Wind Sensor
Installation instructions
The wind sensor is designed to control
outdoor blinds automatically according
to wind speed and sunshine.
This sensor is associated via wireless
with one or more receivers controlling
the different shutters in your installation.
1. How does the sensor work?
2. Description
1.1 Presentation
Wind
sensor
Protective
covers
Display
Programming
keypad
Removal
Not
used
Set wind
threshold
Association
Wind
Configuration
Wireless
transmission
signal
The sensor must be activated before
being used for the first time.
To do this, press and hold the and
buttons for 2 seconds.
The display screen will turn on.
> 2s
The wind sensor switches
automatically into energy
saving mode after 30 seconds of
inaction.
Before each use, «activate» the sen-
sor by pressing any button.
3. Activation
4. Association
1 2
> 2s > 2s
1234
... ... ...
> 3s
1234
TYXIA TYXIA
- Set the receiver(s) to
association wait mode.
- Press and hold the button for 2
seconds.
- The symbols and are displayed
while the device searches for receivers.
- The detected receiver number is displayed
on the screen,
and the symbol «NEW» appears.
- Press and hold the button to confirm
the association.
- On the receiver(s) check that the association was
successful. The receiver LED stops flashing
and the shutter briefly operates twice.
Display when the
sensor has detec-
ted more than 9
receivers.
Display when the sensor
has not detected any recei-
vers > Switches to «Manage
networks» mode (see §10)
4
OK
OFF
1234
TYXIA
Lithium battery - AA
cannot be replaced
Lithium battery life: 10 years
868,7 MHz -> 869,2 MHz
Maximum radio power < 10 mW
Receiver category: 2
100 -> 300 m
IP IPx4
-10°C / +70°C
-10°C / +60°C
260 x 104 x 130 mm
www.deltadore.com
5. Set wind threshold
> 2s
10 km/h
threshold Slight breeze
20 km/h
threshold Gentle breeze
30 km/h
threshold Moderate breeze
(default value)
40 km/h
threshold Fresh breeze
50 km/h
threshold Strong wind
66 km/h
threshold Very strong wind
To protect the shutter or blind equipment, select the wind threshold
recommended by the manufacturer.
- Press and hold the
button for 2 seconds.
- The symbol will flash.
- Press and hold the
button to select the next
value.
For safety reasons, the wind sen-
sor cannot be neutralised.
The mode is exited
automatically after
5 seconds of inaction.
