D-Link DXS-3410-32XY Manual

D-Link Skifte DXS-3410-32XY

Læs gratis den danske manual til D-Link DXS-3410-32XY (3 sider) i kategorien Skifte. Denne vejledning er vurderet som hjælpsom af 21 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 11 anmeldelser. Har du et spørgsmål om D-Link DXS-3410-32XY, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/3

Light Management Radio-control pushbutton and pilot lamp

Ref.-no.: ..1561.07FKO..

Operating Instructions

Radio-control pushbutton and pilot lamp

1. Function

The radio-contol pushbutton permits radio-controlled or manual switching

and dimming of lamps.The starting brightness can be stored in the device

as memory brightness. The pushbutton with radio-control receiver is

plugged onto one of the following inserts:

 Universal touch dimmer 1254 UDE

 Standard touch dimmer 1225 SDE

 Relay insert single-channel 1201 URE

 Relay insert two-channel 1202 URE

 Tronic switching insert 1254 TSE

 LV triac switching insert 1244 NVSE

 Touch control unit 1240 STE

Relay insert with potential-free contact 1201-1 URE After reception of a

data telegram from a programmed radio-control detector and

corresponding darkness, the radio-contol pushbutton is switched on for

about 1 minute with the preset memory brightness. The radio-contol

pushbutton can be programmed to identify up to 30 radio channels.

Lightscapes

The radio-contol pushbutton can be included in up to five lightscapes

which are activated with the corresponding radio-control transmitters (e.g.

hand-held transmitter ‘Komfort’) and stored. The desired lightscape key

must be programmed beforehand into the radio-contol pushbutton.

All-ON / All-OFF

The programming of a radio channel (e.g. hand-held transmitter

‘Komfort’) always includes the simultaneous and automatic storage of the

functions of the All-ON or All-OFF key.The All-ON or All- OFF key of a

radio-control transmitter switches the load connected to the switching

actuator on or off.

Light control

In combination with a programmed radio-control presence detector, the

radio-contol pushbutton can be used for lighting control functions. For

more information, refer to the operating instructions of the radio presence

detector.

Stand: Mai-07 325 276 53

Light Management Radio-control pushbutton and pilot lamp

Ref.-no.: ..1561.07FKO..

Important

The present instructions describe the functions of the radio-control

pushbutton without lighting control. More information on light control with

a presence detector is set out in the operating instructions for these

devices.

WARNING!

Caution: The installation and assembly of electrical equipment may

only be performed by a skilled electrician.

2. Fitting

The radio-control pushbutton can only be operated in conjunction with the

inserts listed under ‘Functions’. Connection and fitting are described in

the operating instructions of the insert.

Procedure

1. Install the selected insert (1) in a flush-mounting box (deep model

recommended), the connecting terminals of the insert pointing

downwards.

2. Plug the radio-control pushbutton (2) together with frame (3) onto

the insert while the mains voltage is disconnected.

L The distance from electrical appliances (e.g. microwave oven, hi-fi and

TV sets) must be at least 0.5 m.

L To prevent saturation of the radio receiver (actuator), the radiocontrol

pushbutton must be at least 1 m away from the nearest transmitter.

Learning a Radio Transmitter

During programming of a transmitter, the sensitivity of a radiocontrol

receiver is reduced to a range of approx. 5 m. The distance between the

radio-control pushbutton and the transmitter to be programmed should be

between 0.5 m and 5 m.

Procedure

1. Switch off the load connected to the radio-control pushbutton by a brief

depression (< 0,4 s) of any of the two pushbutton rockers.

2. Depress both rockers of the radio-control pushbutton at the same time

for abt. 4 seconds (fig. B: double-sided operation) to switch over to the

programming mode. The LED blinks for abt. 1 min (Fig. C). The radio

pushbutton is then in the programming mode.

Produkt Specifikationer

Mærke:	D-Link
Kategori:	Skifte
Model:	DXS-3410-32XY

Har du brug for hjælp?

Hvis du har brug for hjælp til D-Link DXS-3410-32XY stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Skifte D-Link Manualer

D-Link DSS-100E-9P Manual

29 Marts 2025

D-Link DMS-1100-10TP Manual

5 Februar 2025

D-Link DES-1024D Manual

13 Januar 2025

D-Link DGS-1100-05PD Manual

5 Januar 2025

D-Link DGS-1100-10MP Manual

5 Januar 2025

D-Link DGS-1510-28 Manual

5 Januar 2025

D-Link DGS-1210-20 Manual

5 Januar 2025

D-Link DGS-1100-05 Manual

5 Januar 2025

D-Link DKVM-222 Manual

1 Januar 2025

D-Link DKVM-2 Manual

1 Januar 2025

Skifte Manualer

Nyeste Skifte Manualer

Lancom GS-2412 Manual

4 April 2025

Lancom GS-2412P Manual

4 April 2025

Lancom GS-2426 Manual

4 April 2025

Hager ARF970D Manual

3 April 2025

Hager ARF920D Manual

3 April 2025

Roline 14.01.3579 Manual

2 April 2025

Fantini Cosmi B12BN Manual

1 April 2025

Fantini Cosmi B12DN Manual

1 April 2025

Fantini Cosmi B12GN Manual

1 April 2025

Fantini Cosmi B12HN Manual

1 April 2025