
Congratulations on Bushman DCyour purchase of a -X Please read fridge. these instructions carefully
before installation use. and
Please be safe and use common sense and caution when installing, operating and cleaning this appliance. If you are
unsure about any of these instructions, contact your local before proceeding.stockist
Do not lay your fridge on its back, top If your fridge has been incorrectly or sides or at any angle exceeding 30º.
handled, ensure that the fridge is placed in a level upright position for 12 hours to allow the internal fluids to
Never operate your fridge directly from a 240 V or AC power . supply
Do not use a modified sine wave inverter to operate your fridge.
At delivery, please check that the fridge is complete and is not damaged in any way. Remove all packaging and
securing tapes from the fridge. To avoid injury and causing damage to the appliance, be extremely cautious when
using sharp or pointed tools to complete this task.
Do not connect an appliance that has been damaged, contact your local dealer immediately.
Installation of the DC fridges must be completed by a suitably trained professional only.-X range of
Your fridge V V must be connected to a stable and regulated 12 or 24 DC power supply only. The compressor will
automatically detect which voltage is present adjust accordingly.
If you are using a generator or other power supply, the output must be a pure sine wave. Any fluctuations in
generator current may damage the compressor.
For optimum results, you will need the correct sized wire depending on the distance from your power supply to the
fridge. Wiring must be to your directly from your fridge battery and should be continuous without joins. Please also
e a nsure the earth is wired directly to your battery, not to chasse. If your sufficientwiring is in , your fridge may not
perform correctly or may be even be damaged.
MAXIMUM LENGTH OF WIRE IN METRES
Any switches must have a breaking load not less than 20 A on 12 V or 10 A on 24 V.
The power supply wiring must also be protected with a 15 A fuse.
Ensure sure the wiring polarity is correct. Connect the red wire to the positive terminal (+) and the black wire to the
Never connect bare electric wires. Use only connections of a size suitable for the cross section of the wire being