DAYBLAZER 1500™
USB Rechargeable Front Light
Part# 7134750
The light indicator will blink when charging.
When charging is complete the light indicator with flash green.
GREEN = 100% to 75% Battery Capacity
ORANGE = 75% to 25% Battery Capacity
RED = <25% Battery Capacity
When battery capacity is 25-35 minutes or less, red indicator light will
remain on constant until light reaches 0% or turns off in the selected mode.
MAKE SURE TO FULLY CHARGE LIGHT BEFORE FIRST USE
1. Push button to power on.
2. Click to cycle modes.
3. Hold down 1 second to power off.
Light powers back on in the last mode used.
Ask your retailer for full warranty policy or visit www.blackburndesign.com/warranty
Visit us at blackburndesign.com for product updates
Potential choking hazard to children. This light is extremely WARNINGS:
bright—do not aim directly into eyes. UK ONLY: When used for cycling, this light
should be used in conjunction with a British Standard 6102/3 cycle light.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between
the equipment and receiver. • Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Shielded
interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules. Specications and designs are subject to change without any notice
or obligation on the part of the manufacturer.
