Ctek PRO25SE Manual
Ctek
Batterioplader
PRO25SE
Læs nedenfor 📖 manual på dansk for Ctek PRO25SE (6 sider) i kategorien Batterioplader. Denne guide var nyttig for 32 personer og blev bedømt med 4.8 stjerner i gennemsnit af 16.5 brugere
Side 1/6
EN • 5
MANUAL
CONGRATULATIONS
on the purchase of your new professional switch mode battery charger. This charger is
included in a series of professional chargers from CTEK SWEDEN AB and represents the
latest technology in battery charging.
MODE
RECONDSUPPLYNORMAL LITHIUM
LIT HIUM
PROG R AM
ERROR
LAMP
RECOND
PROG R AM
SUPPLY
PROG R AM
NORMAL
BAT TE RY
PROG R AM
HOW TO CHARGE
1. Connect the charger to the battery.
2. Connect the charger to the wall socket. The power lamp will indicate that the mains
cable is connected to the wall socket. The error lamp will indicate if the battery clamps
are incorrectly connected. The reverse polarity protection will ensure that the battery or
charger will not be damaged.
3. Press the MODE-button to select charging program.
4. Follow the indication lamps through the charging process.
The battery is ready to start the engine when is lit.
The battery is fully charged when is lit.
5. Stop charging at any time by disconnecting the mains cable from the wall socket.
MODE-
BUT T ON
POWER
LAMP
For batteries mounted inside a vehicle
1. Connect the charger according to the
vehicles manual.
2. Connect the charger to the wall socket.
3. Disconnect the charger from the wall socket
before disconnecting the battery.
4. Disconnect the black clamp before the red
clamp.
1 2
Read safety instruction
READY TO USE
EMPT Y
CHARGING
FULLY CHARGED
+
–
Temperature sensor
The temperature sensor works automatically
and will adjust the voltage to the ambient
temperature. Place the temperature sensor
in the positive clamp or as the close to the
battery as possible.
6 • EN
CHARGING PROGRAMS
Settings are made by pressing the MODE-button. After about two seconds the charger
activates the selected program. The selected program will be restarted next time the
charger is connected.
The table explains the different Charging Programs:
Program Explanation
NORMAL Normal battery program 14.4V/25A. Only for lead-acid
batteries.
RECOND
Recond program 15.8V/1.5A
Use Recond to return energy to empty WET and Ca/Ca batteries.
Recond your battery once per year and after deep dischare to maximise
lifetime and capacity. The Recond program adds the Recond step to the
normal battery program. Only for lead-acid batteries.
SUPPLY
Supply program 13.6V/25A
Use as a 12V power supply or use for float maintenance charging when
100% capacity of the battery is required. The Supply program activates
the Float step without time or voltage limitation. The spark protection
on the battery charger is disabled during the SUPPLY program.
BATTERY SIZE (Ah) TIME TO 80% CHARGED
40Ah 1.5h
100Ah 3h
200Ah 6h
300Ah 16h
READY TO USE
The table shows the estimated time to charge a battery from empty to 80%
ERROR LAMP
If the error lamp is lit, check the following:
1. Is the chargers red clamp connected to the battery's
positive pole? Connect the charger according to the
vehicles manual.
2. Is the charger connected to a 12V battery?
3. Are the clamps short circuited?
4. Has charging been interrupted in or ?
Restart the charger by pressing the MODE-button. If charging is still
being interrupted, the battery...
...is seriosly sulphated and may need to be replaced.
...can not accept charge and may need to be replaced.
...can not keep charge and may need to be replaced.
POWER LAMP
If the power lamp is lit with a:
1. STEADY LIGHT
The mains cable is connected to the wall socket.
2. FLASHING LIGHT:
The charger has entered the energy save mode. This happens if the
charger isn´t connected to the battery within 2 minutes or the battery
voltage is below 2V.
LEAD-ACID
Produkt Specifikationer
| Mærke: | Ctek |
| Kategori: | Batterioplader |
| Model: | PRO25SE |
Har du brug for hjælp?
Hvis du har brug for hjælp til Ctek PRO25SE stil et spørgsmål nedenfor, og andre brugere vil svare dig
Batterioplader Ctek Manualer
2 September 2024
23 August 2024
23 August 2024
23 August 2024
22 August 2024
22 August 2024
22 August 2024
22 August 2024
22 August 2024
22 August 2024
Batterioplader Manualer
- Batterioplader Manhattan
- Batterioplader Manson
- Batterioplader Mean Well
- Batterioplader Terratec
- Batterioplader Basetech
- Batterioplader Sandberg
- Batterioplader Tesla
- Batterioplader DeWalt
- Batterioplader DreamGEAR
- Batterioplader Skullcandy
- Batterioplader Beghelli
- Batterioplader Mestic
- Batterioplader Parkside
- Batterioplader Energizer
- Batterioplader Rocstor
Nyeste Batterioplader Manualer
3 April 2025
3 April 2025
3 April 2025
3 April 2025
30 Marts 2025
11 Marts 2025
9 Marts 2025
5 Marts 2025
25 Februar 2025
21 Februar 2025