AXESS AXLOC-CH3 Manual

AXESS Ikke kategoriseret AXLOC-CH3

Læs gratis den danske manual til AXESS AXLOC-CH3 (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 56 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 28.5 anmeldelser. Har du et spørgsmål om AXESS AXLOC-CH3, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

AXLOC-CH3

I N S TA L L AT I O N I N S T R U C T I O N S

ATTENTION: With the key out of the ignition,

disconnect the negative battery terminal

before installing this product. Ensure that all

installation connections, especially the air

bag indicator lights, are plugged in before

reconnecting the battery or cycling the

ignition to test this product.

NOTE: Refer also to the instructions included

with the aftermarket accessory before

installing this device.

TOOLS REQUIRED

• Crimping tool and connectors, or solder gun,

solder, and heat shrink

• Tape • Wire cutter • Zip-ties

TABLE OF CONTENTS

Applications.............................................................1

Installation ............................................................. 2

Diagram .................................................................. 3

Chrysler LOC (Line Output Converter)

AXLOC-CH3

(for Non-Ampliﬁed Vehicles)

2011-2020

APPLICATIONS

Chrysler

300/300C 2011-2014

Dodge

Charger 2011-2014

Journey 2011-2020

Visit AxxessInterfaces.com for more detailed information about the product and up-to-date

vehicle speciﬁc applications

KIT COMPONENTS

• AXLOC-CH3 Wiring Harness

• Gain Controller

• 12v-500mA Remote Wire

• Auxiliary Cable

For dash disassembly instructions, refer to metraonline.com. Enter the year, make, and model of the vehicle in the Vehicle Fit Guide Radio Install Kits for .

• Designed to provide (2) channels of low-level audio output from the factory system.

• Allows for the installation of an ampliﬁer for speakers or subwoofers.

• Gain Controller included to adjust the overall output.

• 12v-500mA remote wire activated with signal sense.

• 55-watts per channel.

• Designed for non-ampliﬁed vehicles.

Note: A single pole double throw (SPDT) relay is recommended when installing multiple ampliﬁers.