
- Install master unit where your ethernet cable ends and 2 cable wiring begins.
- Plug in Ethernet and 2 cable wiring into 2N® 2Wire.
- Install slave unit where you need convert 2 cable wiring back to Ethernet at
remote location. Please observe polarity, - port of master unit must be
connected to port of slave unit and + port of master unit must be
connected to + port of slave unit.
- Connect provided power supply to master unit.
- Any of the units can be master or slave. Master unit is the one with connected
power supply, while slave is powered via 2 wires
- Blue Power LED indicators should indicate that both units are powered
- Both BNC and PoE green LED should be blinking, thus signalling established
connection and data transmission.
!
Not respecting the polarity can cause
damage or destruction of one or both units.
Ethernet Interface
- Connector Type : RJ45
- Speed : 10/100 Base T, half/full duplex, auto-negotiation
- IEEE 802.3 af/at 40Watt Compliant PoE+
Extended Wiring Interface (2 wire/coax)
- Cable Type : 2Wire, Cat 5e., Cat 6. or Similar
- Impedance : 25Ω to 10
- Transmit Coverage : Typical 720ft (220m) @ Cat6 with PoE at far end; up to
2460ft (750m) possible; depends on wiring and interference
Transmission Method
- Access Method : CSMA/CA and TDMA
- Modulation Method : Windowed OFDM
- Frequency band : 1.8MHz to 30MHz
LED Indicators
- Power : Blue Power ON
- BNC : Green Link ON
- PoE : Green Link ON
AC/DC Power Supply (provided)
- Input AC : 100 ~ 240VAC , 50~60 Hz
- Output DC : 48VDC / 0.84A ~ 1.25A
Dimension of one unit
- 1.57x1.57x2.95in., 40x40x75mm (HxWxL)
- Weight : 4.2oz (120g)
- Material : Extruded Aluminum
Environmental
- Operating Temperature : 14 to 122 (- to +50 °F °F 10°C °C)
- Storage Temperature - to 158 (- to +70: 22°F °F 30°C °C)
EC Declaration of Conformity
Hereby, 2N TELEKOMUNIKACE a.s., declares that the 2N
® 2Wire product is in
compliance with the essential requirements and other relevant provisions of Directive
2004/108/EC. Refer to our website www.2n.cz for the Declaration of conformity.
2N TELEKOMUNIKACE a.s.
Mod řanská 621, 143 01 Praha 4, Czech Republic
www.2n.cz
RU2022 v3


Produkt Specifikationer

Mærke: 2N
Kategori: Ikke kategoriseret
Model: 9159014

Har du brug for hjælp?

Hvis du har brug for hjælp til 2N 9159014 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret 2N Manualer

2N

2N 9159014 Manual

26 Januar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer