Caliber PARK 300 Manual


Læs gratis den danske manual til Caliber PARK 300 (21 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 78 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 39.5 anmeldelser. Har du et spørgsmål om Caliber PARK 300, eller vil du spørge andre brugere om produktet?

Side 1/21
E N G L I S H
1
PARK 300
PARK 300 parking sensor system consists of ultrasonic sensors,
digital control box and LCD display.The system detects the
distance between the car and front/rear bumper of the car.The
distance will be displayed in an innovative mode with the special
designed LCD, numeric display and step-up sounds, which will be
changed according to the actual positions detected obstruction so
that the driver could judge the distance and avoid accident.
INSTALLATION TOOLS
ADVISED POSITION TO INSTALL THE SENSORS
SELECT DRILLING POSITION FOR SENSOR A AND D
B. 0.5-0.8m vertically high to the ground, 0.55m
is recommended
C.Vertical, tidy surface without metal
components is preferred.
A. Choose suitable drilling position for A and D
sensor with relevant mark
B.To perform the best detecting angle, select the
position for A and D sensor with 8-13cm away
from the side, 11cm is recommended, and 20°
with the side.
A. 4 drilled holes (A, B, C, D) should be under
the same line.


Produkt Specifikationer

Mærke: Caliber
Kategori: Ikke kategoriseret
Model: PARK 300

Har du brug for hjælp?

Hvis du har brug for hjælp til Caliber PARK 300 stil et spørgsmål nedenfor, og andre brugere vil svare dig