Berner SLC07-1036AA Manual

Berner Ikke kategoriseret SLC07-1036AA

Læs gratis den danske manual til Berner SLC07-1036AA (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 16 personer og har en gennemsnitlig bedømmelse på 3.6 stjerner ud af 8.5 anmeldelser. Har du et spørgsmål om Berner SLC07-1036AA, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

-1-

READ AND SAVE

THESE INSTRUCTIONS

No. II-480

Date September, 2016

Installation & Maintenance Instructions

TABLE OF CONTENTS

I. UNCRATING............................................................................................................................................................. 2

II. MOUNTING INSTRUCTIONS................................................................................................................................ 2

III. WALL MOUNTING................................................................................................................................................ 2

IV. SUSPENDED MOUNTING.................................................................................................................................... 3

V. ELECTRICAL CONNECTIONS .............................................................................................................................. 3

VI. MECHANICAL CONNECTIONS .......................................................................................................................... 5

VII. AIRFLOW ADJUSTMENTS ................................................................................................................................. 5

VIII. MAINTENANCE AND CLEANING .................................................................................................................... 6

IX. SERVICE ................................................................................................................................................................ 6

X. TROUBLESHOOTING ............................................................................................................................................ 7

XI. WARRANTY .......................................................................................................................................................... 8

IMPORTANT INSTRUCTIONS

WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

A. Read all instructions before installing or using this air curtain.

B. Use this unit only in the manner intended by the manufacturer and described in this manual. Any other use not recommended by the manufacturer may cause re, electric shock,

or injury to persons. If you have any questions, contact the manufacturer.

C. Before servicing or cleaning unit, switch power o at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the

service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

D. Installation work and electrical wiring must be done by qualied person(s) in accordance with all applicable national and local codes having jurisdiction, including re-rated

construction. See page 3, ELECTRICAL CONNECTIONS (NEC Code ANSI/NFPA No. 70).

E. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.

F. To reduce the risk of re, do not store or use gasoline or other ammable vapors and liquids in the vicinity of the air curtain.

G. This air curtain is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, etc. and

curtains at least 1 inch from the top, back, front, sides and at least 6 feet from the discharge of the air curtain.

H. Extreme caution is necessary when any air curtain is used by or near children or invalids, and whenever the heater is left operating unattended.

I. Do not operate any air curtain after it malfunctions. Disconnect power at the service panel and have the air curtain inspected by a reputable electrician before reusing.

J. To disconnect the air curtain, turn controls to “o”, and turn o power to the air curtain circuit at main disconnect panel.

K. Do not insert or allow foreign objects to enter any ventilation or discharge opening as this may cause an electric shock or re, or damage the air curtain.

L. To prevent a possible re, do not block the air intake or discharge of the air curtain in any manner.

M. The air curtain has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or ammable vapors or liquids are used or stored.

N. This heater may include an audible or visual alarm to warn that parts of the heater are getting excessively hot. If the alarm sounds (or illuminates), immediately turn the heater

o and inspect for any objects on or adjacent to the heater that may have blocked the airow or otherwise caused high temperatures to have occurred.

DO NOT OPERATE THE HEATER WITH THE ALARM SOUNDING (OR ILLUMINATING).

Saving energy and creating healthy, comfortable environments

SANITATION

CERTIFIED

Low Prole 7

AIR CURTAIN SERIES SLC07

COMMERCIAL

Low Prole 8

AIR CURTAIN SERIES CLC08

ANSI/NSF 37

Air Curtain Fans

for Customer Entry

max.mounting

height is 7’

SLC07

for outdoor use

SLC07

-2-

I. UNCRATING THE AIR CURTAIN UNIT

Carefully examine the carton(s) for damage before opening. If the carton

is damaged, immediately notify the shipping company. If the unit(s)

were shipped on wooden skids, remove protective wood and banding

straps securing the carton(s) to the skid. Open the carton(s) and remove

all protective packaging. Remove the plastic cover housing by lifting

vertically. Remove and discard four (4) nuts and washers holding the mo-

tor/blower section to the bottom of the carton. Remove motor/blower

section from the carton.

CAUTION: ONLY LIFT THE UNIT BY GRASPING INLET RINGS ON THE

BLOWER HOUSING WITHOUT TOUCHING BLOWER WHEELS.

