Da-Lite Tensioned Conference Electrol Manual

Da-Lite Videokonferencesystem Tensioned Conference Electrol

Læs gratis den danske manual til Da-Lite Tensioned Conference Electrol (8 sider) i kategorien Videokonferencesystem. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 7 anmeldelser. Har du et spørgsmål om Da-Lite Tensioned Conference Electrol, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

INSTRUCTION BOOK FOR

Tensioned Conference Electrol

Installation

Important Safety Instructions

When using your video equipment, basic safety precautions

should always be followed, including the following:

1. Read and understand all instructions before using.

2. To reduce the risk of electric shock, do not disassemble this

appliance. Contact an authorized service dealer when repair

work is required. Incorrect reassembly can cause electric shock

when the appliance is used subsequently.

3. The use of an accessory attachment not recommended by the

manufacturer may cause a risk of ire, electric shock, or injury to

persons.

4. Do NOT lift or push up on the camera arm mechanism at any

time. This may cause improper operation and/or component

failure or injury to persons.

5. Failure to provide adequate structural strength for this

component can result in serious personal injury or damage to

equipment! It is the installer’s responsibility to make sure the

structure to which this component is attached can support the

weight of all equipment. Reinforce the structure as required

before installing the component.

6. Use this projection screen only for its intended use as described

in these instructions. Do not use attachments not recommended

by the manufacturer.

Save These Instructions

Pre-Installation

1. Carefully unpack screen and remove outer wrapping from case.

2. Make sure to recheck measurements of screen location

before installation.

Hand Hole

Internal

Bracket

Figure 1a – Threaded Rod with Internal Bracket

Figure 1b – Threaded Rod with Internal and External Bracket

Figure 1c – Internal Bracket

Hand Hole

NOTE: Unit is not to be installed in air handling spaces.

1. The case brackets provide multiple attachment points for bolts,

cables, or threaded rod. The following page shows two locations

for typical threaded rod installations with the external case

mounting brackets (Figure 1a) and without them (Figure 1b). The

internal case brackets can be accessed through the hand holes

(Figure 1c).

Original Instructions

Disclaimer

Milestone and its ailiated corporations and subsidiaries

(collectively "Milestone"), intend to make this manual accurate

and complete. However, Milestone makes no claim that the

information contained herein covers all details, conditions or

variations, nor does it provide for every possible contingency in

connection with the installation or use of this subject to change

without notice or obligation of any kind. Milestone makes no

representation of warranty, expressed or implied, regarding the

information contained herein. Milestone assumes no

responsibility for accuracy, completeness or suiciency of the

information contained in this document.

Da-Lite® is a registered trademark of Milestone AV Technologies.

Produkt Specifikationer

Mærke:	Da-Lite
Kategori:	Videokonferencesystem
Model:	Tensioned Conference Electrol
Vægt:	182800 g
Produktfarve:	Hvid
Naturligt aspektforhold:	16:10
Betragtningsvinkel:	60 °
Drevtype:	Motoriseret
Synlig skærmbredde (W):	2950 mm
Synlig skærmhøjde (H):	1840 mm
Samlet skærmstørrelse (højde x bredde):	- cm
Diagonal:	137 "
Skærmforstærkning:	1
Format:	Bred
Sort fald:	180 mm
Boks L1:	3640 mm
Farve på etui:	Hvid