Bauknecht GSIP 40 Power IN Manual

Bauknecht Opvaskemaskine GSIP 40 Power IN

Læs gratis den danske manual til Bauknecht GSIP 40 Power IN (8 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 33 personer og har en gennemsnitlig bedømmelse på 4.1 stjerner ud af 17 anmeldelser. Har du et spørgsmål om Bauknecht GSIP 40 Power IN, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

5019 496 01046

GB GSIP 40 POWER

Before using the dishwasher, read the

installation and maintenance instructions carefully!

1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads, extra functions,

sensor settings (only with sensor programmes), water supply temperatures, water hardness and power supply voltage.

2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories: for more detailed information on the EN comparison test and

other tests, contact the following address: “nk_customer@whirlpool.com”.

3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with. Standard NF EN 13697 - November 2001.

1. OVERVIEW

Programme selector

START button

The indicator lights up during operation, ﬂashes when a fault

occurs, and goes off at the end of the programme.

START button RESET function:

Press this button for at least 2 seconds; the selected programme

and options are cancelled. Main failure displays (repeated flashing

of the START indicator lamp) can be cancelled by RESETTING.

Detailed instructions are given in chapter 5 “What to do, in the

event of...”.

Rinse aid level indicator and salt level indicator

They light up when rinse aid or salt need to be added.

Add just before starting a wash cycle.

Fault indication and wash time display

In normal operation it indicates the remaining time (h:mm),

whereas with “Delayed start” selected it indicates the time

remaining until programme start (hh).

If “F..” appears on the display, see chapter 5 “What to do, in the

event of.

“Delayed start” button

Press the button (repeatedly) to delay the start of the programme.

Adjustable from 1 to 24 hours. With each press of the button, the

delayed start indicator increases by one hour and after 24 restarts

from 00. Then press the START button. The dishwasher will start

after the set time.

Detergent setting upon initial use and when using a different type of detergent

1. Select the third programme in the relative table.

2. Press the START button for approx. 7 sec. to change the display.

3. Using the START button, select the desired detergent:

Display shows: 2 -1 = 2 in 1, 3 -1 = 3 in 1, 4 -1 = other combined action

detergents (in this way, the rinse aid and/or salt indicator is deactivated).

Display shows OFF = Powder detergent (factory setting).

(rinse aid level and salt level indicator activated).

4. Switch the appliance off and then switch it on again. The selected detergent

type will be indicated on the display for approx. 3 seconds .

Half Load/Multizone button

Load the upper or lower rack only.

Press once = wash upper rack (the indicator/symbol lights up)

Press twice = wash lower rack (the indicator/symbol lights up)

Press 3 times = Off (Half load/Multizone deactivated).

When washing without the upper rack, press the “Half load” (i.e.

“wash lower rack”) button twice (the corresponding indicator/

symbol lights up).

Power Clean

An additional spray level offers better cleaning result and more

flexibility of dish loading in the lower rack.

On / Off button

Table 1.1.

Table of programmes Detergent

dispenser Consumption 1)

PProgrammes Selectable

extra

functions Loading instructions large kWhsmall Litres Minutes

1Auto Sensor 50-65°C Recommended programme for daily use,

with dry food residuals (e.g. EN 50242). X X 11-16 1.10-1.50 100-130 ±1)

2Pre-rinse cold Crockery to be washed later. — — 4.0 0.03 14 ± 1)

3Rapid 40°C Slightly soiled crockery, without dry

residuals. X — 10.0 0.65 30 ± 1)

4Eco 2) 50°C Normally soiled crockery. Energy-saving

programme with prolonged drying. X X 14.0 1.05 195 ±1)

5Hygienic + 3)

Normally - heavily soiled crockery, with

additional antibacterial wash. An

interruption of the programme (e.g. due to

door opening) can compromise elimination

of germs.

X X 13.0 1.50 115 ±1)

6Intensive 70°C Recommended programme for very dirty

dishes, particularly suitable for pots and

pans. X X 14.0 1.55 155 ± 1)

2. QUICK REFERENCE GUIDE

Detailed instructions are given on the following pages; also see section “5. What to do, in case of...”

