B-Tech BT881 Manual

B-Tech Vægophæng BT881

Læs gratis den danske manual til B-Tech BT881 (32 sider) i kategorien Vægophæng. Denne vejledning er vurderet som hjælpsom af 24 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 12.5 anmeldelser. Har du et spørgsmål om B-Tech BT881, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/32

This Pack Contains 1 Mount

www.btechavmounts.com

Crosshead

screwdriver

Drill 8mm (5/16") masonry bit

or 5mm (3/16") wood bit

Pencil Stud finder

(optional)

Installation Safety Notes.....................................................................................................................2

Parts List.............................................................................................................................................4

Installation Instructions.......................................................................................................................6

Product Dimensions..........................................................................................................................14

B-Tech Contact Details.....................................................................................................................16

13mm (1/2") &

10mm (2/5")

spanner or socket

● Suitable for projectors up to 10kg (22lbs)

● Mounts projector only 115mm (4.5") from ceiling or 280mm (11")

with supplied extension rod

● +/-90º tilt adjustment, +/-90º roll adjustment and 360º swivel

● Easy to adjust and fix projector in position

● Steel safety wire for extra security

● Maximum distance between any two fixing points

on projector: 340mm (13.4")

● Suitable for projectors with M2.5, M3, M4, M5 and M6 fixings

● Simple installation with all mounting hardware included

REG. DESIGN NO: 3016251

CAUTION: This ceiling mount is intended

for use only with the maximum weights indicated.

Use with projectors heavier than the maximum

indicated may result in instability causing possible injury.

Do not attempt to install this product until all instructions and warnings have been read and properly

understood. Please keep these instructions for future reference.

B-Tech International Limited, its distributors and dealers are not liable or responsible for damage or

injury caused by improper installation, improper use or failure to observe these safety instructions. In

such cases, all guarantees will expire.

General

B-Tech International Ltd recommends that a professional AV installer or other suitably qualified

person install this product. Great care must always be taken during installation as most AV equipment

is of a fragile nature, possibly heavy and easily damaged if dropped.

If you do not fully understand the instructions or are not sure how to install this product safely, then

please consult a professional for advice and/or to install this product for you. Failure to mount this

product correctly may cause serious injury or death both during installation and at any time thereafter.

Do not mount any AV equipment that exceeds the specific weight limit of the product you are

installing. This weight limit will be clearly stated on each product and its packaging and will vary from

product to product.

Product location

Please pay careful attention to where this product is located. Some ceilings are not suitable for

installation.

If located in a public or frequently populated area ensure that the product is out of the immediate

reach of people. If any AV equipment is to be suspended over the likely path or location of people

then great care should be taken to secure all parts of the installation from falling.

When drilling holes in ceilings it is essential to avoid contact with electrical cables and water or gas

pipes contained within. Use of a good quality live wire detector and hidden object locator is therefore

recommended. Only drill into structures when you are sure it is safe to do so.

Fixing hardware

It is highly recommended that all wall fixing screws be used where supplied and that the purpose of all

other fixing hardware is fully understood. In some cases more AV equipment fixing hardware will be

supplied to accommodate different models of equipment and set up configurations.

The installer must be satisfied that any supplied fixing hardware is suitable for each specific

installation. If any fixing screws or included hardware are deemed not sufficient for a safe installation

then please consult a professional or your local hardware store.

Hazard limitation

When routing cables take advantage of any built in cable management features that the product might

provide and ensure that all cables are tidy and secure. Check to see that any moving aspect of the

product can do so unhindered by any cabling.

Some products have moving parts and the potential to cause injury through the crushing or trapping of

fingers or other body parts.

Particular attention to the nature of moving parts is required especially when assembling installing and

adjusting during set up.

Immediately after installations double-check that the work done is safe and secure. Double-check all

necessary fixings are present and are of ample tightness.

It is recommended that periodic inspections of the product and its fixing points are made as frequently

as possible to ensure that safety is maintained. If in doubt consult a professional AV installer or other

suitably qualified person.

Produkt Specifikationer

Mærke:	B-Tech
Kategori:	Vægophæng
Model:	BT881
Bredde:	340 mm
Dybde:	340 mm
Højde:	280 mm
Produktfarve:	Sort
Monteringstype:	Loft
Hældningsvinkelområde:	-90 - 90 °
Produkter pr. hovedkasse (udvendigt):	8 stk
Rotationsvinkel:	90 °
Ydre emballage nettovægt:	14000 g
Maksimal vægtkapacitet:	10 kg
Drejelig vinkel:	360 °