ACTi A951 Manual

ACTi Ikke kategoriseret A951

Læs gratis den danske manual til ACTi A951 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 65 personer og har en gennemsnitlig bedømmelse på 3.7 stjerner ud af 33 anmeldelser. Har du et spørgsmål om ACTi A951, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

A951 Outdoor Speed Dome Camera Quick Installation Guide

This guide is for quick installing and connecting A951 Outdoor Speed Dome Camera. For more details, please refer to

the Hardware Manual.

Installation Notices

 This camera must be installed by qualied personnel and the installation should conform to all local codes.

 Do not replace batteries of the camera. Risk of explosion may occur if the battery is replaced by an incorrect type.

 To use an external power supply, please contact the camera manufacturer to conrm that the power supply

complies with the requirements and shares the same power specications with the camera.

 For safety concern, please hook up the camera with the anti-drop chain of the

pendant when installing the camera. For more information about mounting

accessories, please contact Sales.

Camera’s Connectors

No.

Connector

Denition

Remarks

Reset Button

Press the button with a proper tool for at least 20 seconds to restore the system.

RJ- Port 45

For network and UPoE connections

#Please contact the manufacturer for

compatible PoE injector.

Power (AC24V)

AC24V power connection

Alarm I/O

& RS-485 Connector*

Alarm I/O

& RS-485 connection

# Do NOT connect external power supply to

the alarm I/O connector of the camera.

Memory Card Slot

Insert the memory card into the card slot to store videos and snapshots. Do not

remove the memory card when the camera is powered on.

NOTE: It is not recommended to record with the memory card for 24/7 continuously, as it may not be able to

support long term continu s data read/write. Please contact the manufacturer of the memory card for ou

information regarding the reliability and the life expectancy.

Power Connection

To power up the camera, connect the bundled AC24V power adaptor to the power connector of the camera and the

power outlet. Refer to the diagram and pin denition below.

Denition

Terminal Block Label

Power Adaptor Cable

AC24V L

AC2

Blue

GND

Ground

Green-Yellow

AC24V N

AC1

Brown

Alternatively, users can use an Ethernet cable and connect it to the RJ- port of the camera and a UPoE 60W 45

switch.

Ethernet Cable Connection

Connect one end of the Ethernet cable to the - connector of the camera, and the other end of the cable to RJ 45 plug

the network switch or PC.

NOTE: In some cases, Ethernet crossover cable might be needed when connecting the camera directly to the

PC.

NOTE: Check the status of the link indicator and activity indicator LEDs. If the LEDs are unlit, please check

the LAN connection.

Green Link Light indicates good network connection.

Orange Activity Light ashes for network activity indication.

NOTE: The ITE is to be connected only to PoE networks without routing to the outside plant or equivalent

description.

AIarm I/O & -485 Connection RS

Please refer to the diagram and pin denition tables below for audio/alarm I/O & RS- connection. 485

Denition

N/A

Alarm Out B1

Alarm In 4

GND (Alarm I/O and RS-485)

GND (Audio I/O)

Alarm Out B2

Alarm In 3

N/A

Alarm Out A1

RS-485 D+ (Optional)

Alarm In 2

Alarm Out A2

RS-485 D- (Optional)

Alarm In 1

V 210 720 72

Before Login to the Camera

A client program will be automatically installed to the PC when connecting to the camera. Before logging in to the

camera, please ensure downloading the ActiveX control is allowed by either changing the ActiveX controls and

plug-ins or setting Internet s security level to default. For further details, please refer to the Hardware Manual. ’

ActiveX Controls and Plug-ins Settings

Internet Security Level

Step 1: Start the Internet Explorer (IE).

Step 2: Select <Tools> from the main menu of the

browser. T click <Internet Options hen on >.

Step 3: Click the <Security> tab and select on

<Internet>, and click <Custom level> to on

change ActiveX settings.

Step 4: Set ActiveX controls and plug-ins items to “ ”

<Prompt> or <Enable>.

Step 1: Start the IE Internet Explorer (IE).

Step 2: Select <Tools> from the main menu of the

browser. T click <Internet Options hen on >.

Step 3: Click the <Security> t and select on ab

<Internet >.

Step 4: Down the page, click on <Default Level> and

< > to conrm the setting. Close the browser OK

window, and open a new one later for

accessing the IP camera.

NOTE: is strongly recommended using Microsoft Internet Explorer 10.0 or later version to connect the It

camera.

Camera Login

The default IP address of the camera is: 192.168.0.100. Therefore, to access the camera for the rst time, please set

the IP address of the PC as: 192.168.0.XXX; for example:

IP Address: 192.168.0.99

Subnet Mask: 255.255.255.0

 Type in corresponding camera IP address into the URL eld on the web browser and hit "Enter".

 For initial login, use the default username admin: “ ” and then setup the password. Follow the on-screen instructions

to do so. This username and password will be used for succeeding login. Note that the username and password

are case sensitive.

