2
WARNINGS & SAFETY INFORMATION
• Perform a thorough check of the board before use; do not use the board if it is damaged.
• Always wear a lifejacket (personal oatation device).
• Do not use the board in adverse conditions.
• Do not take sharp objects onto the board.
• Take care of sharp objects, such as coral and debris below the surface and on the bank.
• Do not tow the board with a watercraft.
• Do not over inate or under inate the board.
• If a puncture or leak occurs, return to the shore immediately.
• Do not use the board if you cannot swim.
• Never use the board alone.
• Do not use in white-water.
• Do not use in the presence of strong winds or currents.
• Do not use the board in waves higher than 0.3m.
• This board is not intended to be used by children under the age of 14. In addition to this,
adults with reduced physical or mental capabilities, or those who are under the inuence of
drugs or alcohol should not use the board.
• No more than one person should be on the board at a time.
• Do not exceed a distance greater than 150m from land.
• The maximum weight rating of the inated board is 150kg.
• It is your responsibility to follow relevant local, state and federal regulations. These
regulations may include but are not limited to: lifejackets and other safety equipment; use
of channels; and right of way when passing other vessels. This will assist in ensuring your
safety and avoiding nes.
SET-UP:
1. Remove the board roll from
the Bag and lay it on a at
surface with ample room.
2. Connect the n.
3. Connect the air pump and
inate to 15PSI (103KPA).
Air pump not included. The pump’s gauge will not
show a reading until the board is under pressure and
partially inated.
4. Disconnect the air pump and
lock the valve in the closed
position.
PACK-UP:
1. Dry the board and place it on a
at surface.
2. Push in the valve and turn to
lock in the open position.
3. Remove the n.
4. Once the board is deated,
start rolling the board from the
nose, pushing the remaining air
out.
5. Pack the bag into the included
carry bag.
THE MAXIMUM AIR PRESSURE FOR THIS PRODUCT IS 18PSI (124KPA),
OVER-INFLATING THE BOARD WILL VOID WARRANTY AND CAN
RESULT IN DAMAGE TO BOTH THE USER AND THE BOARD.
