APC SMT3000I Manual

APC UPS SMT3000I

Læs gratis den danske manual til APC SMT3000I (5 sider) i kategorien UPS. Denne vejledning er vurderet som hjælpsom af 39 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 20 anmeldelser. Har du et spørgsmål om APC SMT3000I, eller vil du spørge andre brugere om produktet?

Side 1/5
Installation Guide SMT 2200/3000 VA
Input/Output Hardwire Kit
Safety
Adhere to all national and local electrical codes. A certified electrician must perform all electrical
connections.
1. Disconnect equipment connected to the UPS.
2. Press the OFF button located on the front of the UPS.
3. Disconnect the batteries in the UPS.
4. Disconnect the UPS from utility power.
NOTE: When removing the panels from the UPS, note which cable is connected to the AC input. There are two
4-pin connectors on the UPS and they are not interchangeable.
Inventory
Note: The illustrations in this document may differ slightly from the actual hardware.
Terminal block
Terminal block label
2 screws secure the
terminal block to the UPS
4 grounding screws 8 screws
secure input, output, and
blank panels to the UPS
2 wire nuts
Input panel
Output panel
Blank panel
Hardwire Kit SMT2200/3000 VA 100/120/230 VAC Tower2
Installation
Note: It is recommended that the input and output cables be connected to the terminal block prior to
installing the terminal block in the UPS.
Remove the five screws that secure the factory
installed PDU panels to the UPS.
Save the screws.
Disconnect the PDU input and output cables as
shown in the diagram.
Secure the replacement input and output panels
(supplied), to the UPS. Secure the panels with
four of the screws removed from the factory
installed PDU panel.
Install appropriate strain relief clamps (not
supplied), to the input and output panels as
shown in the diagram.
su0669b
A
C Input Connector
su0670a


Produkt Specifikationer

Mærke: APC
Kategori: UPS
Model: SMT3000I

Har du brug for hjælp?

Hvis du har brug for hjælp til APC SMT3000I stil et spørgsmål nedenfor, og andre brugere vil svare dig