Dell Dimension XPS Manual

Dell Ikke kategoriseret Dimension XPS

Læs gratis den danske manual til Dell Dimension XPS (53 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 58 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 29.5 anmeldelser. Har du et spørgsmål om Dell Dimension XPS, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/53

Dell™Dimension™XPST

xxx

and T

xxx

r Systems Reference

Preface

Technical Overview

Controls and Indicators

Drivers

System Codes and Messages

System Setup Program

Specifications

Removing and Replacing Parts

Documentation

Information in this document is subject to change without notice.

Reproduction in any manner whatsoever without the written permission of Dell Computer Corporation is strictly forbidden.

Trademarks used in this text: Dell, , Dimension, and the DELL logo are trademarks of Dell Computer Corporation; Microsoft Windows, and WindowsNT are registered

trademarks of Microsoft Corporation; Intel and Pentium are registered trademarks of Intel Corporation; VESA is a registered trademark of Video Electronics Standards

Association; Adobe is a trademark of Adobe Systems Incorporated, which may be registered in certain jurisdictions.

Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Dell Computer Corporation

disclaims any proprietary interest in trademarks and trade names other than its own.

Model MMS

Initial release: 26 Feb 1999

Last revised: 18 May 2000

Back to Contents Page

System Codes and Messages: Dell™Dimension™XPST

xxx

and T

xxx

r Systems

Reference

Diagnostic Codes •POST Beep Codes •System Messages

Diagnostic Codes

Your system is equipped with four diagnostic code indicators, which are labeled "A," "B," "C," and "D" on the back of the computer. Each of the

four indicators can be yellow, green, or off as shown in Table 1. When the computer is turned on or restarted and the system is functioning normally,

the indicators flash during power- -on self test (POST). After the system starts, the indicators remain green to signify normal system operation.

If a malfunction is detected and the computer fails to start, the indicators display a code that identifies the problem. Write down the diagnostic code

displayed, and look it up in Table 1.

Table 1. Diagnostic Codes

Diagnostic Code

Definition

Corrective Action

Power up default.

Make sure that the system is

connected to an electrical outlet, and

then check whether the front-panel

power indicator (see Controls and

Indicators) is on or off. If the power

indicator is off, check the power

supply. If the problem persists, refer

to Chapter 7, "Getting Help," of the

Dell Dimension XPS Txxx and

Txxxr Systems Reference and

Troubleshooting Guide for

instructions on obtaining technical

assistance.

If the power indicator is on, reseat the

microprocessor. Remove all

expansion cards.Ifthesystemstill

does not start, refer to Chapter 7,

"Getting Help," of the Reference and

Troubleshooting Guide for

instructions on obtaining technical

assistance.

System board is receiving power,

but the BIOS is not executing.

Set the configuration jumper to

Maintenance mode and restart the

system. Enter the system setup

program and ensure that the

microprocessor speed is set

correctly. Exit and save the setting.

Turn off the computer and reset the

configuration jumper to Normal mode,

and then restart the system. Reseat

the microprocessor. Remove all

expansion cards and restart the

system to determine if a resource

conflict exists. If a conflict exists,

resolve the conflict as described in

"Resolving Software and Hardware

Incompatibilities" in Chapter 5 of the

Reference and Troubleshooting

Guide. If the problem persists, refer

to Chapter 7, "Getting Help," of the

Reference and Troubleshooting

Guide for instructions on obtaining

technical assistance.

Recovery mode from BIOS failure.

Set the configuration jumper to

Maintenance mode and restart the

system. Enter the system setup

program and ensure that the

microprocessor speed is set

correctly. Exit and save the setting.

Turn off the computer and reset the

configuration jumper to Normal mode,

Produkt Specifikationer

Mærke:	Dell
Kategori:	Ikke kategoriseret
Model:	Dimension XPS

Har du brug for hjælp?

Hvis du har brug for hjælp til Dell Dimension XPS stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Dell Manualer

Dell PowerConnect W-3600 Manual

10 August 2025

Dell PowerConnect 3548P Manual

9 August 2025

Dell PowerConnect J-SRX240 Manual

9 August 2025

Dell W-6000 Manual

9 August 2025

Dell PowerConnect 7024F Manual

9 August 2025

24 Juli 2025

5 Juli 2025

4 Juli 2025

8 Juni 2025

Dell Pro WH5024 Manual

20 Februar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Slingshot SL (2025) Manual

13 August 2025

Crestron CLTIBN-1DIM4 Manual

13 August 2025

Beverage-Air PH2-1BG-PT Manual

13 August 2025

Swann SWIFI-MPRSB1T1 Manual

13 August 2025

Slingshot R (2024) Manual

13 August 2025

Heinner MG-2100SS Manual

13 August 2025

Advantech BB-SR30918320-SWH Manual

13 August 2025

Camry CR 3061 Manual

13 August 2025

Crestron FT2A-CBLR-GR-USB Manual

13 August 2025

Advantech PCI-1716-BE Manual

13 August 2025