Bleep Labs Sensory Coupler Manual

Bleep Labs Ikke kategoriseret Sensory Coupler

Læs gratis den danske manual til Bleep Labs Sensory Coupler (17 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 19 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 10 anmeldelser. Har du et spørgsmål om Bleep Labs Sensory Coupler, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/17
The Bleep Labs Sensory Coupler
In the kit:
The Sensory Coupler. 6hp 60mA at standard LED brightness,
180mA fully bright. 12V, 5mA -12V, no 5V.
Phototransistor sensor board
Hall (magnetic) sensor board
Accelerometer sensor board
120 cm long TRS cable
12 cm long bendy TRS cable
25mm alligator clip cable for touch sensor
Donut magnet for hall sensor
All i/o is buffered and protected. Touch sensor is also protected.
The input is TRS and intended only for sensors but you can make
your own. Pinout:
Tip - 3.3V supply
Ring - 0 to 3.3V sensor input
Sleeve - ground.
DIY sensor guide
Getting started
Calibrating reads the high and low value of the sensor readings
and maps them to the full 0-10V output.
Press CAL and give the sensor a full range of input. The LED
next to the CAL button will blink and the LED strip will show a
red indicator of the current sensor value. When a new value that
is higher than the current high level is received, a white light will
blink at the top of the strip. For a new low value the bottom of the
strip will blink.
For example when using the touch sensor press calibrate and
move away from the module at least a foot. Then touch the
contact as hard as you would wille using the device.
For a light sensor, cover it and then shine a light on it.
Press calibrate again to go back to normal operation.
Calibration data is saved when the device turns off and is reset
when something is plugged into or removed from the sensor
jack.
Hold CAL to clear the calibration data. The light next to CAL will
turn off to show that the device is in raw input mode.

Produkt Specifikationer

Mærke: Bleep Labs
Kategori: Ikke kategoriseret
Model: Sensory Coupler

Har du brug for hjælp?

Hvis du har brug for hjælp til Bleep Labs Sensory Coupler stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Bleep Labs Manualer

Bleep Labs

Bleep Labs Sensory Coupler Manual

18 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Playtive

Playtive IAN 102385 Manual

16 Juni 2025
Playtive

Playtive IAN 89045 Manual

16 Juni 2025
AMX

AMX HPA-MYT-TX Manual

16 Juni 2025
Playtive

Playtive IAN 293611 Manual

16 Juni 2025
Playtive

Playtive IAN 321239 Manual

16 Juni 2025
XO

XO D34PROBF Manual

16 Juni 2025
Playtive

Playtive IAN 107436 Manual

16 Juni 2025
Zodiac

Zodiac Hydroxinator iQ Manual

16 Juni 2025
Zempire

Zempire Deluxe 2 Manual

16 Juni 2025
Playtive

Playtive HG02891 Manual

16 Juni 2025