Crest Audio Versarray 112 MKIII Manual

Crest Audio Højttaler Versarray 112 MKIII

Læs gratis den danske manual til Crest Audio Versarray 112 MKIII (32 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 10 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 5.5 anmeldelser. Har du et spørgsmål om Crest Audio Versarray 112 MKIII, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/32
1
Versarray™ 112 Mk III
Passive Enclosure
Product Specifications
e Versarray™ 112 Mk III Passive Ribbon Tweeter Line Source Array speaker system consists of a 12” Neo Black
Widow® woofer combined with a Neodymium based Peavey RD™ 2.6 Mk III ribbon tweeter in a cabinet with a
simple, quick, yetexible rigging system. Designed to provide modular coverage of small to medium venues,
and intended for use with the companion Versarray™ Mk III Sub models, the Versarray™ 112 Mk III oers ex-
cellent versatility with a very high performance capability. e two-way system consists of the following driver
components: a 12” Black Widow® Neo series woofer with Neodymium magnet structure. Capable of over 500W
of continuous power handling (AES Std 2-1984), the woofer can handle a lot of sheer power.e high frequen-
cies are handled by two Peavey® RD™ 2.6 Mk3 ribbon tweeters utilizing a composite sandwich ribbon, a Neo-
dymium magnet system, and a low distortion CLEAR FORM™ waveguide.
Designed to be used in conjunction with a compatible DSP based loudspeaker signal processor, such as a Peavey
Digitool™, Nion® or MediaMatrix® system, with the Peavey factory settings in use, the Versarray™ 112 Mk III can
perform to modern standards of excellence, and handily exceed the competitions audible performance.
e FlyQWIK™ fully articulated hardware rigging system provides for a classic straight line-array conguration,
or a number of dierent angling options, providing easy aiming of the system. Angles between the array modules
is adjustable from 0 degrees (straight), to 15 degrees in 2.5 degree increments. Total angle possible between two
cabinets is 15 degrees.
Quick-lock pins are supplied with the rigging hardware to couple the Versarray™ 112 Mk III modules together
and lock the angles between them into place, as well as for the rigging halo and y bar congurations of a line
array. e exibility of the Versarray™ system allows the use of anywhere from 1 to 10 Versarray™ 112 Mk III
modules in conjunction with Versarray™ 218 Mk III Subs. An optional special groundstack bracket set mounts
to the Versarray 218 Mk III Sub, and allows up to three of the Versarray™ 112 Mk III ‘s to be mounted on top of
the Versarray 218 Mk III Sub, and angled upward, for use on stage in a stadium seating situation.
Features
• 2-way Bi-Amp Ribbon Line Source Array SR System
• 12” Neo Black Widow® 4” VC Woofer
• 1000 watt program, 2000 watt peak power handling
• Ribbon Tweeters with Neo magnet and composite material sandwich ribbon
• Ribbon Tweeters mounted to our proprietary CLEAR FORM™ Waveguide
• 90 H by 15 V degree coverage pattern (per one cabinet)
• Easy aiming FlyQWIK™ hardware rigging system
• Angle adjustable in 2 1/2 degree increments, from 0 to 15 degrees total angle between adjacent cabinets
• Sound Guard™ tweeter protection, series capacitor for reliability
• Inputs are two Neutrik® Speakon® 4 pin jacks in parallel
• 18 mm 13 ply Baltic Birch enclosure with steel inner brackets
• Injection molded cabinet end caps, made from high impact material.
• Hammerhead™ polyurea black nish and black powder-coated cloth lined grilles
2
Frequency Response, 1 meter on-axis,
swept-sine in anechoic environment:
100 Hz to 20 kHz (±3 dB, with
processing)
Usable Low Frequency limit, -10 dB
point: 85 Hz (with processing)
Power Handling:
Low Frequency Section: 500 W
continuous 1,000 W program 2,000 W
peak
High Frequency Section: 120 W
continuous 240 W program 480 W
peak
Sound Pressure Level, 1 Watt, 1 meter
in anechoic environment:
Low Frequency Section: 97 dB SPL,
(2.83 V input)
High Frequency Section: 101 dB SPL,
(4.0 V input for 16 ohm wiring)
Maximum Sound Pressure Level (1
meter) * :
Low Frequency Section: 124 dB SPL
continuous 130 dB SPL peak
High Frequency Section: 122 dB SPL
continuous 128 dB SPL peak
*Note: This spec is for one module at 1
meter, a line array of 6 units has much
higher output at distance due to line
source effect where SPL falls off at 3 dB
per distance doubling rather than 6 dB
Nominal Radiation Angle measured
at -6 dB point of polar response: 90
degrees Horizontal by 15 degrees
Vertical (One module only, straight line
array of more than 1 module narrows
vertical dispersion accordingly)
Transducer Complement:
Low Frequency Section: 1x 12 in.
Woofer, 1244 Neo Black Widow® 4” VC
Woofer, in a sealed box
High Frequency Section: 2x 4.75
in. Ribbon Tweeters Two RD™ 2.6
Mk III Peavey Ribbon Tweeters, on a
waveguide
Box Tuning Frequency (Sealed): Low
Frequency Section: 88 Hz
Electroacoustic Crossover Point, Peavey
Active Digital Crossover:
(Applies to VSX™, Digitool® and Nion®/
MediaMatrix® settings provided by
Peavey)
Sub – Low Frequency: 125 Hz at 24dB/
octave
Low Frequency – High Frequency:
1950 Hz at 24dB/octave
Recommended Active Crossover
Frequency Region and Slope: Sub –Low
Frequency: 125 Hz at 24dB/octave LR
Low Frequency –High Frequency: 2000
Hz at 24dB/octave LR
Impedance (Z):
Low Frequency: Nominal: 8.0 Ohms,
Minimum: 6.5 Ohms
High Frequency: Nominal: 16 Ohms,
Minimum: 13.6 Ohms
(Special Note: Ribbon tweeters
are capacitor coupled so use with
switching amps is allowed.)
Input Connections: 2x Neutrik® 4-pin
Speakon® jack
Enclosure Materials & Finish: 18 mm
13 ply Baltic Birch plywood finished
in a tough Hammerhead™ polyurea
black finish, with injection molded
end caps and horn, with a perforated
steel grille finished in black powder
coat paint and a cloth liner inside.
Inner steel frame and backing plates
for rigging hardware.
Mounting provisions: Custom array
brackets and hardware, and a custom
array angle adjustment system are
included with each module. Quick
release pins are included with each
cabinet.
Dimensions (H x W x D):
Front: 15.13 in. x 25.06 in. x 15.19 in.
384 mm x 637 mm x 386 mm
With Rigging hardware and Pins:
15.13 in. x 27.13 in. x 16.75 in.
321 mm x 689 mm x 426 mm
Net Weight: 66 Lbs. (30.0 kg)
{includes all cabinet associated
rigging hardware for each cabinet,
including quick-lock pins, etc.}
Companion Subwoofers (sold
separately): Versarray™ 218 Mk III
Sub double 18” Lo Max® woofer
subwoofer
Optional Accessories:
3 foot speaker cable, with 16 gauge 4
conductor wires with 4-pin to 4-pin
Neutrik plugs (Peavey part number
00585240); and 10mm Quick Release
Positive Lock Pins for array rigging.
Flying/Rigging Options:
Versarray™ Mk III HALO
Versarray™ Mk III FLY BAR, 6FT
LENGTH
Versarray™ Mk III SUB SUPPORT
FRAME
Versarray™ Mk III FLY BAR, 2FT
LENGTH
SPECIFICATIONS Versarray
™
112 Mk III

