ART SP4X4 Manual

ART Ikke kategoriseret SP4X4

Læs gratis den danske manual til ART SP4X4 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 19 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 10 anmeldelser. Har du et spørgsmål om ART SP4X4, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

4x4 POWER DISTRIBUTION UNIT

Operation Manual

PB 4X4 (

FRONT

)

SP 4X4 (

FRONT

)

PS 4x4 (

FRONT

)

BACK (

ALL UNITS

)

INTRODUCTION

We congratulate you on choosing an ART 4x4 Power Distribution Unit. You will find that they have been designed for

easy use. The latest advances in power technology have been utilized in the design of these units. Please read all

instructions carefully before operating.

All 4X4 Models (Power Base, Smart Power and Power Station) Feature:

• Front-Mounted Circuit Breaker Reset Switch

• Surge & Spike Protection

• EMI & RFI Filtering

• Unique “4X” Distribution on the Back- Four of the Eight Rear Switched Outputs are wider for Wall Wart Devices

• Total Power Capacity of 1800 watts

• Rugged All-Steel Chassis Occupies 1u Rack Space

Smart Power (SP) adds:

• 2 Front Shock-Mounted Light Posts

• Backlit Linear Meter to Monitor Input Voltage

• Separate On/Off Light Switch

• Adjustable Dimmer Dial

Power Station (PS) has all SP features, and adds:

• Backlit Ammeter to Monitor Load Current

The 4x4 POWER DISTRIBUTION UNITs protect your delicate electronic equipment with a high voltage varistor (MOV)

surge and transient suppressor. The fast-acting suppression circuit responds in less than a nanosecond, clamping

transient voltages to safe levels.

OPERATION

MAXIMUM LOAD

The eight circuit breaker protected outlets are rated at 15 amps, which is equivalent to 1800 watts at 120 volts. If the

total load on the 4x4 POWER DISTRIBUTION UNIT’s outlets (and rack lights on the SP & PS) exceed 15 amps, the

circuit breaker will trip, cutting off power to your rack. If this happens, reduce the load by unplugging one or more units

from the 4X4 POWER DISTRIBUTION UNIT. Then push the circuit breaker button in to reset it.

LAMPS (SP & PS)

The 4x4 POWER DISTRIBUTION UNIT’s lamps pull out easily and may be aimed to provide the best illumination for your equipment.

Each lamp is supplied with a 7-watt night light bulb. Replacements are readily available at most hardware stores, or wherever

household light bulbs are sold. Adjust the DIMMER control for the desired brightness. The lights do not turn off automatically when

the tubes are pushed in, so be sure to switch the RACK LIGHTS switch to the OFF position before pushing in the tubes.

CAUTION-BURN WARNING: The caps and light tubes become hot during normal operation. Avoid burning your fingers by allowing the cap to cool

completely before unscrewing it. Do not push the tubes in while the caps are unscrewed. If you find that the heat from the tubes is excessive, reduce the

setting of the Dimmer control, or substitute a 4-Watt bulb.

BULB REPLACEMENT (SP & PS)

Bulbs are easily replaced without removing the unit from the rack. Simply unscrew the cap on the end of each light tube,

remove the old bulb and replace.