Default Username: admin Password: (user must set up rst)

Install the ActiveX Control

 After connecting to the camera, the request for installing the ActiveX control will appear just below the URL bar.

 Right click on the information bar and click on <Install ActiveX Control > to permit ActiveX control installation. …

 In the pop-up security warning window, click on <Install> to start downloading the software on the PC.

 Click on <Finish> after installation is completed.

Browser-based Viewer

The main page of the IP camera user interface,

as shown.

To activate the wiper, click the <Wiper>

icon located on the function buttons of the

<Home> page.

A951

Outdoor Speed Dome Camera

Quick Installation Guide

Produkt Specifikationer

Mærke:	ACTi
Kategori:	Ikke kategoriseret
Model:	A951
Kode for international beskyttelse (IP):	IP66
Type:	IP-sikkerhedskamera
Vekselstrømsindgangsspænding:	24 V
Højde:	431 mm
Vægt:	8900 g
Produktfarve:	Hvid
Kompatible hukommelseskort:	MicroSDHC, MicroSDXC
Wi-Fi:	Ingen
Bluetooth:	Ingen
Formfaktor:	Kuppel
Relativ luftfugtighed ved drift (H-H):	10 - 90 %
Ethernet LAN-porte (RJ-45):	1
Ethernet LAN:	Ja
Understøttede lydformater:	AAC, PCM
Driftstemperatur (T-T):	-40 - 60 °C
Maksimal opløsning:	3840 x 2160 pixel
Husmateriale:	Metal, Plastic
Understøttede grafikopløsninger:	1280 x 720 (HD 720), 3840 x 2160
Forbindelsesteknologi:	Ledningsført
Certificering:	CE, FCC
Strømforbrug (maks.):	55 W
Netværksstandarder:	IEEE 802.1x
Understøttede netværksprotokoller:	IPv4/v6, TCP, UDP, DHCP, PPPoE, HTTP, HTTPS, DNS, DDNS, NTP, RTP, RTSP, SMTP, FTP, IGMP, ICMP, ARP, UPnP, QoS, SNMP, IEEE 802.1X
Servicekvalitet support (QoS):	Ja
IP-adresse filtrering:	Ja
Strømkilde type:	AC, PoE
Monteringstype:	Loft/væg
Diameter:	284 mm
Indbygget kortlæser:	Ja
Indbygget HDD:	Ingen
Video komprimeringsformater:	H.264, H.265, M-JPEG
Understøttet placering:	Udendørs
Sensortype:	CMOS
Billedstabilisator:	Ja
Samlet antal megapixels:	8 MP
Støjreduktion:	Ja
Lydsystem:	2-vejs
Optisk zoom:	31 x
Autofokus:	Ja
Hældningsvinkelområde:	-10 - 100 °
Progressiv scanning:	Ja
Voice codecs:	G.711, G.726
Bredt dynamikområde (WDR):	Ja
Dag/nat funktion:	Ja
Infrarød (IR) cut-off filter:	Ja
Vandafvisende:	Ja
Kamerapanorering kontrol:	Ja
Kontrol af kamerahældning:	Ja
Minimumsbelysning:	0.02 Lux
Panoreringsområde:	0 - 360 °
Antal sensorer:	1
Optisk sensorstørrelse:	1/1.8 "
Antal effektive pixels (HxV):	3864 x 2180 pixel
Zoom kapacitet:	Ja
Maksimale blænderåbning tal:	1.55
Nattesyn:	Ja
LED type:	IR
Billedhastighed:	30 fps
Justering af billedkvalitet:	Brightness, Contrast, Sharpness
Fortrolighedspolitik maskering:	Ja
Tekst billedtekst overlay:	Ja
Ethernet-grænsefladetype:	Gigabit Ethernet
Bevægelsessensor (video):	Ja
HTTPS -kryptering:	Ja
Antal kameraer:	1
Brændviddeområde:	6.5 - 202 mm
Kameraets lukkerhastighed:	1-1/10000 sek./side
Kamera lukker type:	Elektronisk
Videostreaming:	Ja
Antal linser:	1
Beskyttelse af adgangskode:	Ja
PTZ-kontrol:	Ja
Hældningshastighed:	300 grader i sekundet
Nattesyn, afstand:	100 m
Intelligent Video Surveillance (IVS) systemfunktioner:	Ansigtsgenkendelse
Advarsel notifikationstype:	E-mail
Forudindstillede punkter:	Ja
Adgangskodebeskyttelse type:	Bruger
Strømforbrug (Power over Ethernet (PoE)):	51 W
Objektivets synsvinkel, vandret:	63.4 °
Objektivets synsvinkel, lodret:	37.8 °
Justering af lukkertid:	Automatisk
Forudindstillet hastighed:	300 grader i sekundet
Støjreduktionsteknologi:	3D støjreduktion
PTZ-tilstande:	Automatisk scanning