Coleman Sundome Manual

Coleman Telt Sundome

Læs gratis den danske manual til Coleman Sundome (4 sider) i kategorien Telt. Denne vejledning er vurderet som hjælpsom af 34 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 17.5 anmeldelser. Har du et spørgsmål om Coleman Sundome, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Connect Frame to Tent

– Insert one end of main tent pole

onto pin of pin & ring system at tent

corner. (illus. 3)

– Go to opposite end of pole and

gradually apply pressure to the pole

forming an arch until you are able to

insert the pin into the pole.

– Repeat for second pole. (illus. 4)

1Layout & Positioning

of Tent, Pole Assembly

– Layout and position tent with door

facing desired direction. (illus. 1)

– Unzip door.

– Stake down tent using the rings of the

pin & ring system at the corners of the

tent. Keep the floor taut. (illus. 2)

– Assemble frame poles by

interlocking shock-corded poles.

This will make two long poles.

– Insert the poles diagonally into pole

sleeves.The center of the poles should

cross forming an “X” in the middle of

tent. (illus. 1)

Assembled poles

inserted through

pole sleeves

illus. 1

illus. 4

Tent frame set-up

illus. 2

Tent stake through ring

illus.3

Insert pole end onto

pin & ring

SUNDOME®7’x7’

When You Are Ready To Set

Up Your Tent

– Select a level campsite clear of

rocks, branches and other hard

or sharp objects.

– Do not set up your tent under trees.

– For best results in windy conditions,

do not position the door of tent

into the wind.

Rainfly

Pole

Rainfly Part No.

9180-3041

Main Tent

Poles

POLE ASSEMBLY PARTS

Instructions apply to Part Number 2000001114

Part No. 9180-3061

Part No. 9180-3051

Stake down doormat

IMPORTED BY

SUNBEAM CORPORATION (CANADA) LIMITED

DBA JARDEN CONSUMER SOLUTIONS

20B Hereford Street, Brampton, Ontario L6Y 0M1

1-800-387-6161 • www.colemancanada.ca

MADE IN CHINA

PRINTED IN CHINA REV. 11/05

Things You Should Know

• Under certain conditions (cold weather, high humidity, etc.)

condensation will form on the inside surfaces of your tent. Condensation is

caused by water vapor from your breath, perspiration, or any wet clothing

inside your tent. It is NOT LEAKAGE through the tent fabric. It can be

minimized by removing wet clothing from your tent and by providing good

ventilation through the tent.

• Never store tent, even for a short period of time, without drying it

thoroughly and brushing off caked dirt. Do not pack stakes or poles inside

your tent. Use a separate storage bag.

• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.

NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO

REMOVE STAKE.

• TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

• Seam sealer has not been provided with your tent. For additional

protection we recommend seam sealing your tent prior to camping.

Seam sealer may be purchased through your local retailer or at your

local sporting goods store.

• Do not leave your tent set-up for weeks at a time, be aware that

exposure to the ultraviolet rays of the sun can seriously damage material

and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES

AWAY FROM THIS TENT FABRIC. This tent meets the

flammability requirement s of CPAI-84. The fabric will burn if

left in continuous contact with any flame source. The

application of any foreign substance to the tent fabric may

render the flame -resistant properties ineffective.

Attach Tent to Frame

Using Frame Clips

– Attach frame clips along

the edges of tent to frame poles.

(illus. 5), (illus. 6)

– Make any adjustments to the tent

corner stakes that are needed.

4Attach Rainfly

– Assemble rainfly pole by

interlocking shock-corded pole.

– Insert rainfly pole into reinforced

pockets located at the center edges

of the underside of rainfly.

(illus. 7), (illus. 8)

– Attach underside of rainfly to the

rainfly pole. (illus. 8)

– Drape rainfly over tent frame, pole

side down. Rainfly pole should

point out over door and rear window.

– Connect the four elastic loops with

“S” hooks, (found at the rainfly

corners) to the fabric loops

near frame clips. (illus. 9)

– Secure rainfly with attachments

located on underside of fly. (illus. 10)

– Stake out the tent with (2) side

guylines. (illus. 10)

illus. 6

Assembled tent without rainfly.

illus. 5

Frame clips

illus. 7 Insert rainfly

pole into pocket on

underside of rainfly

illus. 10

Completed tent with rainfly.

illus. 8

Underside

of rainfly

attaches to

frame poles

Side guyline

Rainfly pole pockets

Rainfly pole pocket

Pole

attachments

illus. 9

“S” hooks

Produkt Specifikationer

Mærke:	Coleman
Kategori:	Telt
Model:	Sundome

Har du brug for hjælp?

Hvis du har brug for hjælp til Coleman Sundome stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Telt Coleman Manualer

Coleman Instant Up 3P Manual

16 August 2024

Coleman Sundome Manual

16 August 2024

Coleman Kohna Manual

15 August 2024

Coleman Sundome 4 Manual

15 August 2024

Coleman Instant Up 4P Manual

14 August 2024

Coleman Instant Up 6P Manual

14 August 2024

Coleman Evanston Manual

14 August 2024

Coleman Sundome 12x10 Manual

14 August 2024

Coleman Ciqala Manual

14 August 2024

Coleman Instant Up Single Ensuite Manual

14 August 2024

Telt Manualer

Nyeste Telt Manualer

De Waard Zeester Manual

7 Oktober 2024

Eureka El Capitan 2 Manual

6 Oktober 2024

Eureka KeeGo 2 Manual

4 Oktober 2024

SereneLife SLTET30 Manual

1 Oktober 2024

Calima 46074 Manual

1 Oktober 2024

SereneLife SLPTLB106 Manual

1 Oktober 2024

SereneLife SLPTSR107 Manual

30 September 2024

Eureka KeeGo Solo Manual

30 September 2024

Vaude Badawi Long 6 Manual

29 September 2024

De Waard Stormmeeuw Manual

25 September 2024