Filter assembly and disassembly
Parts
Hold the handle to
lift up the machine
Hanging wire function
You can hang the wire
for storage
Rod assembly storage
function
here for storage to
save space
Handle
Blowing function
Clips
Dust shaking function
Turn off the power,
press the dust removing
button at the bottom,
then release it quickly.
The button will go back
to its original position.
Operate it repeatedly
to shake off dust.
To connect the hose, move
the locker to the left
side and insert the hose
connector into the
suction mouth. Then,
release the locker to
make it tightly locked.
Conversely, to separate it.
Move the locker to the right side,
insert the hose connector into the
blowing mouth, then release the
locker to make it tightly locked. Move
the blowing control bar to the left for
blowing function on and to the right
for blowing function off.
Pull out the clips to open,
conversely, to lock it.
Take out the dust removing board
Twist the knob counterclockwi
se,
then take out the dust removing
board
Replace the HEPA filter
Twist the HEPA
clockwise to take it off
Install the HEPA and Dust removing board
Twist the HEPA counterclockwise to
lock, then pull out the dust
removing board. Tighten the knob.
Pull out the filter
Troubleshooting
If you still can not solve the problem, take it to a service center, not repair by yourself.
Reasons
Vacuum
is not
working
1. The plug is not inserted tightly and
correctly.
2. The socket is switched off.
1. Insert the plug into the socket
tightly
2. Ensure that the socket is
switched on
Suction
is weak
1. The hose or tube is blocked
2. The filter is blocked
3. The machine is not fastened tightly
4. The air-out filter is blocked
5. The adjust window in the hose is
open
1. Clean up all the obstructions
in the hose or tube or filter
2. Clean or replace the filter
3. Make sure that the adjust
window is closed
1. The filters are blocked
2. The hose, rod or accessories are
blocked
1. Clean and maintain the filter
2. Get rid of all obstructions
ON / OFF switch
"O" for power turn off
" " for power turn on
Hose
Pull out the machine head
Pull out the clips to pull out
the machine head
Abnormally
loud noise
Put the rod assembly
