Auralex Roominators Project 2 Manual

Auralex Ikke kategoriseret Roominators Project 2

Læs gratis den danske manual til Auralex Roominators Project 2 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 56 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 28.5 anmeldelser. Har du et spørgsmål om Auralex Roominators Project 2, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

A. Using Tubetak™, mount two (2) LENRD Bass Traps in each vertical

corner. We suggest you install the LENRDs starting at the

ceiling. However, we understand that not all corners are the

same. At the very least, place LENRDs in the upper most

section of the vertical corners. If you have doors, windows

or other obstacles blocking your corners, it is acceptable to

place them in the horizontal, wall/ceiling corners.

B. Using Tubetak, mount Studiofoam panels

on the front wall, between and behind the

neareld monitors. The graphic below shows eight

(8) panels across the front wall. The pattern in your

room does not have to be identical, but placement

across this wall is strongly encouraged.

Auralex Project Roominators Kit

Congratulations! You now have a higher quality listening environment.

The is designed to reduce uncontrolled ambience in smaller home and project Auralex ProjectRoominators Kit

studios. Proper placement of the panels and Studiofoam™ LENRD™ Bass Traps will insure greater clarity in your

listening environment. By following these simple instructions, you’ll end up with the best room you’ve never “heard.”

Includes:

8 - LENRD™ Bass Traps

24 - 2’ x 2’ Studiofoam™ panels

5 - TubeTak™ Adhesives

Roominators Project General Guidelines

For superior acoustics, Auralex suggests mounting LENRD™ Bass

Traps in the corners of your room (for low frequency control) as well

as 2’x2’ Studiofoam™ panels for absorption on the walls and ceiling.

If your room is set up with a mix position against one wall (as many

rooms are), please use the following general guidelines:

D. Mount the remaining panels on the ceiling,

focusing between the mix position and the

nearfield monitors. The graphic illustrates one

possible pattern for Studiofoam on the ceiling.

Other General Suggestions

 When treating the front and side walls, try using a mirror to ascertain where

reections are coming from. Simply have a friend move a mirror around the

walls and ceiling while you are sitting at the mix position. Anywhere you can see

your studio monitors in the reection is a likely surface to treat with an Auralex

Studiofoam panel!

 Do not worry about placing treatments very low on the walls—use them at ear

level and on the ceiling for best results. The number of panels and placement on

each surface can vary given your specic situation.

 Remember that these are only guidelines. If you have furniture or gear in the way,

simply work around it as best you can. Auralex acoustic control products are very

forgiving. Placement on the walls is not an exact science. Just having LENRDs

and Studiofoam in the room will improve your mixing or recording environment. Other, less permanent methods, such as Velcro™,

nails, pins, screws, etc. can be used to mount the LENRDs or Studiofoam panels for easy removal later.

 We highly recommend isolating your monitors with Auralex MoPADs. Even greater performance can be obtained by adding Auralex

diffusors or a GRAMMA amp/sub isolation riser.

This Starter Kit is designed to be the rst step towards better acoustics. You may wish to continue to maximize your sound with products

such as our T’Fusor 3D Sound Diffusors or portable products such as our MAX-Wall™ Mobile Acoustical Environment.

Thank you for purchasing the Auralex Project Roominators™ Kit!

Mount a total of 12 Studiofoam panels on the side walls - six

(6) on the left and six (6) on the right is encouraged, but

not mandatory. Around the mix position, you might want

to try using the “mirror” method to place panels (see

below). Note that in the illustration, two (2) panels

have been mounted to the door and can be seen

better in the illustration for step D.

Check out the Auralex Catalog or go to Auralex.com for details on all the great Auralex sound control products!

Produkt Specifikationer

Mærke:	Auralex
Kategori:	Ikke kategoriseret
Model:	Roominators Project 2

Har du brug for hjælp?

Hvis du har brug for hjælp til Auralex Roominators Project 2 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Auralex Manualer

Auralex Roominators Alpha-DST Manual

31 August 2024

Auralex Roominators Deluxe Plus Manual

31 August 2024

Auralex SubDude-II Manual

31 August 2024

Auralex Roominators Project 2 Manual

31 August 2024

Auralex SubDude-HT Manual

31 August 2024

Auralex ProGO 44 Manual

31 August 2024

Auralex Roominators D 36-DST Manual

31 August 2024

Auralex Roominators D108L-DST Manual

31 August 2024

Auralex MoPAD-XL Manual

31 August 2024

Auralex Roominators Pro Plus Manual

31 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

IMC Networks 232CL9R Manual

14 September 2025

Varta Speed Charger 57955 Manual

14 September 2025

Melissa & Doug 9336 Manual

14 September 2025

Opus dataPREDATOR Manual

13 September 2025

Varta Wireless Power Bank 20000 57909 Manual

13 September 2025

Daewoo AVS1369 Manual

13 September 2025

SolarEdge SE120K-RW08IBNQ4 Manual

13 September 2025

Varta Fast Wireless Charger 57912 Manual

13 September 2025

Hauppauge Colossus Manual

13 September 2025

Contour Wireless Unimouse Manual

13 September 2025