Chicco KeyFit 35 SoftGoods Removal Manual

Chicco Ikke kategoriseret KeyFit 35 SoftGoods Removal

Læs gratis den danske manual til Chicco KeyFit 35 SoftGoods Removal (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 37 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 19 anmeldelser. Har du et spørgsmål om Chicco KeyFit 35 SoftGoods Removal, eller vil du spørge andre brugere om produktet?

Side 1/3
WARNING: Avoid serious injury or death to your child. Never
use your KeyFit 35 Child Restraint without the softgoods in place.
You must read and understand the Softgood Removal instructions
and the instructions in the User Guide. If you do not understand
these instructions, DO NOT attempt to remove the softgoods,
STOP and call Chicco at 1-877-424-4226.
INSTRUCTIONS: KeyFit 35 Softgood Removal
IMPORTANT: Please also refer to the instructions that came with your product.
Rotate the Carry Handle up into the carry position. To remove the Canopy, unhook the Elastic Straps on both sides,
below the Carry Handle hub. Undo both Toggles on the back of the Child Restraint. On one side of the Canopy, press the
button on the Canopy Mount and pull out the bow. Repeat for the other side of the Canopy and remove. Then rotate the
Carry Handle back into stationary position.
Refer to User Guide if needed.
1
Press the Harness Adjuster Button and loosen the
Harness Straps. Undo the buckle and chest clips.
2
Remove the optional Head Rest Insert and Newborn
Positioner.
Refer to User Guide if needed.
4
Remove the Crotch Strap Pad by pushing the fabric Tab
through the slot on the BACK of the Harness Buckle. Then
pull Tab out of the FRONT and remove Crotch Strap Pad.
IMPORTANT! If Crotch Strap Pad prevents harness from properly
tting small Infant, it should be removed.
3
1
SS0030E_01
Remove both Shoulder Pads.
Undo the hook and loop
sections located on the outside seam of the Shoulder Pad.
5
2
At the top and side of the Carrier, flip the plastic tabs
out from under the lip of the Carrier. Pull the fabric from
the top and sides of the Carrier.
9
Pull forward on the Seat Back fabric and guide the Head Rest through the opening on the Seat Back. Pinch the Seat
Pad fabric at the corner of the Harness Adjuster Strap Cover. Pull forward on the Seat Pad edge to remove the fabric from
around the Harness Adjuster Strap Cover.
Note: The plastic Harness Adjuster Strap Cover is NOT removable.
WARNING - NEVER use Child Restraint without the seat pad.
10
Flip the Carrier over
and adjust Head Rest
into the
lowest position, using the Height Adjuster Plate.
6
Remove BOTH Shoulder Harness Straps from the
Splitter Plate. Then flip the Carrier upright and pull the
Shoulder Harness Straps to front of Carrier.
7
Remove the Seat Pad from the carrier.
12
Slide the fabric over both seat belt guides.
Feed
the harness straps, chest clip sections, and crotch buckle
through the fabric openings.
11
Place the Carrier on its side and unhook the Elastic
Straps, located just below the Handle’s rotating hinge.
Then ip out the Plastic Tabs located below the seat belt
guide. Repeat for the other side
8
Height Adjuster
Plate
Adjustment
Positions


Produkt Specifikationer

Mærke: Chicco
Kategori: Ikke kategoriseret
Model: KeyFit 35 SoftGoods Removal

Har du brug for hjælp?

Hvis du har brug for hjælp til Chicco KeyFit 35 SoftGoods Removal stil et spørgsmål nedenfor, og andre brugere vil svare dig