AMX RDM-2DC Manual

AMX Lysdæmper RDM-2DC

Læs gratis den danske manual til AMX RDM-2DC (1 sider) i kategorien Lysdæmper. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om AMX RDM-2DC, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

Installation Guide

RDM-2DC Dual DC Dimmer Module 1920W, 0-10 VDC (x2)

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).

7/08

AMX reserves the right to alter specifications without notice at any time.

3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com

93-606-61 REV: A

The RDM-2DC Dual DC Module (FG606-61) is a 1920 W module used for the

dimming of fluorescent ballast loads. It uses a 0 to 10 VDC current sinking for

use with four-wire ballasts. It is designed for use with the RDA series of

enclosures, in an AMX Lighting™ modular digital dimming system. The module’s

120 and 277 VAC ratings are CE, UL, and C-UL approved.

RDM-2DC UL and C-UL Ratings

• 120 VAC, 50/60 Hz, 1920 W

• 277 VAC, 50/60 Hz, 1920 W

• Control Out: 50 mA, 12 VDC sinking

Suggested Dimmed Loads

• Four-wire dimmable ballasts, like Advance Transformer Mark VII™ or the

Energy Savings SuperDim™ series

Specifications

• Dimensions (HW): 10" x 2.75" (25.4 cm x 6.99 cm)

• Non-phase dependant

• Use wires rated at 75°C (167°F)

• Torque terminals to 20 in-lbs. (2.3 N/M)

• Max. wire size: 10 AWG (4 mm²)

• Wire stripping length: 0.28" (7 mm)

• Weight: 2.6 lbs. (1.180 kg)

• BTU/hr: 150

• Control current: 125 mA @ 12 VDC per control port

Caution: Pre-Installation Notes

• All Class 1 wiring must be connected to proper terminals.

• All control wiring must be connected to proper terminals.

• Disconnect power while installing or connecting the unit.

• Keep top and bottom air vents clear at all times.

• Use low-voltage wires with a 300 volt rating or greater.

• Use field installed copper conductors.

• All electrical ratings are for continuous duty.

• For indoor use only.

• Test loads for shorts before connecting.

• This module may require extra power from the AXlink connection or an

external power supply connected to the control card.

Connecting the RDM-2DC to the AMX Lighting Master

Lighting Application Drawings

Warning: Failure to ground the ballast may cause ballast failure

FIG. 1 RDM-2DC

Low-voltage control

wiring: 4-pin

Relay

+ out (LV)

- out (LV)

Line in

Load out

High

Low-voltage

voltage

connector to AMX

Lighting master

controller

Mounting

points

+ out (LV)

- out (LV)

Line in

Load

High

Low

voltage

Relay

voltage

Fuses

out

FIG. 2

Connecting the RDM-2DC and AMX Lighting Master

FIG. 3 RDM-2DC application wiring

Pin 4 (GND)

Pin 3 (RLY)

Pin 2 (DIM)

Pin 1 (+12 V)

RDM-2DC 4-pin module connector

1 (+)

2 (DIM)

3 (-)

GND

4-pin plug from RDM series module

Note: The 4-pin plugs from the module connector to the 4-pin

connector on the master (black plug cover facing up).

Ballast

Florescent

Neutral

Line in (HOT)

Load

Neutral

Circuit breaker

panel

Ballast

The fuses protect the dimming

circuit from a low impedance load.

• The fuse will blow if it were

incorrectly wired

• Catastrophic ballast failure

• Reversing switched and

dimmed circuits

• Reversing dimmed and

line circuits.

The dimmed output must be

connected to a high impedance

load.

Produkt Specifikationer

Mærke:	AMX
Kategori:	Lysdæmper
Model:	RDM-2DC
Type:	Lysdæmper
Bredde:	69.9 mm
Højde:	254 mm
Vægt:	1040 g
Kontroltype:	Ikke tilgængelig
Boks design:	Monterbar

Har du brug for hjælp?

Hvis du har brug for hjælp til AMX RDM-2DC stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Lysdæmper AMX Manualer

AMX CCD-15APS-1 Manual

15 September 2025

14 September 2025

14 September 2025

27 August 2024

27 August 2024

27 August 2024

AMX CCD-RS-277 Manual

27 August 2024

AMX RDM-2INC Manual

27 August 2024

Lysdæmper Manualer

Nyeste Lysdæmper Manualer

Lutron Caseta P-BDG-PKG1W Manual

7 Oktober 2025

Grässlin trim 300 Manual

27 September 2025

Grässlin trim 200 Manual

26 September 2025

EtiamPro LQC4D-V1 Manual

30 August 2025

Vimar 09134.CM Manual

27 August 2025

Vimar 20134.B Manual

26 August 2025

Vimar 01550.1 Manual

26 August 2025

Vimar 09134 Manual

26 August 2025

Mueller 873010 Manual

18 August 2025

Renkforce RS2W Mini Manual

15 August 2025