1. Switch on the

appliance Press the ON/OFF button.

2. Select a programme Press the button “Select programme” or the programme selector to display the

selected programme. If required, select possible options.

3. Select the type of

detergent The detergent selection procedure varies depending on the dishwasher model.

Chapter “1. Overview” provides instructions for selecting detergent type.

4. Fill in the detergent 4a. Powder/gel/tabs

Fill the detergent dispenser compartments in

accordance with the wash programme selected.

Large compartment A for every wash cycle, additional

small compartment B for programmes with pre-wash

(see table 1.1.).

4b. Combined action detergents (2 in 1/3 in 1/... etc.)

Place the detergent in compartment A or in the cutlery

basket, as per the manufacturer's recommendations.

5. Check the rinse aid

level

6. Check the salt level Depending on the model:

7. Load the racks

Make sure that the spray arms can turn freely and are not impeded by crockery

or cutlery in the racks.

Detailed instructions on loading the racks are given in chapter “3. How to use

the appliance”, under “How to load the racks”.

8. Open the water tap

and close the door

9. Start the appliance Press the START button.

Wash cycle

If the appliance is switched off during a

wash cycle, when switched on again it will

resume the cycle from where it was

interrupted. Care must be taken when

opening the door, as steam will escape!

10.End of programme The START indicator lamp switches off at the end of the programme.

11.Switch off the

appliance Press the OFF button. All the indicator lamps switch off.

12.Turn oﬀ the water

tap, unload the racks

Unload the appliance, starting from the lower rack in order to avoid any

residual drips of water falling onto crockery below.

Visual indicator in dispenser C

dark ➯sufficient rinse aid present,

clear ➯add rinse aid (approx. 100 ml).

The indicator lamp on the control panel lights up when rinse aid

needs to be added. Not all models are equipped with such an

indicator.

window in salt reservoir cap on bottom of appliance inside

orange ➯when sufficient salt is present,

clear ➯when salt needs to be added.

The indicator lamp on the control panel lights up when salt needs

to be added. Even once salt has been added, the indicator lamp

only switches off after several wash cycles!

Changing the programme

in progress:

- Keep the START button pressed

for about 2 seconds until the

START indicator goes off.

- (Water drains for up to 60

seconds).

- Select the programme again.

- Press the Start button.

Produkt Specifikationer

Mærke:	Bauknecht
Kategori:	Opvaskemaskine
Model:	GSIP 40 Power IN

Har du brug for hjælp?

Hvis du har brug for hjælp til Bauknecht GSIP 40 Power IN stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Opvaskemaskine Bauknecht Manualer

Bauknecht BK6IC11BS7LSA0CH Manual

15 Juli 2025

Bauknecht BK8IA15AM3TUSC0CH Manual

15 Juli 2025

Bauknecht BK4PC11BS7A0 Manual

29 Juni 2025

Bauknecht BK41C11BS7LA0 Manual

29 Juni 2025

Bauknecht OBFC Ecosilent 9760 Manual

28 Juni 2025

Bauknecht OBIC Ecosilent 9760 Manual

28 Juni 2025

Bauknecht B8KI HP42 LCA Manual

27 Juni 2025

Bauknecht BK6IB10BS7LAO Manual

27 Juni 2025

Bauknecht BK6UB10BS7A0X Manual

26 Februar 2025

Bauknecht BK6IB10BS7LA0 Manual

26 Februar 2025

Opvaskemaskine Manualer

Nyeste Opvaskemaskine Manualer

Frigidaire FDSH4502BF Manual

29 Juli 2025

Siemens iQ300 SN43HS11TE Manual

28 Juli 2025

Blaupunkt 5VS401AU Manual

28 Juli 2025

Whirlpool WDT751SAPZ Manual

28 Juli 2025

GE GDF540HSFSS Manual

28 Juli 2025

Neff S255HTX00E Manual

28 Juli 2025

Neff S287HDX01A Manual

28 Juli 2025

Blaupunkt 5VF421AU Manual

28 Juli 2025

GE PDT760SSFSS Profile Manual

28 Juli 2025

GE GDWF460VSS Manual

28 Juli 2025