APC Smart-UPS SRT011 Manual
Læs gratis den danske manual til APC Smart-UPS SRT011 (10 sider) i kategorien UPS. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 7 anmeldelser. Har du et spørgsmål om APC Smart-UPS SRT011, eller vil du spørge andre brugere om produktet?
Side 1/10
Installation Guide Smart-UPS™On-Line
SRT011/SRT012
Important Safety Information
Read the instructions carefully to become familiar with the equipment before trying to install, operate,
service or maintain it. The following special messages may appear throughout this manual or on the
equipment to warn of potential hazards or to call attention to information that clarifies or simplifies a
procedure.
The addition of this symbol to a Danger or Warning safety label indicates that an electrical hazard
exists which will result in personal injury if the instructions are not followed.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey
all safety messages that follow this symbol to avoid possible injury or death.
Safety and General Information
Inspect the package contents upon receipt. Notify the carrier and dealer if there is any
damage.
Adhere to all local and national electrical codes.
Recycle the packaging.
Deenergizing safety
The UPS contains internal batteries and may present a shock hazard even when disconnected from the
branch circuit (mains). Before installing or servicing the equipment, check that the internal batteries are
removed, that external extended run batteries are disconnected and the branch circuit (mains) is
disconnected.
CAUTION
CAUTION indicates a potentially hazardous situation which, if not avoided, can result in minor or
moderate injury.
NOTICE
NOTICE used to address practices not related to physical injury. The safety alert symbol is not
used with this signal word.
Smart-UPS On-Line SRT011/SRT0122
Hardwire safety
• Verify that all branch circuit (mains) and low voltage (control) circuits are deenergized, and locked out
before installing cables or making connections, whether in the junction box or to the UPS.
• Wiring by a qualified electrician is required.
• Adhere to all national and local codes.
• Select wire size and connectors according to national and local codes.
• Strain relief is required for all hardwiring.
• All openings allowing access to UPS hardwiring terminals must be covered. Failure to do so may
result in personal injury or equipment damage.
Produkt Specifikationer
| Mærke: | APC |
| Kategori: | UPS |
| Model: | Smart-UPS SRT011 |
Har du brug for hjælp?
Hvis du har brug for hjælp til APC Smart-UPS SRT011 stil et spørgsmål nedenfor, og andre brugere vil svare dig
UPS APC Manualer
14 Januar 2025
14 Januar 2025
14 Januar 2025
14 Januar 2025
14 Januar 2025
1 Januar 2025
29 December 2024
11 December 2024
11 December 2024
12 Oktober 2024
UPS Manualer
- Vanson
- SurgeX
- Liebert
- LC-Power
- Voltcraft
- AEG
- Tripp Lite
- Avocent
- Block
- V7
- PowerWalker
- Furman
- Maruson
- JUNG
- Murr Elektronik
Nyeste UPS Manualer
30 Januar 2025
9 Januar 2025
31 December 2025
31 December 2025
30 December 2025
30 December 2025
28 December 2024
28 December 2024
28 December 2024
14 December 2024