Broan EC60KIT Manual

Broan Ventilator EC60KIT

Læs gratis den danske manual til Broan EC60KIT (8 sider) i kategorien Ventilator. Denne vejledning er vurderet som hjælpsom af 5 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 3 anmeldelser. Har du et spørgsmål om Broan EC60KIT, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

MODEL EC60KIT

Page 1

WARNING

CAUTION

BATH FAN UPGRADE KIT

R E A D A N D SAV E T H E S E I N ST RU C T I O N S

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR

INJURY TO PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer.

If you have questions, contact the manufacturer.

2. Before servicing or cleaning unit, switch power off at service

panel. Lock or tag service panel to prevent power from being

switched on accidentally.

3. Installation work and electrical wiring (including switch location)

must be done by a qualified person(s) in accordance with

all applicable codes and standards, including fire-rated

construction codes and standards.

4. Provide sufficient air for proper combustion and exhausting of

gases through the flue (chimney) of fuel burning equipment

to prevent backdrafting. Follow the combustion equipment

standards such as those published by the National Fire

Protection Association (NFPA), the American Society for

Heating, Refrigeration and Air Conditioning Engineers

(ASHRAE), and local codes.

5. This product may have sharp edges. Be careful to avoid cuts

and abrasions during installation and cleaning.

6. When cutting or drilling into wall or ceiling, do not damage

electrical wiring and other hidden utilities.

7. Ducted fans must always be vented to the outdoors.

8. Not for use in kitchens.

9. Acceptable for use over a bathtub or shower when installed

in a GFCI protected branch circuit.

10. This unit must be grounded.

11. This unit must be installed into fan housings that are marked

with the series number 690, 695, 696, EC, or VSBP5 . Other

fan housings cannot be substituted.

12. When local regulations include more restrictive installation

and/or certification requirements, those requirements

supersede the requirements of this document and the installer

agrees to conform to them at his own expense.

13. When installing, servicing or cleaning this unit, wear safety

glasses and gloves.

1. For general ventilating use only. Do not use to exhaust

hazardous or explosive materials and vapors.

2. Install fan at least five feet (1.52 m) above floor.

3. To avoid motor bearing damage and noisy, unbalanced

impellers, keep drywall spray, construction dust, etc. off

motor and impeller.

4. Read specification label on product for information and

requirements.

online at www.broan.ca

WARRANTY

OPERATION

• For quiet and efficient operation, long life, and attractive

appearance – lower or remove grille and vacuum interior of

fan with a dusting brush attachment.

• The motor is permanently lubricated and never needs oil-

ing. If the motor bearings make excessive or unusual noise,

replace the motor with the exact service motor. The impeller

should also be replaced.

• To remove blower assembly - See step 3 on page 2.

Use an on/off switch, timer, or speed control to operate this ventilator.

CLEANING & MAINTENANCE

BROAN-NUTONE CANADA INC.

ONE YEAR LIMITED WARRANTY

Broan-NuTone Canada warrants to the original consumer purchaser

of its products that such products will be free from defects in materials

or workmanship for a period of one (1) year from the date of original

purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR

IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES

OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

During this one year period, Broan-NuTone Canada will, at its option,

repair or replace, without charge, any product or part which is found to

be defective under normal use and service.

THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP

STARTERS OR TUBES, BULBS OR BATTERIES, FILTERS, DUST,

ROOF CAPS, WALL CAPS AND OTHER ACCESSORIES FOR

DUCTING. This warranty does not cover (a) normal maintenance

and service or (b) any products or parts which have been subject to

misuse, negligence, accident, improper maintenance or repair (other

than by Broan-NuTone Canada or an authorized representative), faulty

installation or installation contrary to recommended installation instructions.

The duration of an implied warranty is limited to the one year period as

specified for the express warranty.

BROAN-NUTONE CANADA’S OBLIGATION TO REPAIR OR

REPLACE, AT BROAN-NUTONE CANADA’S OPTION, SHALL BE

THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS

WARRANTY. BROAN-NUTONE CANADA SHALL NOT BE LIABLE

FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES

ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR

PERFORMANCE. This warranty supersedes all prior warranties.

To qualify for warranty service, you must (a) notify Broan-NuTone Canada

at the address or telephone number stated below, (b) give the model

number and part identification and (c) describe the nature of any defect

in the product or part. At the time of requesting warranty service, you

must present evidence of the original purchase date.

IF YOU NEED ASSISTANCE OR SERVICE:

For the location of your nearest Broan-NuTone Canada Inc. dealer:

Dial Toll Free: 1-888-882-7626

Please be prepared to provide:

• Product model number • Date and proof of purchase

• The nature of the difficulty

Broan-NuTone Canada Inc. 1140 Tristar Drive,

Mississauga, Ontario L5T 1H9

Released Oct. 2011

MODEL EC60KIT

Page 2

INSTALLATION

GRILLE

1. Disconnect the electrical power supply

and lock out the service panel for the

existing fan.

2. Remove grille from the existing fan.

Pull grille down to expose two springs. Squeeze each spring

together and pull down again to release springs from motor

plate slots.

SPRING

3. Remove blower assembly from the

existing fan (cont’d).

Pivot blower assembly down and out.

4. Check existing housing.

Vacuum the interior of the existing fan housing with a dusting

brush attachment. Examine the housing to make sure it is

securely fastened to the building structure and free of any

holes caused by corrosion. The receptacle must be intact.

If any damage is found, do not continue installation of this

product. Contact a qualified person(s) for repair..

3. Remove blower assembly from the

existing fan.

Unplug motor cord from receptacle and remove screw located

next to receptacle. If necessary, insert a straight-blade

screwdriver between motor plate and side of housing near

the screw location and gently pry housing away from motor

plate.

SCREW

(SET ASIDE)

SIDE OF

HOUSING

MOTOR PLATE

Produkt Specifikationer

Mærke:	Broan
Kategori:	Ventilator
Model:	EC60KIT

Har du brug for hjælp?

Hvis du har brug for hjælp til Broan EC60KIT stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ventilator Broan Manualer

Broan ZB80L1 Manual

8 Juli 2025

Broan LP510R Manual

7 Juli 2025

Broan L500 Manual

7 Juli 2025

Broan Roomside AR80LWH Manual

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

Ventilator Manualer

Nyeste Ventilator Manualer

RYOBI ONE+ RF18 Manual

31 Juli 2025

Brandson 307361 Manual

31 Juli 2025

Meaco Fan 1056 Manual

31 Juli 2025

Brandson 307510 Manual

31 Juli 2025

Koenic KSF 400-M Manual

31 Juli 2025

AEG LK 5689 Manual

31 Juli 2025

Brandson 307321 Manual

31 Juli 2025

Brandson 307301 Manual

31 Juli 2025

Brandson 307218 Manual

31 Juli 2025

Brandson 307322 Manual

31 Juli 2025