Bauknecht GSIP 6198 Manual


Læs gratis den danske manual til Bauknecht GSIP 6198 (4 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 32 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 16.5 anmeldelser. Har du et spørgsmål om Bauknecht GSIP 6198, eller vil du spørge andre brugere om produktet?

Side 1/4
5019 496 90425
GB
GSIP 6198 Quick Reference Guide
Before using the dishwasher, read the user instructions!
(We reserve the right to make technical modifications)
Add regeneration salt
Only add regeneration salt immediately before
starting a wash programme.
Add rinse aid
Time and failure display3)
Indicates in hours the time remaining until the start of
the wash cycle. Switches off at programme start and
indicates the remaining time in hours and minutes.
“F....” Information for the After-Sales Service
“Delayed start” button
The wash cycle can be programmed to start after 1 -
24 hours. With each successive touch of the button,
the delayed start indicator increases by 1 hour, and
after 24 returns to 00. Then press the Start button.
The dishwasher will start at the set time.
“Half load - Multizone” button
Load the upper or lower rack only.
This function can be used with any programme.
Press once = upper rack (the indication lamp/
symbol comes on)
Press twice = lower rack (the indication lamp/
symbol comes on)
Press 3 times = Off (half load function deactivated).
When washing without the top rack, press the “Half
Load” button twice, or “Lower rack wash” (the
corresponding LED/symbol comes on).
Antibacterial rinse 4)
This function adds an antibacterial rinse at the end of
the wash cycle, thereby guaranteeing a perfectly
clean and sanitized load. The lamp will light up when
the function is activated. If the temperature is not
maintained during the antibacterial cycle (e.g. if the
door is opened and remains open for a long time),
the lamp will start blinking to indicate that sanitation
is not guaranteed.
1) Reference programme for energy label EN 50242
(Liter = 13.0, kWh = 1.05, Min. = 145);
2) Refer to “User instructions”;
3) Program data obtained in conformity with European standard
EN 50242. Values may vary in relation to usage, e.g.: different
loads, water temperatures - above or below 15°C - as well as water
hardness and power supply voltage, etc.
4) The bacteria removal efficiency has been tested by the Institut
Pasteur de Lille (France), based on the NF EN 13697 standard
of November 2001.
5) These programmes can be used with the Antibacterial rinse
option.
Programme selection button
On / Off button
Start button
Switches “onwhen the dishwasher is operating.
Flashes when a fault occurs. Switches off at the
end of the programme.
Indicators
Options
Programme chart Detergent2) Consumption 3)
Programmes Loading instructions A B Litres kWh Minutes
Sensor + 1) 5) 40-70°C Lightly, normally or heavily soiled
crockery, including pots and pans. X X 7.0-17.0 0.99-1.58 90-162
Pre-Rinse cold Crockery to be washed later. - - 4.0 0.03 14
Glass 40°C Light soiling, for example glasses
and cups. X - 10.0 0.80 55
Rapid 30 min 40°C Lightly soiled crockery with no
dried-on food. X - 10.0 0.65 30
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool.com.
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Press the ON / OFF button.
Compartment A:
With each wash cycle.
Compartment B:
For programmes with pre-wash only.
Mechanical indicator lamp C.
Electric indicator on control panel (if provided).
On models with water softener
system only.
Mechanical indicator lamp D. Electric
indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Select the desired programme (using the specific button or knob).
The corresponding indicator lamp lights up.
If necessary (and if provided).
The corresponding indicator lamp lights up.
The selected programme is
then memorised (even in the
event of power failure).
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.
Only after the START button has switched off: Press the ON / OFF button.
All the indicator lamps switch off.
Warning: When the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
Switch on the appliance
Fill the detergent dispenser
A B C
Check the rinse aid level
Check the
regeneration salt level
Load the racks
Close the dishwasher door,
turn on the water tap
Select a programme
Select additional options
Press the Start button
“Change programme in progress”
Press the START button for 2 sec. until the
Start indicator lamp switches off.
Select another programme and press the
START button again.
Wash cycle
Switch off the appliance
Turn off the water tap,
unload the racks


Produkt Specifikationer

Mærke: Bauknecht
Kategori: Opvaskemaskine
Model: GSIP 6198

Har du brug for hjælp?

Hvis du har brug for hjælp til Bauknecht GSIP 6198 stil et spørgsmål nedenfor, og andre brugere vil svare dig