APC Back-UPS Pro BR1500MS2 Manual

APC UPS Back-UPS Pro BR1500MS2

Læs gratis den danske manual til APC Back-UPS Pro BR1500MS2 (12 sider) i kategorien UPS. Denne vejledning er vurderet som hjælpsom af 10 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 5.5 anmeldelser. Har du et spørgsmål om APC Back-UPS Pro BR1500MS2, eller vil du spørge andre brugere om produktet?

Side 1/12
Important Safety Instructions
Inspect the package contents upon receipt. Notify the carrier and
dealer if there is any damage.
SAVE THESE INSTRUCTIONS - This section contains important
instructions that should be followed during installation and maintenance of
the UPS and batteries.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
This UPS is intended for indoor use only.
Do not operate this UPS in direct sunlight, in contact with fluids, or
where there is excessive dust or humidity.
Be sure the air vents on the UPS are not blocked. Allow adequate
space for proper ventilation.
Connect the UPS power cable directly to a wall outlet.
Failure to follow these instructions will result in death or serious
injury.
CAUTION
RISK OF HYDROGEN SULPHIDE GAS AND EXCESSIVE SMOKE
Replace the battery at least every 5 years or at the end of its service
life, whichever is earlier.
Replace the battery immediately when the UPS indicates battery
replacement is necessary.
Replace batteries with the same number and type of batteries as
originally installed in the equipment.
Replace the battery immediately when the UPS indicates a battery
over-temperature condition, or when there is evidence of electrolyte
leakage. Power off the UPS, unplug it from the AC input, and
disconnect the batteries. Do not operate the UPS until the batteries
have been replaced.
Failure to follow these instructions could result in minor or
moderate injury and equipment damage.
User Manual Back-UPS Pro
BR1500MS2
Back-UPS Pro BR1500MS22
Inventory
Connect the Battery
The UPS is shipped with the battery disconnected.
Coaxial Cable
USB communication cable
Lay the UPS with the battery door facing up.
The arrows point to the locking tabs of the
battery compartment.
Press the tabs downwards and pull the
battery door away from the unit to access
the battery modules.
Using the handles on both sides of the
battery, lift the battery 30 degrees upward to
expose the battery connector. Connect the red
wire as shown above.
Push the battery into the unit.
Replace the battery door.
bu476a
bu471a
bu472a
bu473a
bu474a
b
u
4
7
5
a


Produkt Specifikationer

Mærke: APC
Kategori: UPS
Model: Back-UPS Pro BR1500MS2

Har du brug for hjælp?

Hvis du har brug for hjælp til APC Back-UPS Pro BR1500MS2 stil et spørgsmål nedenfor, og andre brugere vil svare dig