Immediately verify that the electrical rating nameplate located on the

cover matches electrical power supply available. Retain the shipping

carton(s) until the unit(s) are installed and properly operating.

ACCESSORIES: If the unit(s) were ordered with optional electrical acces-

sories (door switch, control panel, etc.), the accessories may be found in

the carton containing the unit or in a separate carton(s) accompanying

the unit(s). Check all of the cartons/skids for accessories before discard-

ing.

II. MOUNTING INSTRUCTIONS (General)

The Certied Low Prole 7/Commercial Low Prole 8 air curtain

is designed to be an eective barrier against cold drafts in the

winter and hot air in the summer, ying insects and airborne

contaminants. To achieve optimum protection, the unit should

be mounted on the inside of the building, ush to the wall and as

close to the top of the door opening as possible. To ensure peak

performance, keep air stream free of obstructions.

The air curtain will not perform properly if negative air pres-

sure exists in the building. Under these conditions, a means

for make-up air to the building must be provided so that the

air pressure on both sides of the opening is in balance.

Before mounting the unit, check the supporting structure to verify

that it has sucient load-carrying capacity to support the weight

of the unit(s). The mounting hardware (supplied by others) should

be capable of supporting a minimum of three (3) times the weight

of the unit. See TABLE 1.

A. When determining the mounting location for the unit(s), make

sure that nothing interferes with the curtain of air developed

when the discharge vanes are directed from 0° to 20° toward

the door opening. If the air stream strikes any obstruction

(the top edge of the doorway, a door opening device, etc.),

the eectiveness of the unit will be greatly reduced.

See FIGURE 1.

B. For optimum performance, the bottom of the unit (discharge

nozzle) should be no more than 1” above the top of the door

opening with the unit mounted ush to the wall. If the unit

must be mounted higher, it must be from the wall spaced out

3/8” for every inch the unit is above the door opening. Any

void between the air curtain and the wall should be sealed

along the full length of the unit. See FIGURE 2.

C. Proceed to: Section III-WALL MOUNTING or

Section IV-SUSPENDED MOUNTING

FIGURE 1 - Air Stream

TABLE 1 - Weight Chart

FIGURE 2 - Positioning of Air Curtain

6' minimum*

20˚

AIR

Discharge

Nozzle

INTERIOREXTERIOR

1” minimum

side clearance from

combustible materials.

*Electrically Heated Units Only

Flush Mounting

1" max.

AIR

CURTAIN

Top of Doorway

2" 3"

AIR

CURTAIN

Spacer

Seal

3/8"

3/4"

MODEL

Net Weight (lbs)

SLC07

Ambient

CLC08

Ambient

CLC08

Electric

CLC08

St/Hw

Produkt Specifikationer

Mærke:	Berner
Kategori:	Ikke kategoriseret
Model:	SLC07-1036AA

Har du brug for hjælp?

Hvis du har brug for hjælp til Berner SLC07-1036AA stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Berner Manualer

Berner DTU03-1018EA Manual

15 August 2024

Berner SLC07-1036AA Manual

14 August 2024

Berner SLC07-2108AA Manual

13 August 2024

Berner SLC07-2084AA Manual

13 August 2024

Berner DTU03-1018AA Manual

11 August 2024

Berner SLC07-1048AA Manual

11 August 2024

Berner SLC07-1072AA Manual

10 August 2024

Berner SHD07-1036AA Manual

10 August 2024

Berner SLC07-1042AA Manual

10 August 2024

Berner SLC07-2096AA Manual

9 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Sony RM-V202T Manual

15 Juni 2025

Hughes & Kettner Attax Metroverb Manual

15 Juni 2025

Kohler K-10124 Manual

15 Juni 2025

Planet Audio P9900CPA Manual

15 Juni 2025

Levenhuk LabZZ SP20 Manual

15 Juni 2025

Planet Audio P62CP Manual

15 Juni 2025

Cranborne Audio Carnaby 500 Manual

15 Juni 2025

Audio-Technica AT-VM740xML/H Manual

15 Juni 2025

Stamos SWG-WC-3D Manual

15 Juni 2025

Planet Audio P350MB Manual

15 Juni 2025