AXESS AXDI-FD1 Manual

AXESS Ikke kategoriseret AXDI-FD1

Læs gratis den danske manual til AXESS AXDI-FD1 (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 30 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 15.5 anmeldelser. Har du et spørgsmål om AXESS AXDI-FD1, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

AXDI-FD1

I N S T A L L A T I O N I N S T R U C T I O N S

Product Info

INTERFACE FEATURES

INTERFACE COMPONENTS

TOOLS & INSTALLATION ACCESSORIES REQUIRED

• Crimping tool and connectors, or solder gun,

solder, and heat shrink • Tape • Wire cutter

• Zip ties

TABLE OF CONTENTS

Connections ............................................................2

Installation .............................................................3

Programming .........................................................3

Ford CAN Data Interface 2007-Up

APPLICATIONS

• Provides accessory power (12-volt 10-amp)

• Retains R.A.P. (retained accessory power)

• Provides NAV outputs (parking brake, reverse, speed sense)

• Pre-wired AXSWC harness (AXSWC sold separately)

• Can be used in both non-ampliﬁed and ampliﬁed models

(including Sony/THX)

• Retains balance and fade (excluding Sony/THX)

• Micro-B USB updatable

Ford

Econoline (w/ CD) 2009-Up

Edge 2007-2010

Escape 2008-2012

Expedition 2007-2014

Explorer (with NAV) 2009-2010

Explorer Sport Trac (with NAV) 2009-2010

F-150 * 2009-2012

F-150 STX/FX2 base/XLT base 2013

F-150 STX/XLT base 2014

Ford (Cont)

F-250/350/450/550 2011-2012

F-250/350/450/550 XLT, XL (w/ CD) 2013-2016

F-650/750 (w/ CD) 2016-Up

Focus 2008-2011

Fusion 2010-2012

Mustang 2009-2014

Taurus 2010-2012

Lincoln

MKX 2007-2010

MKZ 2007-2009

Navigator 2007-2014

Mazda

Tribute 2008-2011

Mercury

Mariner 2008-2011

Milan 2010-2011

• AXDI-FD1 interface • AXDI-FD1 harness

• 8-pin sub/center harness

* XL models must be equipped with a CD player

CONNECTIONS

From the AXDI-FD1 harness to the aftermarket radio:

• Connect the wire to the ground wire.Black

• Connect the Yellow wire to the battery wire.

• Connect the wire to the accessory wire.Red

• Connect the wire to the power antenna wire.Blue

• For models equipped with a Sony/THX ampliﬁer only: Blue/White Connect the wire from

the 12-pin connector to the amp turn on wire. This wire must be connected to hear sound

from the factory ampliﬁer.

• For the Ford Expedition only: Connect the Blue/White wire from the 24-pin connector to the

amp turn on wire, if applicable. This wire must be connected to hear sound from the factory

ampliﬁer, if applicable.

Only connect if a wire is populated on the factory side.Note:

• If the aftermarket radio has an illumination wire, connect the wire to it.Orange

• Connect the wire to the right front positive speaker output.Gray

• Connect the Gray/Black wire to the right front negative speaker output.

• Connect the wire to the left front positive speaker output.White

• Connect the wire to the left front negative speaker output.White/Black

• Connect the wire to the left rear positive speaker output.Green

• Connect the wire to the left rear negative speaker output.Green/Black

• Connect the wire to the right rear positive speaker output.Purple

• Connect the wire to the right rear negative speaker output.Purple/Black

The following (3) wires are only for multimedia/navigation radios that require these wires.

• Connect the wire to the VSS/speed sense wire.Blue/Pink

• Connect the wire to the reverse wire.Green/Purple

• Connect the wire to the parking brake wire.Light Green

12-pin pre-wired AXSWC harness:

• This harness is to be used along with the optional AXSWC (not included) to retain steering

wheel audio controls. If the AXSWC is not being used, disregard this harness. If it will be

used, please refer to the AXSWC instructions for radio connections and programming.

If the vehicle is not equipped with Bluetooth/Sync, cut the Note: Gray/Red wire and tape it off.

Disregard the harness that comes with the AXSWC.Note:

From the 8-pin sub/center harness to the aftermarket radio:

• Connect the (2) wires to the amp turn on wire. These wires must be connected Blue/White

to hear sound from the factory ampliﬁer, if applicable.

• If the vehicle is equipped with a factory subwoofer, connect the RCA jack to the White

subwoofer out jack.

• If the vehicle is equipped with a SONY/THX ampliﬁer, connect the RCA jack to the center Red

channel out jack on the aftermarket radio/processor.

If this jack is not present on the aftermarket radio, just leave be. Only the center Note:

channel speaker will be lost.

Produkt Specifikationer

Mærke:	AXESS
Kategori:	Ikke kategoriseret
Model:	AXDI-FD1

Har du brug for hjælp?

Hvis du har brug for hjælp til AXESS AXDI-FD1 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret AXESS Manualer

AXESS AXBUCH-MZ6V Manual

29 Juli 2025

AXESS AXABH-CH3 Manual

29 Juli 2025

AXESS AXDSPX-HK5 Manual

25 Februar 2025

AXESS AXAMP-CH8 Manual

25 Februar 2025

AXESS AXTC-MZ1 Manual

25 Februar 2025

AXESS AXBUCH-TYCAM26V Manual

25 Februar 2025

AXESS AXAMP-FD2 Manual

25 Februar 2025

AXESS AXBUCH-TYCAM36V Manual

25 Februar 2025

AXESS AXAMP-TY1 Manual

25 Februar 2025

AXESS AXAMP-TY4 Manual

25 Februar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Advantech MIC-711-OX Manual

30 Juli 2025

Intellinet 713108 Manual

30 Juli 2025

Electro Harmonix EU12AC-1000 Manual

30 Juli 2025

Advantech PCIE-1753 Manual

30 Juli 2025

MXR Rockman X100 Manual

30 Juli 2025

MIPRO MI-909R Manual

30 Juli 2025

Advantech AMAX-4870 Manual

30 Juli 2025

Advantech IDK-1112P-50XGA2 Manual

30 Juli 2025

MIPRO MP-820 Manual

30 Juli 2025

Advantech ARES-12290 Manual

30 Juli 2025