Cointra Thermex IF Manual


Læs gratis den danske manual til Cointra Thermex IF (12 sider) i kategorien Kedler & kedler. Denne vejledning er vurderet som hjælpsom af 32 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 16.5 anmeldelser. Har du et spørgsmål om Cointra Thermex IF, eller vil du spørge andre brugere om produktet?

Side 1/12
THERMEX
SPECIALIZED WATER HEATER MANUFACTURER
ELECTRIC WATER HEATER
OPERATION MANUAL
UNIQUE WELDING PRACTICE G.5
HIGH-QUALITY AUSTENITIC STAINLESS STEEL
www.thermex.ru
DEAR BUYER!
We wish to congratulate you on the purchase of electric water heater. It is THERMEX
safe to say that our wide range of electric water heaters will satisfy any of your needs. The use of
modern technologies and high-quality materials in the manufacture of these devices brought
about popularity of and confidence in THERMEX trade mark. Our electric water heaters can be
optionally equipped with a protective cutout device (PCD) to ensure complete electrical safety in
operation.
THERMEX electric water heaters are designed and manufactured in strict
correspondence with international standards that ensure reliability and safety in operation. The
models were all subjected to compulsory certification by the Russian State Standard and fully
comply with the requirements of -ГОСТР 51318.14.1 2006, ГОСТ Р 52161-2-21-2006.
This Manual covers THERMEX models (Series IR, IF, ID, IQ, IS, RZL). The model
name of the water heater you purchased is shown in Section on W “Manufacturer's arranties”
(Subsection on and on an identification plate on the device case. “Sales Mark”)
Please read over carefully this Operation Manual.
1. PURPOSE
The electric water heater (hereinafter referred to as EWH) is designed to supply hot water
to domestic and industrial facilities having a cold water main operating under a working pressure
of not less than 0.05 MPa and not more than 0.6 MPa.
The EWH is to be operated in enclosed heated rooms. It is not intended for use in continuous
flow mode.
2. ESSENTIAL TECHNICAL CHARACTERISTICS
Power supply voltage for all EWH types and models should be within 220v ± 10%.
Mains frequency must be 50 Hz ± 1%. Capacity of the inner tank and power of the heating
element are shown on identification plate on the device case A thread diameter of branch an .
pipes at the water inlet and outlet is 1/2 ".
Table 1
EWH Capacity,
L
Average heating time at ΔТ=45°С
(for W)Р = 2000
5
10
15
30
40
50
60
80
100
120
150
0 . 08 min. hr
0 . 15 min. hr
0 . 25 min. hr
0 . 50 min. hr
1 . 10 min. hr
1 . 25 min. hr
1 . 40 min. hr
2 hr. 10 min.
2 hr. 45 min.
3 15 min. hr.
4 hr. 10 min.


Produkt Specifikationer

Mærke: Cointra
Kategori: Kedler & kedler
Model: Thermex IF

Har du brug for hjælp?

Hvis du har brug for hjælp til Cointra Thermex IF stil et spørgsmål nedenfor, og andre brugere vil svare dig




Kedler & kedler Cointra Manualer

Cointra

Cointra Optima 11 D Manual

1 September 2024
Cointra

Cointra Thermex IF Manual

1 September 2024
Cointra

Cointra TNC 10 Manual

1 September 2024
Cointra

Cointra TL Plus 30 S Manual

1 September 2024
Cointra

Cointra Optima COB-5p Manual

1 September 2024
Cointra

Cointra Thermex ID Manual

1 September 2024
Cointra

Cointra TNC- 100 H Manual

1 September 2024
Cointra

Cointra TNC-15 Manual

1 September 2024
Cointra

Cointra Optima COB-5N Manual

1 September 2024

Kedler & kedler Manualer

Nyeste Kedler & kedler Manualer