EVE E-160ZQ QRG Rev. 1
Safety Notes
These Safety Notes include important information about installation, use, and maintenance of the EVE E-160ZQ.
What is Included
Control Panel Description
■ALWAYS:
♦Connect to a grounded circuit.
♦Connect to operating voltages as specified on the product's spec sticker.
♦Disconnect from power before replacing the fuse.
♦Disconnect from its power source during periods of inactivity.
♦Use a safety cable when suspending overhead.
♦Heed all restrictions and warnings on the spec sticker.
♦Mount in a location with at least 20 in (50 cm) of ventilation.
♦Replace the fuse with the same type and rating.
♦Use a clamp with a captive bolt when a single hanging bracket is used.
■In the event of a serious operating problem, stop using immediately.
■DO NOT:
♦Open this product or attempt any repairs. It contains no user-serviceable parts.
♦Look at the light source when the product is on.
♦Use if the power cord is crimped or damaged.
♦Disconnect by pulling on the power cord.
♦Allow flammable materials close to the product when it is operating.
♦Touch the housing when it is on.
♦Block any ventilation holes/slots in the housing.
♦Connect to a dimmer or rheostat.
♦Carry the product by its power cord.
♦Operate in temperatures higher than 104°F (40°C).
♦Expose to environments that exceed the Ingress Protection (IP) rating.
♦Expose to rain or moisture.
♦Use outdoors.
♦Submerge.
♦Leave outdoors for extended periods of time.
♦Expose to corrosive environmental conditions such as temperature, humidity, salinity, pressure, radiation,
or shock.
♦Set this product on a flammable surface.
♦EVE E-160ZQ
♦Power cable
♦Gel frame
♦Metal gobo holder
♦Glass gobo holder
♦Quick Reference Guide
Button Function
<MENU> Exits from the current menu or function
<UP> Navigates upwards through the menu list and increases the numeric value when in a function
<DOWN> Navigates downwards through the menu list and decreases the numeric value when in a function
<ENTER> Enables the currently displayed menu or sets the currently selected value into the selected function
