AMX RDM-3DC Manual

AMX Lysdæmper RDM-3DC

Læs gratis den danske manual til AMX RDM-3DC (1 sider) i kategorien Lysdæmper. Denne vejledning er vurderet som hjælpsom af 14 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 7.5 anmeldelser. Har du et spørgsmål om AMX RDM-3DC, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

Installation Guide

RDM-3DC Triple DC Dimmer Module 1920W, 0-10 VDC (x3)

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).

7/08

AMX reserves the right to alter specifications without notice at any time.

3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com

93-606-62 REV: A

The RDM-3DC Triple DC Module (FG606-62) is a 1920 W module used for the

dimming of fluorescent ballast loads. It uses a 0 to 10 VDC current sinking for

use with four-wire ballasts. It is designed for use with the RDA series of

enclosures, in an AMX Lighting™ modular digital dimming system. The module’s

120 and 277 VAC ratings are CE, UL, and C-UL approved.

RDM-3DC UL and C-UL Ratings

• 120 VAC, 50/60 Hz, 1920 W

• 277 VAC, 50/60 Hz, 1920 W

• Control Out: 50 mA, 12 VDC sinking

Suggested Dimmed Loads

• Four-wire dimmable ballasts, like Advance Transformer Mark VII™ or the

Energy Savings SuperDim™ series

Specifications

• Dimensions (HW): 10" x 2.75" (25.4 cm x 6.99 cm)

• Non-phase dependant

• Use wires rated at 75°C (167°F)

• Torque terminals to 20 in-lbs. (2.3 N/M)

• Max. wire size: 10 AWG (4 mm²)

• Wire stripping length: 0.28" (7 mm)

• Weight: 2.9 lbs. (1.315 kg)

• BTU/hr: 150

• Control current: 125 mA @ 12 VDC per control port

Caution: Pre-Installation Notes

• All Class 1 wiring must be connected to proper terminals.

• All control wiring must be connected to proper terminals.

• Disconnect power while installing or connecting the unit.

• Keep top and bottom air vents clear at all times.

• Use low-voltage wires with a 300 volt rating or greater.

• Use field installed copper conductors.

• All electrical ratings are for continuous duty.

• For indoor use only.

• Test loads for shorts before connecting.

• This module may require extra power from the AXlink connection or an

external power supply connected to the control card.

Connecting the RDM-3DC to the AMX Lighting Master

Lighting Application Drawings

Warning: Failure to ground the ballast may cause ballast failure

FIG. 1 RDM-3DC

Low-voltage control

wiring: 4-pin

Relay

+ out (LV)

- out (LV)

Line in

Load out

High

Low-voltage

voltage

connector to AMX

Lighting master

controller

Mounting

points

+ out (LV)

- out (LV)

Line in

Load

Low

Relay

voltage

High

voltage

+ out (LV)

- out (LV)

Line in

Load

Low

voltage

High

voltage

Fuses

Relay

out

FIG. 2

Connecting the RDM-3DC and AMX Lighting Master

FIG. 3 RDM-3DC application wiring

Pin 4 (GND)

Pin 3 (RLY)

Pin 2 (DIM)

Pin 1 (+12 V)

RDM-3DC 4-pin module connector

1 (+)

2 (DIM)

3 (-)

GND

4-pin plug from RDM series module

Note: The 4-pin plugs from the module connector to the 4-pin

connector on the master (black plug cover facing up).

Ballast

Florescent

Neutral

Line in (HOT)

Load

Neutral

Circuit breaker

panel

Ballast

The fuses protect the dimming

circuit from a low impedance load.

• The fuse will blow if it were

incorrectly wired

• Catastrophic ballast failure

• Reversing switched and

dimmed circuits

• Reversing dimmed and

line circuits.

The dimmed output must be

connected to a high impedance

load.

Produkt Specifikationer

Mærke:	AMX
Kategori:	Lysdæmper
Model:	RDM-3DC
Type:	Lysdæmper
Bredde:	69.9 mm
Højde:	254 mm
Vægt:	1040 g
Kontroltype:	Ikke tilgængelig
Boks design:	Monterbar

Har du brug for hjælp?

Hvis du har brug for hjælp til AMX RDM-3DC stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Lysdæmper AMX Manualer

AMX CCD-15APS-1 Manual

15 September 2025

14 September 2025

14 September 2025

27 August 2024

27 August 2024

27 August 2024

AMX CCD-RS-277 Manual

27 August 2024

AMX RDM-2INC Manual

27 August 2024

Lysdæmper Manualer

Nyeste Lysdæmper Manualer

Legrand HCL453PMMW Manual

15 December 2025

Legrand RH703PTC Manual

11 December 2025

Legrand LSCL453P Manual

9 December 2025

Legrand RH703PTUW Manual

9 December 2025

Legrand RHL153P Manual

9 December 2025

Crestron CM2-DIMUEX Manual

3 December 2025

RADEMACHER DuoFern 9476-1 Manual

17 November 2025

Theben DMG 2 T KNX Manual

9 November 2025

Lutron Caseta P-BDG-PKG1W Manual

7 Oktober 2025

Grässlin trim 300 Manual

27 September 2025