Produkt Specifikationer

Mærke: Crest Audio
Kategori: Højttaler
Model: Versarray 112 MKIII

Har du brug for hjælp?

Hvis du har brug for hjælp til Crest Audio Versarray 112 MKIII stil et spørgsmål nedenfor, og andre brugere vil svare dig


Højttaler Crest Audio Manualer

Crest Audio

Crest Audio CPL 10+ Manual

14 December 2024
Crest Audio

Crest Audio Versarray PRO 215 Manual

16 August 2024
Crest Audio

Crest Audio CPL 6T Manual

2 August 2024
Crest Audio

Crest Audio CPL 265B+ Manual

1 August 2024
Crest Audio

Crest Audio CPL 8+ Manual

31 Juli 2024
Crest Audio

Crest Audio Versarray 218 MKIII Manual

31 Juli 2024
Crest Audio

Crest Audio CPL 25C+ Manual

31 Juli 2024
Crest Audio

Crest Audio CPL 15+ Manual

29 Juli 2024
Crest Audio

Crest Audio CPL 4T Manual

28 Juli 2024
Crest Audio

Crest Audio CPL 26+ Manual

28 Juli 2024

Højttaler Manualer

Nyeste Højttaler Manualer

DS18

DS18 Hydro NXL-8M Manual

17 Juni 2025
Earthquake Sound

Earthquake Sound PR-EQ5S8 Manual

17 Juni 2025
Sogo

Sogo SS-8780 Manual

17 Juni 2025
DS18

DS18 PRO-X6.4BMRGB Manual

17 Juni 2025
DS18

DS18 PRO-X4.4BMSL Manual

17 Juni 2025
DS18

DS18 PRO-FU12.8 Manual

17 Juni 2025
DS18

DS18 GEN-X G4.6Xi Manual

17 Juni 2025
DS18

DS18 JL-SBAR.HT Manual

17 Juni 2025
DS18

DS18 JK-SBAR22 Manual

17 Juni 2025
DS18

DS18 JK-SBAR.HT Manual

17 Juni 2025